Subsurface nutrient modelling using finite element model under Boro rice cropping system

Boro rice, an emerging low-risk crop variety of rice, cultivated using residual or stored water after Kharif season. To enhance the quality and production of rice, potassium (K) and phosphorus (P) are the common constituents of agricultural fertilizers. However, excess application of fertilizers causes leaching of nutrients and contaminates the groundwater system. Therefore, assessment and optimization of fertilizer dose are needed for better management of fertilizers. Towards this, the present study determines the path, persistence, and mobility of K and P under the Boro rice cropping system. The experimental site consisted of four plots having Boro rice with four different fertilizer doses of nitrogen (N), P, K viz. 100%, 75%, 50%, and 25% of the recommended dose. Disturbed soil samples were analysed for K and P from pre-sown land to tillering stage at 0–5, 5–10, 10–15, 15–30, 30–45, and 45–60 cm depths. Simultaneously, K and available P were also simulated in the subsurface soil layers through the HYDRUS-1D model. The statistical comparisons were made with RMSER, E, and PBIAS between the modelled values and laboratory-measured values. Although, the results showed that all the treatments considered had agreeable simulations for both K and P, the K simulations were found to be better as compared to P simulations except for 25% where P simulations outperformed K. The simulated concentration at all doses was found most appropriate when measured for the subsurface layers (up to 45 cm), while showed an underestimation in the bottom layers (45–60 cm) of soil.

     

Potential energy production from organic waste and its environmental and economic impacts at a tertiary institution in Palestine

Municipal solid waste (MSW) is one of the most well-known biomass resources that can be utilized to produce renewable energy. Numerous countries are plagued by the proliferation of waste, particularly organic waste that can be utilized for energy recovery. Palestine suffers from inefficient solid waste management, and only recently have a few projects focused on bioenergy production been implemented. Throughout the years, the city of Tulkarm experiences power outages which cause a challenge to the Palestine Technical University-Kadoorie campus in Tulkarm. Thus, the possibility of energy recovery from the organic portion in Palestine Technical University-Kadoorie was evaluated. The analysis of an economic impact included discussions of a number of economic aspects, including Levelized cost of energy, internal rate of return, present worth, annual worth, and payback period. On the other hand, a carbon dioxide savings analysis and gas emission were evaluated. The outcomes of the energy optimization demonstrated that the suggested system could supply the institution with an average of roughly 7 MWh of electrical energy. According to the economic study, this project offers 0.25 million dollars in present value, 0.144 million dollars in annual value, a 13 percent internal rate of return, a payback period of 6 years, and a levelized cost of energy of 0.11 dollars for each kWh generated. Additionally, the environmental assessment revealed that this system might reduce CO₂ emissions by around 8,343,778 tons. For effective waste management, energy recovery, and emission reduction, it is advised to implement anaerobic digestion technology.     

A multivariate statistical approach for the evaluation of spatial and temporal dynamics of surface water quality from the small reservoir located in the drought-prone area of South-West India: a case study of Tiru reservoir (India)

Environmental Science and Pollution Research - With the use of different multivariate statistical analysis methods, spatio-temporal fluctuations in the water parameters of Tiru reservoir located at...     

Toward harmonizing prospective effectiveness assessment for road safety: Comparing tools in standard test case simulations

Abstract

Objective: With the overall goal to harmonize prospective effectiveness assessment of active safety systems, the specific objective of this study is to identify and evaluate sources of variation in virtual precrash simulations and to suggest topics for harmonization resulting in increased comparability and thus trustworthiness of virtual simulation-based prospective effectiveness assessment.

Methods: A round-robin assessment of the effectiveness of advanced driver assistance systems was performed using an array of state-of-the-art virtual simulation tools on a set of standard test cases. The results were analyzed to examine reasons for deviations in order to identify and assess aspects that need to be harmonized and standardized. Deviations between results calculated by independent engineering teams using their own tools should be minimized if the research question is precisely formulated regarding input data, models, and postprocessing steps.

Results: Two groups of sources of variations were identified; one group (mostly related to the implementation of the system under test) can be eliminated by using a more accurately formulated research question, whereas the other group highlights further harmonization needs because it addresses specific differences in simulation tool setups. Time-to-collision calculations, vehicle dynamics, especially braking behavior, and hit-point position specification were found to be the main sources of variation.

Conclusions: The study identified variations that can arise from the use of different simulation setups in assessment of the effectiveness of active safety systems. The research presented is a first of its kind and provides significant input to the overall goal of harmonization by identifying specific items for standardization. Future activities aim at further specification of methods for prospective assessments of the effectiveness of active safety, which will enhance comparability and trustworthiness in this kind of studies and thus contribute to increased traffic safety.     

Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Emerging applications of green coconut: A promising lignocellulosic biomass

Waste accumulation is a grave concern and becoming a transboundary challenge for environment. During Covid-19 pandemic, diverse type of waste were collected due to different practices employed in order to fight back the transmission rate of the virus. Covid-19 was proved to be capricious catastrophe of this 20th century and even not completely eradicated from the world. The havoc created by this imperceptible quick witted, pleomorphic deadly virus can't be ignored. Though a number of vaccines have been developed by the scientists but there is a fear of getting this virus again in our life. Medical studies prove that immunity drinks will help to reduce its reoccurrences. Coconut water is widely used among all drinks available globally. Its massive consumption created an incalculable pile of green coconut shells around the different corners of the world. This practice generating enormous problem of space acquisition for the environment. Both the environment and public health will benefit from an evaluation of quantity of coconut waste that is being thrown and its potential to generate value added products. With this context, present article has been planned to study different aspects like, coconut waste generation, its biological properties and environmental hazards associated with its accumulation. Additionally, this review illustrates, green technologies for production of different value added products from coconut waste.     

Systematic review of conservation interventions to promote voluntary behavior change

Understanding human behavior is vital to developing interventions that effectively lead to proenvironmental behavior change, whether the focus is at the individual or societal level. However, interventions in many fields have historically lacked robust forms of evaluation, which makes it hard to be confident that these conservation interventions have successfully helped protect the environment. We conducted a systematic review to assess how effective nonpecuniary and nonregulatory interventions have been in changing environmental behavior. We applied the Office of Health Assessment and Translation systematic review methodology. We started with more than 300,000 papers and reports returned by our search terms and after critical appraisal of quality identified 128 individual studies that merited inclusion in the review. We classified interventions by thematic area, type of intervention, the number of times audiences were exposed to interventions, and the length of time interventions ran. Most studies reported a positive effect (n = 96). The next most common outcome was no effect (n = 28). Few studies reported negative (n = 1) or mixed (n = 3) effects. Education, prompts, and feedback interventions resulted in positive behavior change. Combining multiple interventions was the most effective. Neither exposure duration nor frequency affected the likelihood of desired behavioral change. Comparatively few studies tested the effects of voluntary interventions on non-Western populations (n = 17) or measured actual ecological outcome behavior (n = 1). Similarly, few studies examined conservation devices (e.g., energy-efficient stoves) (n = 9) and demonstrations (e.g., modeling the desired behavior) (n = 5). There is a clear need to both improve the quality of the impact evaluation conducted and the reporting standards for intervention results.     

Improvement of Impact Toughness of Biodegradable Poly(butylene succinate) by Melt Blending with Sustainable Biobased Glycerol Elastomers

Poly(butylene succinate) (PBS) was melt blended with glycerol based polyesters (PGS) synthesized from pure and technical glycerol aiming to improve the impact strength of PBS. It was found that after addition of 30 wt% PGS to PBS its impact strength was significantly increased by 344% (from 31.9 to 110 J/m) and its elongation at break was maintained at 220%. Infrared spectra of the blends showed the presence of hydroxyl groups from the PGS phase suggesting that hydrogen bonding between the phases could be responsible for a good stress transfer and an efficient toughening in the PBS/PGS blends. Scanning electron microscopy imaging showed a good dispersion of PGS phase into PBS with a PGS particle size of 10 μm and less and no agglomeration. Addition of PGS to PBS was shown to be an effective strategy for improvement of PBS impact resistance without serious detrimental effects on its thermal and rheological properties.     

Are older drivers’ driving patterns during an on-road driving task representative of their real-world driving patterns?

Abstract

Objective: The current study investigated whether older drivers’ driving patterns during a customized on-road driving task were representative of their real-world driving patterns.

Methods: Two hundred and eight participants (male: 68.80%; mean age?=?81.52 years, SD?=?3.37 years, range?=?76.00–96.00 years) completed a customized on-road driving task that commenced from their home and was conducted in their own vehicle. Participants’ real-world driving patterns for the preceding 4-month period were also collected via an in-car recording device (ICRD) that was installed in each participant’s vehicle.

Results: During the 4-month period prior to completing the on-road driving task, participants’ median real-world driving trip distance was 2.66?km (interquartile range [IQR]?=?1.14–5.79?km) and their median on-road driving task trip distance was 4.41?km (IQR?=?2.83–6.35?km). Most participants’ on-road driving task trip distances were classified as representative of their real-world driving trip distances (95.2%, n?=?198).

Conclusions: These findings suggest that most older drivers were able to devise a driving route that was representative of their real-world driving trip distance. Future research will examine whether additional aspects of the on-road driving task (e.g., average speed, proportion of trips in different speed zones) are representative of participants’ real-world driving patterns.