Potential energy production from organic waste and its environmental and economic impacts at a tertiary institution in Palestine

Municipal solid waste (MSW) is one of the most well-known biomass resources that can be utilized to produce renewable energy. Numerous countries are plagued by the proliferation of waste, particularly organic waste that can be utilized for energy recovery. Palestine suffers from inefficient solid waste management, and only recently have a few projects focused on bioenergy production been implemented. Throughout the years, the city of Tulkarm experiences power outages which cause a challenge to the Palestine Technical University-Kadoorie campus in Tulkarm. Thus, the possibility of energy recovery from the organic portion in Palestine Technical University-Kadoorie was evaluated. The analysis of an economic impact included discussions of a number of economic aspects, including Levelized cost of energy, internal rate of return, present worth, annual worth, and payback period. On the other hand, a carbon dioxide savings analysis and gas emission were evaluated. The outcomes of the energy optimization demonstrated that the suggested system could supply the institution with an average of roughly 7 MWh of electrical energy. According to the economic study, this project offers 0.25 million dollars in present value, 0.144 million dollars in annual value, a 13 percent internal rate of return, a payback period of 6 years, and a levelized cost of energy of 0.11 dollars for each kWh generated. Additionally, the environmental assessment revealed that this system might reduce CO₂ emissions by around 8,343,778 tons. For effective waste management, energy recovery, and emission reduction, it is advised to implement anaerobic digestion technology.     

Biohythane production from pineapple peel using Methanosarcina mazei enhanced with palm oil mill effluent (POME) sludge in single-stage anaerobic digestion

Biohythane production via single-stage anaerobic digestion (AD) is an effective way for sustainable energy recovery from lignocellulosic biomass. In this paper, biohythane was produced through the AD process from pineapple peel waste substrate using purely cultured Methanosarcina mazei with the enhancement of palm oil mill effluent (POME) sludge as the inoculum. This study focuses on the effects of the lignocellulosic pre-treatment method, the addition of POME sludge into M. mazei culture medium as inoculum, and various operational conditions (food to microorganisms (F/M) ratios, temperature, pH) on gas production performances. The experimental results indicate that these parameters influenced the efficiency of biohythane production by producing the peak maximum biohythane production rate values (HPR_max) and (MPR_max), H₂:CH₄ = 1.93:0.67 L/L-d, and biohythane yield (HY) and (MY), H₂:CH₄ = 1.18:0.55 mL/L-substrate. This study demonstrates that biohythane gas (H₂ + CH₄ + CO₂) production from pineapple waste can be accelerated by M. mazei only with the enhancement of POME sludge through single-stage AD system under mesophilic batch process conditions.     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

臭氧氧化—湿式钙法吸收工艺对烟气的同时脱硫脱硝

采用臭氧氧化—湿式钙法吸收工艺对模拟烟气进行同时脱硫脱硝处理。O₃于150 ℃下具有较高的热稳定性,可将NO氧化为高价态氮氧化物,且NO氧化率随n（O₃）∶n（NO）的增大而逐渐提高。烟气中SO₂和H₂O的存在对NO氧化率的影响不大。O₃对SO₂的氧化率较低,约为5%。3%（w）石灰石浆液对SO₂的吸收率接近100%,NO_x吸收率随n（O₃）∶n（NO）的增大而逐渐提高,当n（O₃）∶n（NO）为1.6时NO_x吸收率可达约65%。SO₂能促进吸收液对NO_x的脱除。石灰石浆液中加入0.2%（w）的（NH₄）₂SO₃或Na₂SO₃后NO_x吸收率可达约85%或82%,且吸收率随添加剂加入量的增加而提高,添加（NH₄）₂SO₃的NO_x吸收率略高于添加Na₂SO₃。     

SMBBR-AF-SMBBR组合工艺处理高氨氮农药废水

采用特异性移动床生物膜反应器(SMBBR)和厌氧生物滤池(AF)组合工艺处理高氨氮农药废水。考察了HRT、pH和DO等工艺条件对SMBBR-AF-SMBBR组合工艺运行稳定期COD和氨氮去除率的影响。试验结果表明,在进水COD为2 408~7 440 mg/L、ρ(NH_4~+-N)为160.21~433.84 mg/L、TN为208.27~537.65 mg/L、HRT为8d、pH为8.0、DO为4 mg/L的条件下,处理后出水平均COD为342 mg/L,COD去除率达92.3%;ρ(NH_4~+-N)小于4.0mg/L,氨氮平均去除率为89.2%;TN小于50 mg/L,平均TN去除达83.0%。出水各指标均优于原A2O工艺出水。     

水中总氮测定方法存在问题的研究及改进

碱性过硫酸钾消解紫外分光光度法测定水中总氮采用的消解器皿是玻璃比色管,易造成空白偏高、结果偏低等问题。采用双圆柱状的消解杯对水样进行消解。结果表明,消解杯消解水中总氮,线性相关系数均大于0.999,检出限为0.05 mg/L,相对标准偏差小于5%,相对误差为0.88%~1.00%;改进后的消解器皿具有较好的精密度和准确度,能够更加准确测定水中总氮的含量。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

活性炭吸附和两级Fenton氧化组合工艺处理高盐对氨基苯酚生产废水

采用活性炭吸附和两级Fenton氧化组合工艺对高盐度对氨基苯酚生产废水进行了处理实验研究。结果表明,p H值对活性炭去除有机物的影响较小。当活性炭投加量为4 g/L时,TOC去除率61%。分级加药可以有效提高Fenton氧化对有机物的去除效率。在温度为25℃、p H为3、30%H2O2投加量为3%(V/V)、Fe2+/H2O2摩尔比为0.05时,两级Fenton氧化处理后,出水TOC降至150 mg/L以下。此外,Fenton氧化后形成氢氧化铁污泥颗粒粒径为4.5μm,经过聚丙烯酰胺(PAM)絮凝之后,污泥的粒径明显增加,过滤特性改善。PAM絮凝效果依赖于溶液的p H值,当p H超过10后会失去作用,故在使用过程中需要严格控制溶液的p H值。     

酸碱度对生活垃圾焚烧厂沥滤液蒸发处理效果的影响

采用蒸发法处理城市生活垃圾焚烧厂垃圾沥滤液,着重考察了不同沥滤液初始pH值对蒸发去除COD和氨氮效果的影响,并采用GC-MS对蒸发冷凝液中有机物成分进行了分析鉴定.结果表明,生活垃圾沥滤液的初始pH对冷凝液中COD、氨氮含量及有机污染物分布产生了决定性的影响.沥滤液在酸性条件下(pH≤6)蒸发,随着pH的增加,冷凝液中COD的含量线性降低,而氨氮的含量线性增加.当沥滤液的初始pH值从6增加到11,冷凝液中COD的含量呈对数函数降低,而氨氮的含量表现出显著增加趋势.从冷凝液中鉴定出38种有机污染物,多为沸点较低的醇、酸、酚和酯类.在酸性条件下(pH=3),冷凝液中挥发性有机酸和低碳醇的相对丰度接近90％.在近中性条件下(pH=6.2),冷凝液中的有机污染物以酚、酸和杂环类化合物为主.在碱性条件下(pH =11),冷凝液中酚和杂环类化合物占比较高,而酸的含量极少.     

页岩对污泥氨气挥发的抑制作用

氨气是城市污水污泥产生的恶臭气体之一,控制或抑制其产生是资源化利用甚至处置过程中至关重要的.通过改进氨气测量方法定量分析外掺页岩对污泥氨气挥发的抑制作用和机理,实验研究了页岩掺量、陈放形式以及环境温度对污泥氨气挥发浓度的影响.结果表明,外掺页岩对污泥氨气挥发具有明显的抑制作用,随温度升高、陈放时间延长抑制效果有所减弱但仍具有明显作用;页岩对污泥氨气挥发的抑制作用主要为对氨气的吸附作用.