电沉积处理含镉废水的性能研究

电沉积含镉废水考察溶液的不同初始p H、镉的不同初始浓度、电流密度及金属配合物对电沉积效果的影响,利用SEM和XRD对沉积物的表面形貌和物相成分进行分析,研究沉积物金属的存在形式。实验结果表明,p H在1.5~3.5时,溶液中镉的去除效果达到99.3%;一级动力学常数随着初始镉溶液浓度增加而变大;当电流密度为4.46 m A/cm2进行90 min电沉积时反应速率较快且沉积量最大;氨水与镉形成的配合物可以促进电沉积镉的反应速率;对电沉积后的沉积物进行扫描电镜(SEM)和X-射线衍射(XRD)测试。SEM表明,沉积物呈现树枝状的纳米结构。XRD表明,沉积物主要成分为氢氧化镉和镉。     

Characterization of MSWI fly ash through mineralogy and water extraction

This paper investigates the mineralogical characteristics of fresh, aged and hot water extracted MSWI fly ash for providing the baseline information of minerals stability which controls the released heavy metals into the environment. Quantitative determination of bulk phase abundance in the fresh fly ash by the XRD Rietveld refinement method provided composition levels for amorphous and crystalline phases such as potassium tetrachlorozincate (K₂ZnCl₄), gehlenite, halite, quartz, anhydrite, and feldspar. The minerals association in the fly ash is clearly unstable and subject to mineralogical reactions. The phases of K₂ZnCl₄, halite and anhydrite in the fresh fly ash were involved in hydration and dissolution/precipitation processes to form new minerals such as the Zn-bearing mineral gordaite, syngenite, gypsum and hydrocalumite. The solubility-controlling phases and extractability of heavy metals were examined in a Soxhlet hot water-extractor. Here the soluble salts were simply removed from fly ash while Ca-, Al-, Si- and SO₄²⁻-bearing hydrate minerals were precipitated from the extraction solution. Furthermore, a low release of heavy metals Zn, Pb and Cd in hot water was noticed, indicating a strong retention of the trace metals in the mineral phases remaining in the insoluble fly ash residues.     

响应面分析法优化稀土废水MAP沉淀法脱氮

经过预处理后的稀土生产废水，其氨氮浓度大幅降低，但并未达到中华人民共和国《稀土工业污染物排放标准》（GB26451-2011）中氨氮浓度限值。实验通过响应面分析法中的Box-Behnken实验设计（BBD），取pH、n（Mg）：n（N）、n（P）：n（N）3因素，采用Design-Expert 8.0.6，建立合适的剩余氨氮浓度及剩余总磷浓度模型，得到回归方程，并分析模型各项指标，各因素及其相互作用对剩余氨氮浓度及剩余总磷浓度的影响。利用预测模型预测最佳实验条件，在最佳实验条件下验证预测结果，并对沉淀物进行X射线衍射（XRD）分析。结果显示，二次响应模型适用于剩余氨氮浓度及剩余总磷浓度，2个模型均拥有较好的拟合程度、可信度及精密度，最优反应条件为：pH=9.88、n（Mg）：n（N）=1.50：1、n（P）：n（N）=1.38：1时，剩余氨氮浓度为46.58 mg/L，剩余总磷浓度为7.85 mg/L。在最优条件下所得到的沉淀物并非纯净的MgNH₄PO₄·6H₂O，还有Mg₃（PO₄）₂·22H₂O生成。     

扎当冰川雪坑中不同粒径微粒元素和矿物组成特征

为了研究雪冰中不溶性微粒的矿物和元素组成及其来源,2009年5月和7月在念青唐古拉山扎当冰川垭口采集了2个雪坑样品,采用质子激发X荧光分析（PIXE）和X射线衍射定量分析方法（XRD）测定了不同季节粗细微粒（d〉10μm和0.22μm     

MAP沉淀法目标产物最优形成条件及分析方法

为了确定鸟粪石(MAP：MgNH₄PO₄·6H₂O)形成的最优条件,引入化学剖析法,利用酸溶液将鸟粪石沉淀法中所得沉淀物溶解后进行相应的元素分析;提出一种根据沉淀物中的NH⁺₄-N含量间接计算确定鸟粪石含量(即纯度)的分析方法.根据这种计算分析方法,分别得出了不同pH条件下以自来水(主要为地下水)和超纯水作为溶剂所合成的鸟粪石纯度,并对pH和Ca²⁺在鸟粪石形成过程中的影响进行了评估.结果表明,该计算分析方法能够有效实现对MAP沉淀法目标产物的定量分析,弥补了国内外目前普遍依靠XRD技术定性判断所得沉淀物中鸟粪石是否存在的缺陷.以超纯水作为溶剂时,使鸟粪石纯度>90%的最佳pH范围在7.5～9.0,而以自来水为溶剂时,获得相同鸟粪石纯度最佳pH范围则是7.0～7.5.实际污水中常常含有相当数量的Ca²⁺,实施碱性条件(pH>8.0)的MAP沉淀势必大幅降低鸟粪石的纯度.因此,对实际污水回收磷而言,MAP沉淀法的最优pH条件应控制在中性范围(<8.0)以内.     

摩尔配比对MAP沉淀法回收模拟废水中磷的影响

以磷浓度50mg/L的实验室模拟废水为研究对象,考察了以鸟粪石(MAP)形式回收磷的最佳摩尔配比,并借助X-衍射(XRD)对不同摩尔配比条件下得到的沉淀物进行分析。试验结果表明,在pH=9.5时,以鸟粪石形式回收磷的最佳Mg:N:P=4:1.6:1。对沉淀物的XRD分析发现,在pH=9.5,当固定Mg:P=1.6时,N:P=1时沉淀物中基本不含MAP,当N:P=2时,生成的沉淀物中混有少量的副产物Mg(3PO)42,当N:P2时则生成较纯的MAP;当固定N:P=4时,Mg:P=2是生成较纯的MAP的临界值,超过此比例则生成副产物Mg(3PO)42;当反应按照理论配比投加氨氮和镁盐时,所得产物基本不是MAP,而是副产物Mg(3PO)42。故鸟粪石沉淀结晶反应中应尽量提高氨氮配比,并避免投加过量的镁盐,以保证回收产物的纯度。     

Mechanical performance and capillary water absorption of sewage sludge ash concrete (SSAC)

Disposal of sewage sludge from waste water treatment plants is a serious environmental problem of increasing magnitude. Waste water treatment generates as much as 70 g of dry solids per capita per day. Although one of the disposal solutions for this waste is through incineration, still almost 30% of sludge solids remain as ash. This paper presents results related to reuse of sewage sludge ash in concrete. The sludge was characterised for chemical composition (X-ray flourescence analysis), crystalline phases (X-ray diffraction analysis) and pozzolanic activity. The effects of incineration on crystal phases of the dry sludge were investigated. Two water/cement (W/C) ratios (0.55 and 0.45) and three sludge ash percentages (5%, 10% and 20%) per cement mass were used as filler. The mechanical performance of sewage sludge ash concrete (SSAC) at different curing ages (3, 7, 28 and 90 days) was assessed by means of mechanical tests and capillary water absorption. Results show that sewage sludge ash leads to a reduction in density and mechanical strength and to an increase in capillary water absorption. Results also show that SSAC with 20% of sewage sludge ash and W/C = 0.45 has a 28 day compressive strength of almost 30 MPa. SSAC with a sludge ash contents of 5% and 10% has the same capillary water absorption coefficient as the control concrete; as for the concrete mixtures with 20% sludge ash content, the capillary water absorption is higher but in line with C20/25 strength class concretes performance.     

Performance of lime-BHA solidified plating sludge in the presence of Na2SiO3 and Na2CO3

This research investigated the performance of lime-BHA (black rice husk ash) solidified plating sludge with 2 wt% NaO from Na(2)SiO(3) and Na(2)CO(3) at the level of 0, 30 and 50 wt%. The sludge was evaluated for strength development, leachability, solution chemistry and microstructure. The lime-BHA solidified plating sludge with Na(2)SiO(3) and Na(2)CO(3) had higher early strength when compared to the control. The addition of Na(2)SiO(3) and Na(2)CO(3) increased the OH(-) concentration and decreased the Ca(2+) and heavy metal ions in solution after the first minute. The XRD patterns showed that the addition of Na(2)SiO(3) resulted in the formation of calcium silicate hydrates, while the addition of Na(2)CO(3) resulted in CaCO(3). The heavy metals from the plating sludge, especially Zn, were immobilized in calcium zincate and calcium zinc silicate forms for the lime-BHA with and without Na(2)SiO(3) solidified wastes, while samples with Na(2)CO(3) contained Zn that was fixed in the form of CaZnCO(3). The cumulative leaching of Fe, Cr and Zn from the lime-BHA solidified plating sludge decreased significantly when activators were added, especially Na(2)CO(3).     

MgAlFe复合氧化物氧化吸附SO2的性质

MgAlFe水滑石在600℃以上焙烧后脱去表面水和层间水形成MgAlFe复合氧。通过对MgAlFe复合氧化物BET、XRD表征和测定它的吸附硫容，发现它对SO2有优良的氧化吸附性能。吸附SO2后MgO和尖晶石相消失，形成硫酸盐晶相。用氢气对饱和吸附SO2后的MgAlFe复合氧化物进行还原再生，发现它经过10次吸附还源循环后，MgO和尖晶石的晶相依然存在，是一种可循环利用脱除SO2的环境催化材料。     

重庆城区大气颗粒物的元素、离子及物相组成研究

采用X－射线能谱（EDX），傅立叶红外光谱（FT－IR），X－射线衍射（XRI）对重庆市区大气颗粒污染物的元素组成，离子，物相组成进行顾研究，EDX检出了S，Cl,K,Ca,Ti,Cr,Mn,Fe,Cu,Se,Sr,Zr,Rb,Ga,Hg,Zn,Ni元素，FT－IR光谱发现主要存在SO4^2-,NH4^ 和NO3^-,XRD结果表明存在CaSO4.2H2O,α-SiO2,(NH4)2Ca(SO4)2.2H2O,(NH4)2SO4等4个主要物相以及Fe3O4,CaCO3等物相，初步讨论了重庆大气颗粒物的污染来源及其时间，空间分布。