响应面法优化预氧化强化混凝处理铁锰地下水

以KMnO_4为氧化剂,Al_2(SO_4)_3·18H_2O为混凝剂,含铁锰离子地下水为模拟用水,考察预氧化强化混凝法的效果。利用响应面设计试验,分析氧化剂投加量、混凝剂投加量和pH值对铁锰去除的交互作用。模型优化结果显示,在氧化剂投加量4.16 mg/L,混凝剂投加量263.68 mg/L,pH值为7.54的最佳工艺参数下,铁锰去除率分别可达98.22%和97.49%。     

高锰酸钾强化PAC混凝处理温瑞塘河黑臭水体试验研究

以浙江省温州市温瑞塘河某河段黑臭地表水为研究对象,考察高锰酸钾强化PAC混凝工艺的除污效能,获得处理温瑞塘河黑臭水体的最佳工艺条件,为恢复河流水体生态自净功能提供基础。试验结果表明,高锰酸钾的最优投加方式为在混凝剂PAC前投加,最佳预氧化时间5 min,最佳投加量1.5 mg/L。将本实验得出的最优混凝处理条件应用于温瑞塘河实际黑臭水体的处理时发现,处理后水质明显改善,此表明高锰酸钾强化混凝应急处理温瑞塘河黑臭水体是切实可行的,可为实际的应急处理工艺提供了理论依据和技术指导。     

舟山高浊度海水混凝除浊研究

测定了舟山高浊度海水悬浮物的粒度分布,分析了高浊度海水自由沉降特性,选用氯化铁(FeCl)3、聚合氯化铁(PFC)、聚合硫酸铁(PFS)3种混凝剂,利用正交试验方法对高浊度海水进行混凝沉淀对比试验,采用极差分析方法研究了影响混凝效果的因素。试验结果表明:舟山海域悬浮物组成以粉砂为主,用自然沉降的方法是很难去除;各因素对浊度去除率影响的主次顺序均为:慢搅时间>慢搅速度>快搅时间>快搅速度;对于高浊度海水混凝除浊最佳水力条件为:快搅时间为2 min,快搅速度为300 r/min,慢搅时间为15 min,慢搅速度为60 r/min;聚合硫酸铁是较理想的絮凝剂,最佳投药量范围在15～25 mg/L,对浊度去除率高达99%以上。     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

混凝气浮对还原深蓝BO脱色的实验研究

实验研究了混凝气浮对还原深蓝BO脱色的几个影响因素:pH值、硫酸铝钾用量、十二烷基硫酸钠用量、气浮时间;对比了混凝沉淀和混凝气浮对还原深蓝BO的脱色处理效果。结果表明:pH值对混凝气浮处理效果影响最大,硫酸铝钾用量、十二烷基硫酸钠用量及气浮时间对混凝气浮处理效果有一定影响;当pH值为5.00、硫酸铝钾用量为556mg/L、十二烷基硫酸钠用量为20mg/L、气浮时间为5min时,还原深蓝BO混凝气浮的色度和吸光度去除率分别为99.4%和85.44%;气浮对还原深蓝BO的进一步去除有一定作用。     

高浓度服装水洗废水的混凝处理研究

采用化学混凝法,以PAC为混凝剂,PAM为助凝剂,对高浓度服装水洗废水进行处理研究。考察了溶液的pH值、PAC的投加量、PAM的用量等因素对脱色率及COD去除率的影响,得到最佳工艺条件为:pH为8.0左右,PAC投加量为25mL/L(废水),PAM的投加量为1.0mL/L(废水)。在此条件下,服装水洗废水的脱色率为73.1%,COD的去除率为72.1%。     

强化混凝去除微污染湖泊水浊度及TOC的研究

通过烧杯混凝试验和动态连续混凝试验,就混凝剂种类、投药量、pH值、水温等因素,研究强化混凝对水中浊度和TOC去除效果的影响。试验结果表明:PAC最佳投量为30mg/L,浊度去除率为90.19%,TOC去除率为38.2%,水温高于20℃时,聚合氯化铝对浊度和TOC去除率分别高达84.95%、33.18%以上。虽然pH值是影响有机物去除的主要参数,动态连续混凝试验表明,不改变pH值,强化混凝工艺依然能极大地改善出水水质,滤后水质浊度为0.1NTU,TOC为6.23mg/L。     

废纸造纸废水处理工程的设计与运行

文章针对废纸造纸生产中废水产生量大,SS、COD浓度较高的问题,将废纸造纸废水处理工程实践中的污水作为对象,研究一套废纸造纸废水回收利用的污水处理方法,减少再生纸造纸工业对环境的污染。实验结果和工程实践证明:利用混凝沉淀—活性污泥相结合工艺处理废纸造纸废水,达到一部分经物理处理后回收利用,一部分经生化处理后达标排放。采用该工艺处理效果好,SS去除率达99.7%、COD去除率达98.4%,且运行稳定,成本和一次性投资均较低,其排放废水水质满足《造纸工业水污染物排放标准》(GB3544-2001)中的排放要求。     

微旋涡无级变速反应沉淀器技术探讨

基于混凝沉淀的基础理论,结合现有絮凝沉淀池的优点,通过对反应沉淀器核心结构的升级改造及搅拌系统的优化设计,开发了微旋涡无级变速反应器。该反应器集混合、絮凝、固液分离于一体,可创造微涡流与切向流相结合的优良水力条件,结构紧凑,能耗节约。