CuO-CeO2/AC吸附燃煤烟气中元素汞的实验研究

通过活性炭负载CuO和CeO2来制备吸附剂,采用固定床吸附方式,在不同反应条件下对吸附剂的吸附性能进行测试,筛选出去除效率最好的吸附剂,并通过BET和XRD对吸附剂的理化性质进行分析。结果表明,CuO和CeO2的加入大大改变了原活性炭的比表面积和孔结构,改善了活性炭的吸附性能。CuO-CeO2/AC中CuO和CeO2质量比不同,对汞的去除效率也不同,在1∶2时去除效率最好;CuO-CeO2/AC中所负载的CuO和CeO的总量为5%时,能大大促进汞的吸附效率,增长有效吸附时间;CuO-CeO2/AC对汞的吸附性能随反应温度的增加呈先增加后减小的趋势,在80℃时达到最大值。     

可见光响应型CuO/BiVO4的光催化活性研究

采用浸渍法制备了CuO/BiVO4光催化剂,通过X射线衍射(XRD)、热重/差示扫描量热(TG/DSC)和傅立叶红外光谱(FTIR)对其进行了表征,并在可见光照射下考察了其光催化氧化亚甲基蓝(MB)的动力学特性。结果表明,Cu的掺杂并未改变BiVO4的晶型结构;Cu(NO3)2/BiVO4在热处理(30～300℃)过程中,NO3-已经完全分解,Cu最终以CuO的形式存在于CuO/BiVO4光催化剂体系中;掺杂不同量Cu的CuO/BiVO4中的Cu2+/Bi+(摩尔比)实测值与理论值相近,该系列光催化剂的合成过程具有较高的可信度;在可见光照射下,CuO/BiVO4光催化降解MB反应符合表观一级反应动力学特征;当Cu2+/Bi+为0.050时,反应动力学速率常数(k)达到最高值(0.4334h-1),此时的k比单体BiVO4作用下的提高了1.04倍;由于异质结的存在,CuO/BiVO4与单体BiVO4相比,电子和空穴的利用率大大增加,使得CuO/BiVO4的光催化活性较单体BiVO4有了大幅度提高。     

CuO / 过硫酸氢钾体系催化氧化苯酚简

本论文通过直接沉淀法制备了CuO催化剂，结合过硫酸氢钾，在常温常压下催化氧化处理苯酚模拟废水。采用电子显微镜（SEM）、X射线粉末衍射（XRD）对催化剂进行了表征，并研究了反应过程中各影响因素对降解效率的影响。实验结果表明，在催化剂用量为0.2 g/L，氧化剂浓度为0.25 g/L，pH值为7，反应时间为60 min的条件下，浓度为50 mg/L的苯酚降解率可达100%，TOC去除率达84%。进一步实验表明，催化剂具有良好的重复使用能力。最后，通过自由基捕捉实验，考察了体系中的自由基种类，并根据实验结果，讨论了CuO/过硫酸氢钾体系的催化降解机理。     

CuO对贵金属/CeO2/Al2O3催化剂的作用

制备含少量贵金属Ｐｔ、Ｐｄ的不同Ｃｕ和Ｃｅ摩尔含量比（０：１０,１：９,２：８）的催化剂,实验条件十加入ＣｕＯ可以提高Ｐｔ催化剂的二效活性;加入Ｃｕ：Ｃｅ＝２：８的ＣｕＯ降低了Ｐｄ催化剂的顾效性能,然而Ｃｕ：Ｃｅ＝１：９时可以改善Ｐｄ催化剂的三效催化性能。通过结构分析,认为ＣｕＯ的存在可以提高ｄ催化剂的比表面积,ＰｄＯ的分散度。     

催化湿式氧化处理造纸废水的研究

以过渡金属氧化物CuO为活性组分,采用催化湿式氧化法处理造纸废水,考察Cu负载量、催化剂用量、反应温度对废水COD去除率的影响。结果表明:固定氧气分压在2.5MPa和反应时间3h,催化剂用量为3g,Cu负载量为4%,反应温度为220℃,500mL浓度为3250mg/L造纸废水的COD去除率为90%,色度去除率为89%,pH值由9.6变为7.8。另外,对催化剂进行再生处理和稳定性测试。结果表明:450℃下活化3h,在上述相同反应条件下,对原废水的COD去除率降低为88%,重复使用9次后对废水的COD去除率仍能保持在85%左右。     

Mn-Cu-O负载型催化剂上CO氧化性能的研究

研究了ＺｒＯ２或Ａｌ２Ｏ３负载Ｍｎ－Ｃｕ－Ｏ体系催化剂ＣＯ催化氧化活性，以及物相结构，表面氧性能与活性的关系。结果表明，锆基催化剂的氧化活性明显优于铝基催化剂，起燃温度Ｔ５０低达５０℃，ＺｒＯ２载 利于活性组份形成高活性物相，并促进表面吸附氧的脱附，表现出催化剂表面吸附氧的脱附温度高低次序与其氧化活性有一致的对应关系。     

Catalysts for decomposing ozone tail gas

The preparation of immobilizing-catalysts for decomposing ozone by using dipping method was studied. XRD, XPS and TEM were used to characterize the catalysts. The three kinds of catalysts were selected preferentially, and their catalytic activities were investigated. The results showed that the catalyst with activated carbon dipping acetate( active components are Mn:Cu = 3:2, active component proportion in catalyst is 15%, calcination temperature is 200℃ ) has the best catalytic activity for ozone decomposing. One gram of catalyst can decompose 17.6g ozone at initial ozone concentration of 2.5g/m^3 and the residence time in reactor of 0.1s. The experimental results also indicated that humidity of reaction system had negative effect on catalytic activity.     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

超声-过氧化氢-氧化铜组合技术催化氧化水中苯酚

研究了超声-H2O2-CuO组合技术对苯酚的降解效果。考察了苯酚初始浓度、溶液温度及鼓入空气对苯酚去除率的影响。实验结果表明，与未鼓入空气时相比，连续鼓气时苯酚的降解效果较好；初始浓度低，苯酚去除率高；溶液温度从20％上升到55％时，苯酚去除率随温度升高而增大，温度对该过程的影响主要表现为对催化剂的影响而不是对超声作用的影响。高效液相色谱分析表明，苯酚降解的中间产物主要为对苯二酚、邻苯二酚及其他有机小分子物质，最终产物为草酸、二氧化碳和水。