臭氧氧化—湿式钙法吸收工艺对烟气的同时脱硫脱硝

采用臭氧氧化—湿式钙法吸收工艺对模拟烟气进行同时脱硫脱硝处理。O₃于150 ℃下具有较高的热稳定性,可将NO氧化为高价态氮氧化物,且NO氧化率随n（O₃）∶n（NO）的增大而逐渐提高。烟气中SO₂和H₂O的存在对NO氧化率的影响不大。O₃对SO₂的氧化率较低,约为5%。3%（w）石灰石浆液对SO₂的吸收率接近100%,NO_x吸收率随n（O₃）∶n（NO）的增大而逐渐提高,当n（O₃）∶n（NO）为1.6时NO_x吸收率可达约65%。SO₂能促进吸收液对NO_x的脱除。石灰石浆液中加入0.2%（w）的（NH₄）₂SO₃或Na₂SO₃后NO_x吸收率可达约85%或82%,且吸收率随添加剂加入量的增加而提高,添加（NH₄）₂SO₃的NO_x吸收率略高于添加Na₂SO₃。     

聚硅酸铝铁/羧基壳聚糖复合絮凝剂处理硫化黑染料废水的研究

用聚硅酸铝铁/羧基壳聚糖复合絮凝剂对硫化黑染料废水进行了处理,研究了影响絮凝剂处理硫化黑染料废水的影响因素。结果表明,较佳的条件为转速50 r/min、聚硅酸铝铁和羧基壳聚糖的质量配比为3、废水pH值为9.0、絮凝剂用量为60 mg/L。在该条件下,复合絮凝剂对硫化黑染料废水的COD、色度、浊度去除率分别为92.1%,88.6%,96.3%。     

电石炉炉气电改袋除尘技术

介绍了某厂3台20 000kVA内燃式电石炉炉气除尘系统由原来采用的电式除尘器改为袋式除尘器技术,同时将原系统内的增湿塔改造为强制风冷及预荷电、预除尘设备,这样不但可以降低烟气温度使其满足袋式除尘器对进口烟气温度的要求,同时使微细粉尘荷电凝聚,提高了后续袋式除尘器对颗粒的捕集效率,并降低了袋式除尘器的阻力损失。改造后的系统运行稳定,烟气出口排放浓度满足国家环保要求。     

鸟粪石法回收养猪废水中磷时pH对沉淀物组分的影响

采用鸟粪石沉淀法对养猪废水中的磷进行回收,应用红外光谱和X射线衍射法,并结合物料衡算研究pH变化对沉淀物组分的影响.结果表明,当pH由8.0升至9.0时,磷去除率从85%增加到94%;pH在9.0～11.0范围,磷去除率稳定在94%左右;当pH升高至12.0,磷去除率急剧下降至70％.沉淀物组分为鸟粪石(MgNH₄PO₄·6H₂O)、 钾型鸟粪石(MgKPO₄·6H₂O)、 Ca₃(PO₄)₂·xH₂O和Mg(OH)₂,不含有硫酸盐和碳酸盐.当pH<9.0,沉淀物组分主要为鸟粪石;pH在9.0～10.0范围时,鸟粪石含量降低,钾型鸟粪石、 Ca₃(PO₄)₂·xH₂O含量呈逐渐增加趋势;pH由10.0升至12.0时,鸟粪石含量急剧下降,Ca₃(PO₄)₂·xH₂O和Mg(OH)₂含量快速增加,而钾型鸟粪石快速增加并在pH 11.0达到最大后急剧下降.因此,回收养猪废水中的磷时要获得纯度高的鸟粪石产品,pH值应控制在8.0～9.0.     

硫酸铝渣和硫铁矿烧渣制聚硅酸硫酸铁的研究

研究硫酸铝渣和硫铁矿烧渣制聚硅酸硫酸铁的工艺流程及其主要参数.提取硫酸铝渣中的SiO2得到Na2SiO3溶液,提取硫铁矿烧渣中铁得到FeSO4结晶.用FeSO4结晶制备聚合硫酸铁.用含3.5% SiO2的Na2SiO3溶液,控制pH=4.0,制得聚硅酸,将聚合硫酸铁加入聚硅酸制得聚硅酸硫酸铁絮凝剂.红外光谱分析表明,聚硅酸硫酸铁结合了SO2-4.检测了聚硅酸硫酸铁对模拟浊水和垃圾填埋场渗滤液的絮凝效果,用铁和硅物质的量比为0.5、用量0.5 mL/L的聚硅酸硫酸铁,处理模拟浊水,除浊率可达90%以上.用铁和硅物质的量比为1.5、用量4.0 mL/L的聚硅酸硫酸铁处理垃圾填埋场渗滤液生化处理尾水,CODCr去除率可达60%.     

Effect of chemical and thermal activations on the properties of rice husk ash-based solidified wastes

Strength development,leachability and microstructure of heavy metals from the solidified waste using synthesis rice husk ash (sRHA) and lime blended at the weight ratio of 1:1 were used as binders.The heavy metal-containing sludge was used at the level of 0 wt.%,30 wt.%,and 50 wt.% dry weight,respectively.The sample specimens with and without 1.5 wt.% of sodium silicate (SiO 2 /Na 2 O=1.0) were cured under the ambient condition and elevated temperature curing at 50°C for 24 hr.Experimental results showed that the introduction of sodium silicate solution and elevated temperature curing to sRHA-based solidified waste containing 30 wt.% of heavy metal sludge gave one day strength of 20 kg/cm 2 compared to 0.9 kg/cm2 for the control sample.XRD patterns indicated that most metal-sulfides present in the sludge were appeared in the solidified waste and SEM coupled with EDX techniques reveal these metal-sulfide particles were trapped within the lime-sRHA matrices.In addition,cumulative leaching behavior by tank test (EA NEN 7375:2004) showed that solidified waste containing up to 30 wt.% of heavy metal sludge was suitable to dispose in a secured landfill.     

钙基脱硫剂孔隙网络动态生成特性

钙基脱硫剂孔隙结构特性直接影响到脱硫效果及脱硫剂的利用率,对其空间网络特性的描述将有助于分析SO2的扩散及反应特性. 在石灰石分解动力学和烧结机理的基础上,结合固体分解的成核机理,运用Monte-Carlo 方法,建立了脱硫剂孔隙网络的动态生成模型,对钙基脱硫剂分解形成的孔隙结构进行了动态模拟,并对生成孔结构的分形特性进行研究.结果表明,运用动态生成模型,可以给出石灰石分解形成的CaO内部孔隙的微观空间结构,且模拟生成的孔隙网络的分形维数与实验测定值基本吻合.     

Mechanism of calcium mitigating membrane fouling in submerged membrane bioreactors

Two parallel membrane bioreactors (MBRs) were operated under different calcium dosages (168.5, 27 mg/L) to gain a better understanding of the mechanism of retarding membrane fouling by adding calcium. The results showed that the particle size of sludge flocs increased and the particle size distribution tended to be narrow at the optimum dosage (168.5 mg/L). Calcium was effective in decreasing loosely bound extracellular polymeric substances (LB-EPS) in microbial flocs and soluble microbial products (SMP) in the supernatant at the dosage of 168.5 mg/L by strengthening the neutralization and bridging of EPS with flocs. Furthermore, the amount of COD_S and COD_C decreased in both the mixed liquor and the fouling cake layer on the membrane surface. In order to compare the filtration characteristics of cake layers from the MBRs with the two calcium dosages, the specific cake resistance and the compressibility coefficient were measured. The specific cake resistance from the MBR with optimum dosage (168.5 mg/L) was distinctly lower than that with low dosage (27 mg/L). The compressibility coefficient of the cake layers under two dosages were respectively attained as 0.65, 0.91. Scanning electron microscopy (SEM) and three-dimensional confocal scanning laser microscope analysis (CLSM) images were utilized to observe the gel layer directly.     

钙镁磷肥生产富氧空气助燃节能可行性分析

介绍了钙镁磷肥传统生产方法,分析了钙镁磷肥高炉富氧空气助燃的可行性,认为该方法可行。     

钠钙交换体对心肌保护作用的研究进展

心肌钠钙交换体是引起胞内钙超载的重要原因.简要综述了钠钙交换体的的结构特征、生理功能、病理作用以及在心肌保护方面的研究新进展.NCX反向转运的激活可能是心肌缺血预适应产生心脏保护作用的机制之一.