Harvesting of Chlorella sp. using hollow fiber ultrafiltration

Introduction

The suitability of the application of ultrafiltration (UF) to harvest Chlorella sp. from the culture medium was examined. We investigated the effects of two improved UF system, forward air?Cwater flushing and backwash with permeate, on the concentration process.

Materials and methods

Backwash with permeate was selected as an optimization of the improved UF system, which was more effective for permeate flux recovery. Moreover, the hollow fiber UF system by adding periodical backwash with permeate was examined for Chlorella sp. harvesting.

Results and discussion

It was found that Chlorella sp. could be concentrated with high recovery in a lab-scale experiment. An overall algal biomass recovery of above 90% was achieved when the volume concentration factor was 10. For an original biomass of 1.3?±?0.05?g/L, 1?min backwash followed by 20?min forward concentrating was more effective, which resulted in a recovery of 94% and a high average flux of 30.3?L/m²/h. In addition, the algal recovery was highly correlated to the volume concentration factor and the initial biomass. A high concentration factor or a high initial biomass resulted in a low biomass recovery.     

Characteristic, composition, and sources of TSP investigated by HRTEM/EDS and ESEM/EDS

Total suspended particle (TSP) collected at the fifth floor of House Dust in Hunan University, China, was analyzed in terms of microscopic morphology and chemical composition. The fine particles (50?nm-2?μm) in the TSP were analyzed by a high-resolution transmission electron microscope equipped with an energy-dispersive X-ray analyzer (HRTEM/EDS). Results showed that the particles were in shapes of plate, irregular and agglomerate. Based on EDS results, these fine particulate matter was primarily composed of Fe-rich (35.82-61.29%), Ca-rich (30.18-36.77%) and Si-rich (18.95-32.28%) particles. Other elements mainly including Mg (0.47-4.97%), Al (0.45-14.57%), S (0.45-4.73%), K (1.13-2.13%) and Zn (0.67-3.85%) were also observed. The sources analysis indicated that the HRTEM particles mainly originated from coal combustion, traffic emission, vehicles exhaust emission and fugitive soil or cement particulate matter. The coarse particles (4-50?μm) were detected by environmental scanning electron microscopy coupled with energy-dispersive X-ray detector (ESEM/EDS). Based on a simple algorithm, ESEM particles were categorized into five groups: C-bearing (46.15%, 67% and 86.98%), Si + Ca-bearing (21.48?+?11.80%, 16.51?+?10.81% and 16.32?+?10.62%), Si + Al-bearing (20.06?+?12.40%, 20.16?+?11.22% and 15.31?+?11.25%), Si-bearing (34.40%, 26.92% and 27.15%) particles and aggregates, most of which exhibit obvious crystalline structure, and these ESEM particles mainly derived from vehicles exhaust emission, coal combustion, soil, and biomass burning, while the aggregates are indicative of atmospheric reaction progress. HRTEM/EDS and ESEM/EDS are mutual complementary in analyzing the characteristic and determining the sources of TSP.     

Adsorption of 17β-estradiol from aqueous solution by raw and direct/pre/post-KOH treated lotus seedpod biochar

Five biochars derived from lotus seedpod(LSP) were applied to examine and compare the adsorption capacity of 17β-estradiol(E2) from aqueous solution.The effect of KOH activation and the order of activation steps on material properties were discussed.The effect of contact time,initial concentration,p H,ionic strength and humic acid on E2 adsorption were investigated in a batch adsorption process.Experimental results demonstrated that the pseudo second-order model fitted the experimental data best and that adsorption equilibrium was reached within 20 hr.The efficiency of E2 removal increased with increasing E2 concentration and decreased with the increase of ionic strength.E2 adsorption on LSP-derived biochar(BCs) was influenced little by humic acid,and slightly affected by the solution p H when its value ranged from 4.0 to 9.0,but considerably affected at p H 10.0.Low environmental temperature is favorable for E2 adsorption.Chemisorption,π–π interactions,monolayer adsorption and electrostatic interaction are the possible adsorption mechanisms.Comparative studies indicated that KOH activation and the order of activation steps had significant impacts on the material.Post-treated biochar exhibited better adsorption capacity for E2 than direct treated,pretreated,and raw LSP biochar.Pyrolyzed biochar at higher temperature improved E2 removal.The excellent performance of BCs in removing E2 suggested that BCs have potential in E2 treatment and that the biochar directly treated by KOH would be a good choice for the treatment of E2 in aqueous solution,with its advantages of good efficiency and simple technology.     

Growth inhibition and oxidative damage of Microcystis aeruginosa induced by crude extract of Sagittaria trifolia tubers

Aquatic macrophytes are considered to be promising in controlling harmful cyanobacterial blooms. In this research, an aqueous extract of Sagittaria trifolia tubers was prepared to study its inhibitory effect on Microcystis aeruginosa in the laboratory. Several physiological indices of M. aeruginosa, in response to the environmental stress, were analyzed. Results showed that S. trifolia tuber aqueous extract significantly inhibited the growth of M. aeruginosa in a concentration-dependent way. The highest inhibition rate reached 90% after 6 day treatment. The Chlorophyll-a concentration of M. aeruginosa cells decreased from 343.1 to314.2 μg/L in the treatment group. The activities of superoxide dismutase and peroxidase and the content of reduced glutathione in M. aeruginosa cells initially increased as a response to the oxidative stress posed by S. trifolia tuber aqueous extract, but then decreased as time prolonged. The lipid peroxidation damage of the cyanobacterial cell membranes was reflected by the malondialdehyde level, which was notably higher in the treatment group compared with the controls. It was concluded that the oxidative damage of M. aeruginosa induced by S.trifolia tuber aqueous extract might be one of the mechanisms for the inhibitory effects.     

Efficient removal of naphthalene-2-ol from aqueous solutions by solvent extraction

Naphthalene-2-ol is a typical biologically recalcitrant pollutant in dye wastewater.Solvent extraction of naphthalene-2-ol from aqueous solutions using mixed solvents was investigated.Various extractants and diluents were evaluated,and the effects of volume ratio of extractant to diluent,initial p H,initial concentration of naphthalene-2-ol in aqueous solution,extraction time,temperature,volume ratio of organic phase to aqueous phase(O/A),stirring rate and extraction stages,on extraction efficiency were examined separately.Regeneration and reuse of the spent extractant were also investigated.Results showed that tributyl phosphate(TBP) achieved 98% extraction efficiency for naphthalene-2-ol in a single stage extraction,the highest among the 12 extractants evaluated.Extraction efficiency was optimized when cyclohexane and n-octane were used as diluents.The solvent combination of 20% TBP,20% n-octanol and 60% cyclohexane(V/V) obtained the maximum extraction efficiency for naphthalene-2-ol,99.3%,within 20 min using three cross-current extraction stages under the following extraction conditions:O/A ratio of 1:1,initial p H of 3,25°C and stirring rate of 150 r/min.Recovery of mixed solvents was achieved by using 15%(W/W) Na OH solution at an O:A ratio of 1:1 and a contact time of 15 min.The mixed solvents achieved an extraction capacity for naphthalene-2-ol stably higher than90% during five cycles after regeneration.     

Shellac-coated iron oxide nanoparticles for removal of cadmium(II) ions from aqueous solution

This study describes a new effective adsorbent for cadmium removal from aqueous solution synthesized by coating a shellac layer, a natural biodegradable and renewable resin with abundant hydroxyl and carboxylic groups, on the surface of iron oxide magnetic nanoparticles. Transmission Electron Microscopy (TEM) imaging showed shellac-coated magnetic nanoparticle (SCMN) adsorbents had a core-shell structure with a core of 20 nm and shell of 5 nm. Fourier Transform Infrared Spectroscopic analysis suggested the occurrence of reaction between carboxyl groups on the SCMN adsorbent surface and cadmium ions in aqueous solution. Kinetic data were well described by pseudo second-order model and adsorption isotherms were fitted with both Langmuir and Freundlich models with maximum adsorption capacity of 18.80 mg/g. SCMN adsorbents provided a favorable adsorption capacity under high salinity conditions, and cadmium could easily be desorbed using mild organic acid solutions at low concentration.     

A restoration-promoting integrated floating bed and its experimental performance in eutrophication remediation

Numerous studies on eutrophication remediation have mainly focused on purifying water first, then restoring submerged macrophytes. A restoration-promoting integrated floating bed （RPIFB） was designed to combine the processes of water purification and macrophyte restoration simultaneously. Two outdoor experiments were conducted to evaluate the ecological functions of the RP1FB. Trial 1 was conducted to compare the eutrophication purification among floating bed, gradual-submerging bed （GSB） and RPIFB technologies. The results illustrated that RPIFB has the best purification capacity. Removal efficiencies of RPIFB for TN, TP,NH4＋-N, NO3-N, CODcr, Chlorophyll-a and turbidity were 74.45%, 98.31%, 74.71%, 88.81%, 71.42%, 90.17% and 85%, respectively. In trial 2, influences of depth of GSB and photic area in RPIFB on biota were investigated. When the depth of GSB decreased and the photic area of RPIFB grew, the height of Potamogeton crispus Linn. increased, but the biomass of Canna indica Linn. was reduced. The mortalities of Misgurnus anguillicaudatus and Bellamya aeruginosa in each group were all less than 7%. All results indicated that when the RPIFB was embedded into the eutrophic water, the regime shift from phytoplankton-dominated to macrophyte-dominated state could be promoted. Thus, the RPIFB is a promising remediation technology for eutrophication and submerged macrophyte restoration.     

Short-term prediction of the influent quantity time series of wastewater treatment plant based on a chaos neural network model

By predicting influent quantity, a wastewater treatment plant (WWTP) can be well controlled. The nonlinear dynamic characteristic of WWTP influent quantity time series was analyzed, with the assumption that the series was predictable. Based on this, a short-term forecasting chaos neural network model of WWTP influent quantity was built by phase space reconstruction. Reasonable forecasting results were achieved using this method.     

Feasibility of bioleaching combined with Fenton oxidation to improve sewage sludge dewaterability

A novel joint method of bioleaching with Fenton oxidation was applied to condition sewage sludge. The specific resistance to filtration (SRF) and moisture of sludge cake (MSC) were adopted to evaluate the improvement of sludge dewaterability. After 2-day bioleaching, the sludge pH dropped to about 2.5 which satisfied the acidic condition for Fenton oxidation. Meanwhile, the SRF declined from 6.45 × 10¹⁰ to 2.07 × 10¹⁰ s²/g, and MSC decreased from 91.42% to 87.66%. The bioleached sludge was further conditionedwith Fenton oxidation. From an economical point of view, the optimal dosages of H₂O₂ and Fe2+ were 0.12 and 0.036 mol/L, respectively, and the optimal reaction time was 60 min. Under optimal conditions, SRF, volatile solids reduction, and MSC were 3.43 × 10⁸ s²/g, 36.93%, and 79.58%, respectively. The stability and settleability of sewage sludge were both improved significantly. Besides, the results indicated that bioleaching-Fenton oxidation was more efficient in dewatering the sewage sludge than traditional Fenton oxidation. The sludge conditioningmechanisms by bioleaching-Fenton oxidationmight mainly include the flocculation effects and the releases of extracellular polymeric substances-bound water and intercellular water.     

Feasibility of bioleaching combined with Fenton oxidation to improve sewage sludge dewaterability

A novel joint method of bioleaching with Fenton oxidation was applied to condition sewage sludge. The specific resistance to filtration(SRF) and moisture of sludge cake(MSC) were adopted to evaluate the improvement of sludge dewaterability. After 2-day bioleaching, the sludge p H dropped to about 2.5 which satisfied the acidic condition for Fenton oxidation.Meanwhile, the SRF declined from 6.45 × 1010 to 2.07 × 1010s2/g, and MSC decreased from91.42% to 87.66%. The bioleached sludge was further conditioned with Fenton oxidation. From an economical point of view, the optimal dosages of H2O2 and Fe2+were 0.12 and 0.036 mol/L,respectively, and the optimal reaction time was 60 min. Under optimal conditions, SRF,volatile solids reduction, and MSC were 3.43 × 108s2/g, 36.93%, and 79.58%, respectively. The stability and settleability of sewage sludge were both improved significantly. Besides,the results indicated that bioleaching-Fenton oxidation was more efficient in dewatering the sewage sludge than traditional Fenton oxidation. The sludge conditioning mechanisms by bioleaching-Fenton oxidation might mainly include the flocculation effects and the releases of extracellular polymeric substances–bound water and intercellular water.