Fast,cheap, and imperfect? US public opinion about solar geoengineering

ABSTRACT

Solar geoengineering, which seeks to cool the planet by reflecting a small fraction of sunlight back into space, has drawn the attention of scientists and policymakers as climate change remains unabated. Unlike mitigation, solar geoengineering could quickly and cheaply lower global temperatures. It is also imperfect. Its environmental impacts remain unpredictable, and its low cost and immediate effects may result in ‘moral hazard,’ potentially crowding out costly mitigation efforts. There is little understanding about how the public will respond to such tradeoffs. To address this, a 1000-subject nationally representative poll focused on solar geoengineering was conducted as part of the Cooperative Congressional Election Study (CCES) of the US electorate in October–November 2016. The importance that individuals place on solar geoengineering’s speed and cost predicts their support for it, but there is little to no relationship between their concerns about its shortcomings and support for its research and use. Acquiescence bias appears to be an important factor for attitudes around solar geoengineering and moral hazard.     

Climate engineering and human rights

ABSTRACT

In this Forum, three scholars discuss how climate engineering will pose novel human rights challenges, and may well force reconsideration of how human rights are applied as a guide to action. Following a short introduction, the first section introduces three competing approaches to human rights, arguing views which emphasize fairness or attempt to maximize satisfaction are more promising than one viewing human rights as inviolable ‘side-constraints’. The second section draws lessons from climate migration that are relevant for climate engineering in terms of incorporating a human rights approach to duties, rights, and participation. The final section compares the ‘needs-based’ and ‘rights-based’ approaches to humanitarian work in the face of climate change and climate engineering, raising concerns for duty-bearers and right-holders. The Forum’s conclusion draws together points of overlap and suggests a path forward for policy and research on this topic.     

录井系统雷击危害分析及模拟试验研究

针对雷击电磁辐射对录井系统的危害问题，建立了录井系统线路雷击危害模拟试验模型，采用8/20 μs冲击电流发生器，开展了录井系统的雷击耦合试验，定量分析了雷击电磁辐射对录井系统的影响。研究结果表明:随着电流的增大和距离电流通道的减小，耦合的电压随之增大；线缆长度越长耦合的电压越大，最大耦合电压达到了2 720 V；屏蔽层接地可以有效地减小电磁辐射对线缆的耦合作用。     

深圳市天然γ辐射空气吸收剂量率调查

从2007年至2011年在深圳市进行了天然γ辐射空气吸收计量的调查.调查结果显示：全市天然辐射外照射空气吸收剂量率的变化范围为（4.87 ～17.68）×10^ 8Gy/h,平均值为10.00 ×10^ 8Gy/h,与广东省平均水平相当,稍高于全国平均值,属于正常天然本底范围;天然辐射外照射致深圳市居民人均年有效剂量当量（0.22 ～ 1.08） mSv,低于广东省与全国的平均水平;集体有效剂量当量54.32×10^2man· Sv.     

我国辐射环境自动监测系统建设的回顾与展望

辐射环境自动监测是我国辐射环境监测工作的重要内容,是核与辐射安全监管工作的重要手段.本文回顾了“十一五”以来,我国辐射环境自动监测系统建设的进展情况和在核与辐射监管工作中所发挥的作用,总结了辐射环境自动监测系统的建设和运行经验,并对今后的工作进行了展望,提出了完善系统建设和运行的合理化建议.研究指出,作为国家辐射环境监测网的重要组成部分,辐射环境自动监测系统初步具备了对我国省会城市和主要地级城市的辐射环境质量状况的实时监测能力.但由于我国辐射环境自动监测站于2008年底才开始在全国范围内建设,起步较晚、经验不足,依然存在点位数量和代表性不够、自动化程度不够高、软件系统功能不成熟、标准化和规范化问题比较突出,缺乏质量控制技术、运行维护难度大等问题.为此本文提出：第一,增加自动监测站数量,点位布设更有针对性;第二,增加自动监测站的类型;第三,加强软件系统的分析和控制能力;第四,完善相关标准、技术规范和质保体系;第五,完善运行维护体系;第六,增强国际学习和交流.     

铀尾矿库尾矿砂大气污染的控制研究

铀尾矿库运行期间,裸露的尾矿以扬尘形式对周边地区造成环境污染和辐射危害.因此,本文以平地型铀尾矿库为对象,应用CFD技术,探讨滩面形状(弧形、棱形和锥形)对减轻或控制运行期间尾矿库滩面颗粒物的大气迁移和环境污染的作用.结果表明,常年主导风速V=1.0m·s-1条件下,以1 mg·m-3的浓度为抑尘标准时弧形滩面抑尘效果最为明显,棱形滩面和锥形滩面抑尘效果较差.通过对不同风速下几种滩面形状防护效果的分析对比发现,小风速(V=0.5 m·s-1)下3种滩面形式辐射防护均效果良好,但随风速的增大效果逐渐减弱;弧形滩面条件下综合防护效果最佳.     

Insights into metals in individual fine particles from municipal solid waste using synchrotron radiation-based micro-analytical techniques

Excessive inter-contamination with heavy metals hampers the application of biological treatment products derived from mixed or mechanically-sorted municipal solid waste (MSW). In this study, we investigated fine particles of < 2 mm, which are small fractions in MSW but constitute a significant component of the total heavy metal content, using bulk detection techniques. A total of 17 individual fine particles were evaluated using synchrotron radiation-based micro-X-ray fluorescence and micro-X-ray diffraction. We also discussed the association, speciation and source apportionment of heavy metals. Metals were found to exist in a diffuse distribution with heterogeneous intensities and intense hot-spots of < 10 μm within the fine particles. Zn-Cu, Pb-Fe and Fe-Mn-Cr had significant correlations in terms of spatial distribution. The overlapped enrichment, spatial association, and the mineral phases of metals revealed the potential sources of fine particles from size-reduced waste fractions (such as scraps of organic wastes or ceramics) or from the importation of other particles. The diverse sources of heavy metal pollutants within the fine particles suggested that separate collection and treatment of the biodegradable waste fraction (such as food waste) is a preferable means of facilitating the beneficial utilization of the stabilized products.     

Synergistic effect of ozonation and ionizing radiation for PVA decomposition

Ozonation and ionizing radiation are both advanced oxidation processes (AOPs) without chemical addition and secondary pollution. Also, the two processes'' efficiency is determined by different pH conditions, which creates more possibilities for their combination. Importantly, the combined process of ozonation and ionizing radiation could be suitable for treating wastewaters with extreme pH values, i.e., textile wastewater. To find synergistic effects, the combined process of ozonation and ionizing radiation mineralization was investigated for degradation of polyvinyl alcohol (PVA) at different pH levels. A synergistic effect was found at initial pH in the range 3.0–9.4. When the initial pH was 3.0, the combined process of ozonation and ionizing radiation gave a PVA mineralization degree of 17%. This was 2.7 times the sum achieved by the two individual processes, and factors of 2.1 and 1.7 were achieved at initial pH of 7.0 and 9.4, respectively. The combined process of ozonation and ionizing radiation was demonstrated to be a feasible strategy for treatment of PVA-containing wastewater.     

振荡辐射下PMMA 热解与着火过程研究

采用正弦波变化振荡的辐射热流,对热厚PMMA(聚甲基丙烯酸甲酯)的热解和着火过程进行研究,同时采用数值模拟,对实验结果进行验证和补充。结果表明,表面温度和深度温度随着时间而增加,温度由于周期性的辐射而发生振荡,而振荡幅度随着深度的增加而衰减;表面温度与深度温度振荡存在时间延迟;着火时间随着热流振荡周期的增大而减小,主要由于平均热流密度随着周期增大而增大。     

北京市某高层建筑高空电磁辐射环境影响分析

选取北京市某代表性高层居民楼顶平台作为高空电磁辐射环境水平监测点进行综合场强和选频监测，评价总体电磁辐射环境水平，并分析监测区域电磁辐射能量的来源。结果表明：该高空监测区域的电磁辐射环境总体水平低于国家规定的公众照射导出限值，但高于地面水平。监测区域主要受30 km 外的中波台影响，其次是9 km 外的中央电视塔。影响最大的是639 kHz频率的中波信号，占100 kHz～300 MHz总场强的95％以上，其次是1．28 MHz频率的中波信号。提出，开展敏感建筑物规划建设时，应考虑中波的传播特性和对环境的影响。