考虑岩石抗拉强度受围压影响的地层破裂压模型

预测地层破裂压力是地下流体注入工程中的关键问题，关系到工程的稳定性和安全性。根据地测资料，岩石的抗拉强度会随着围压产生变化，然而目前常见的地层破裂压预测模型均未考虑该因素。基于厚壁圆筒法，针对2种砂岩开展不同围压条件下的砂岩致裂试验，根据试验数据，计算各组试验中试样的抗拉强度，并拟合围压与岩石抗拉强度的关系函数。研究岩石抗拉强度随围压变化的规律，提出能在实际地层中表征该规律的参数，基于该参数对现有的地层破裂压模型进行修正，并结合实测数据验证修正模型的可靠性。研究结果表明:岩石的抗拉强度随着围压的增加呈现明显的线性正相关关系，低围压下，新模型的预测结果与实测数据较为接近。随着围压增加，二者的差异逐渐增大，说明选取的特征参数在低围压下能较好地描述抗拉强度受围压的影响效应，而高围压下参数的取值需进一步研究。     

煤对CO2，N2和CH4的吸附速率经验公式与异同性研究*

为了解决吸附速率拟合公式缺乏而解吸经验公式众多的问题，通过替换解吸参数、定性和对比分析各经验公式对煤吸附CO₂，N₂，CH₄吸附速率的适用性，选取4种不同煤质的煤样在0.5，1.0和2.0 MPa下进行定温吸附实验，分析压力和煤质对吸附速率的影响规律。研究结果表明:时间函数式对3种气体在不同压力和煤质下的吸附速率拟合效果最佳；压力和煤质对3种气体吸附速率的影响既存在共性又具有差异性，气体吸附速率与压力符合指数函数关系，与挥发分呈现出二次函数关系，并且压力升高会导致最低吸附速率趋向于较高变质程度煤样；CH₄和N₂的吸附速率随压力升高而升高，而CO₂的吸附速率因煤样而不同，且在同压下，不同气体的最高和最低吸附速率煤样的变质程度也不同。     

不同类型活性炭处理废水中重金属离子的研究进展

重金属对人体的显著毒性和难降解的特性,使重金属水体污染成为全球性关注的环境问题。本文综述了重金属废水的危害、来源及常用处理方法,比较了不同类型活性炭处理废水中重金属离子的差异,阐述了不同类型活性炭处理技术的优势和特点,并对今后的重金属废水处理技术研究方向进行了展望。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

三维电极电Fenton氧化法处理染料废水

采用三维电极电Fenton氧化法处理实际染料废水,探究了染料废水处理效果的影响因素。实验结果表明：以钌铱镀层钛电极为阳极、不锈钢板为阴极、粉末活性炭为颗粒电极,在粉末活性炭投加量为2.0 g/L、电流密度为0.5 mA/mm²、极板间距为3 cm、pH为2.0、硫酸亚铁投加量为0.50 g/L的最优工艺条件下,反应2 h后COD、TOC、氨氮、色度的去除率达到最大,分别为62.80%、41.15%、42.48%和95.00%;粉末活性炭作为颗粒电极可使染料废水COD去除率提高18个百分点;重复使用10次的处理效果与第2次基本持平。     

Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

CeO2/TiO2纳米管催化剂脱硝性能研究

利用废气中本身含有的CO催化还原烟气中的NO_x,可以实现以废治废。采用TiO₂纳米管负载CeO₂,制备CeO₂/TiO₂纳米管催化剂,并对其进行了SEM表征及影响因素实验。实验结果表明：在n（Ce）∶n（Ti）=3∶7、焙烧温度500 ℃、焙烧时间3 h时制备的CeO₂/TiO₂纳米管催化剂形貌较好,表面颗粒分布相对均匀;反应温度400~600 ℃时NO脱除率达98%;该催化剂具有一定的抗氧性能;当n（SO₂）∶n（NO）=（1∶2）~（2∶1）时,NO脱除率仍然在95%以上。     

初始温度和压力对排污空间甲烷-空气混合物爆燃特性影响的模拟研究

市政排污空间作为城市公共基础设施的重要组成部分，易积聚可燃气体形成爆炸性环境。结合排污空间的特殊环境条件，采用Fluidyn-MP多物理场数值模拟软件，建立了20 L球形爆炸罐分析模型，通过改变初始温度和初始压力，对排污空间甲烷-空气混合物爆燃特性及其变化规律进行模拟研究。结果表明:初始温度升高导致甲烷-空气混合物最大爆炸压力降低，缩短了到达最大爆炸压力的时间；初始压力增加导致最大爆炸压力急剧升高，并延长了到达最大爆炸压力的时间；最大爆炸压力对初始压力的敏感程度远大于初始温度的影响。此外，随着初始温度和初始压力的升高，爆炸火焰平均传播速度增加，而火焰传播速度对初始温度较敏感。