国外碳市场机制设计解读

碳交易不仅能以市场的方式促进经济结构的调整,而且将改善国民收入与民生。在碳交易设计阶段,澳大利亚即准备将碳市场创造收入的大部分用于个人所得税体系的调整,而且将主要关注中低收入群体。这将对国家的收入分配和生产力提高产生积极作用。     

五羰基铁对正辛硫醇中硫的脱除研究

由于能源化石类燃料中均包含不同含量的硫化物,随着人类对这些能源的不断利用,引发的环境污染等问题日趋严重。利用五羰基铁(Fe(CO)5)分解条件温和可控,产物无杂质,分解后的Fe0可以与硫原子原位键合等特点。文章尝试采用Fe(CO)5作为脱硫剂在温和条件下进行脱除正辛硫醇的研究。实验结果表明:随着压强(101~5 067 kPa)、Fe(CO)5加入量(50~250μL)、时间(1~6 h)和温度(0~180℃)的不同,Fe(CO)5脱硫效率具有明显差异,在此基础上得到最佳脱硫条件及最高脱除效率:常压、Fe(CO)5加入量200μL(1.4 mmol)、t=2h和T=140℃时,达到最高硫容3 450 mg/L。分别采用IR、XPS手段对脱硫反应机理进行了探索。IR结果表明:在1 084 cm-1处为硫氧峰,在797 cm-1归属为铁氧峰。XPS结果表明:167.8 eV处可能为S4+,711.6 eV处可能为Fe3+。因此,正辛硫醇脱除的可能机理为巯基断裂,并在空气中与氧结合,最终形成S4+,而Fe(CO)5的Fe经过脱硫之后,在空气中不稳定,最终被氧化成Fe3+。     

纳米铁酸镍的制备及可见光催化性能研究

利用水热法制备了纳米铁酸镍,表征了其微观结构和光谱性能,并以罗丹明B溶液作为目标污染物,研究了铁酸镍催化剂的可见光催化性能。结果表明:所制备铁酸镍的微观形貌为由直径200-300 nm左右的类似球形小颗粒组成的大颗粒,平均粒径为95.60 nm,在紫外-可见光谱区均有较强的光吸收。光催化过程中催化剂的适宜用量为0.05 g,少量H2O2的加入有助于提高罗丹明B溶液的降解率。催化剂用量为0.05 g,加入0.4 mL 30%的H2O2,降解50 mL 20 mg/L罗丹明B溶液,模拟太阳光照射240 min后降解率能够达到99.2%。在实际太阳光照射下,240 min后罗丹明B溶液的降解率可以达到85.2%。     

pH值对纳米零价铁吸附降解2,4-二氯苯酚的影响

在不同pH条件下,对纳米铁(颗粒粒径为30～40 nm)及其降解2,4-二氯苯酚反应体系进行取样,并进行透射电子显微镜(TEM)、扫描电子显微镜-能谱联用(SEM-EDX)以及电感耦合等离子体发射光谱(ICP-OES)等形貌观测与分析表征,以考察pH值在纳米零价铁降解氯酚反应过程中的影响和作用.结果表明,在降解2,4-二氯苯酚的过程中纳米铁由分散的颗粒逐渐团聚,其表面逐渐氧化,并最终被呈针状结晶的碱式氧化亚铁(FeOOH)覆盖,从而阻碍了降解反应的进一步进行.在酸性体系中,纳米零价铁的氧化和团聚现象有所缓解,尽管会造成一部分铁量的损失,但反应产生大量的亚铁离子参与并促进了脱氯降解反应的进行,反应过程中溶液pH值有逐渐升高的趋势.不同pH条件下,纳米铁对氯酚的去除率随pH值的降低而升高,酸性条件有利于提高氯酚的还原降解速率,当pH=3时,24 h内氯酚的去除率可达到90%以上.     

定位基本法改好《环保法》

《环境保护法》在环保领域的法律框架体系中事实上居于基础性、综合性地位,建议国家立法机关应当按照基本法的定位,改好环保法。     

唐纳德·沃斯特

唐纳德·沃斯特(Donald Worster)1941年生于美国加州,祖籍堪萨斯。是美国艺术与科学院院士、美国环境史学会前主席,美国最有影响的环境史学家之一。1963年和1964年在堪萨斯大学分别获得学士和文学硕士学位,1970年和1971年在耶鲁大学分别获得哲学硕士和哲学博士学位。毕业后,先后受聘任教于缅因大学,夏威夷大学,     

Seasonal trend of ambient PCDD/Fs in Tianjin City, northern China using active sampling strategy

The spatial concentrations, seasonal trends, profiles and congener pairs of ambient polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) were investigated within a seasonally active sampling scheme during Jun 2008 and Jan 2009 in Tianjin City, northern China. The PCDD/F concentrations ranged 14.2-172 fg I-TEQ/m³ (average 69.3 fg I-TEQ/m³) in summer and (89.8-1.01) × 10³ fg I-TEQ/m³ (average 509 fg I-TEQ/m³) in winter, respectively, except for the E-waste dismantling site where much higher values were observed (1.04 × 10³ fg I-TEQ/m³ in summer and 7.123 × 10³ fg I-TEQ/m³ in winter). The results indicated a significantly seasonal trend with higher TEQ values in winter as compared with summer, which could be related to increased emission sources and seasonal variations of the atmospheric boundary layer height. 2,3,4,7,8-PeCDF was the dominant contributor to the total PCDD/F toxic equivalents, and 2,3,7,8-TCDD was detected at almost all the sampling sites in winter. Most of the similarly substituted PCDD/F congener pairs exhibited high correlations, suggesting that they might have similar environmental fate or sources. But different seasonal and spatial distributions of PCDD/F concentrations indicated that the emission sources might be intermittent.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.