一株耐盐柴油降解菌的分离鉴定及其降解性能

从某油田附近受石油污染土壤中分离出一株以柴油为惟一碳源的耐盐菌株LS1。通过对菌株的生理生化特性、菌体的形态观察及16S r DNA基因序列分析鉴定菌株LS1为假单胞菌属(pseudomonas)。该菌株可耐受的最高盐度(Na Cl)和柴油浓度分别为6%~8%和12 000 mg/L。菌株生长的适宜p H和温度条件分别为6.0~8.0和28~36℃。在盐度为6%、p H为7.0、温度为32℃、菌种投加量为10%的条件下,初始浓度为3 000 mg/L的柴油经6 d降解后,去除率可达78.3%,加入适量外加碳源葡萄糖和蔗糖,可使降解率分别提高至92%和90%左右。菌株LS1的耐盐机理可能是通过在细胞内积累甜菜碱以调节菌株细胞内外渗透压平衡。投加甜菜碱可提高耐盐菌LS1在高盐环境下对柴油的降解效率。     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.     

LNAPL在砂质含水层中动态迁移的电阻率法监测试验研究

在海滨潮间带采集细砂,通过室内柴油泄漏模拟试验,利用自制电阻率监测系统对轻非水相液体在砂土-地下水系统垂向渗透过程进行电阻率变化动态监测;通过配制不同含油率砂土测定其静态电阻率变化规律,探讨电阻率变化的影响因素;最后取样分析测定污染含水介质稳定后含水率及含油率,对监测结果有效性进行了验证;并利用显微成像法对污染砂土进行了微观形态分析.结果表明,柴油污染砂土微观形态上胶结现象明显;柴油渗透海滨砂土过程电阻率大小同含水饱和度,比电阻率和含油饱和度之间存在良好的相关性,均可用Archie公式拟合,n值分别为2.36和0.15;通过电阻率测定可以有效估算柴油透镜体厚度;电阻率随深度的变化可以反映含油率和含水率的垂向分布.本研究为轻质油品储罐或者海上油品输运过程泄露造成的海滨砂土地下污染扩散过程监测及机制研究提供了一种有效的方法,也可为其他典型石油泄漏污染场地的电阻率法探测或监测提供参考.     

Cu-K型低温碳烟氧化催化剂的合成及表征

柴油机排放中碳烟的低温氧化是近年来研究的热点.通过原位合成法制备Cu2K/Al2O3和CuK／Al2O3两种碳烟氧化催化剂,并采用低温氮吸附/脱附实验、X射线衍射、X射线光电子能谱、程序升温氧化对其结构进行系统表征,并用U碳模拟柴油机碳烟,研究其催化活性,评测其对柴油机排气中碳烟颗粒的净化效果.研究表明,Cu2K/Al...     

重型柴油车车载排放实测与加载影响研究

采用车载排放测试仪,对2辆重型柴油卡车在空载和加载条件下进行实际道路车载排放测试.通过分析获得了油耗与排放速率的速度-加速度及其工况点的分布,发现高油耗与高排放工况点主要集中在高速加速区域,加载时油耗与排放高值随工况点分布更广;车辆在(30±2.5)km·h^-1等速及加速行驶时受加载影响最大,此时加载油耗与排放约是空载的1.6～3.2倍左右;由实测结果发现,卡车Ⅰ和卡车Ⅱ加载时油耗及CO、HC、NO_x排放因子分别是空载的1.6倍、3.5倍、1.1倍、1.5倍以及1.2倍、1.0倍、0.9倍和1.5倍,加载对油耗与NO_x排放影响最为明显,对HC影响最小,CO影响取决于车辆保养水平;卡车Ⅱ较卡车Ⅰ车型更大,发动机功率更高,相同荷载时受加载影响较小,说明重型车在发动机负荷可承受的范围内合理装载,有助于避免油耗与排放恶化,提高燃油经济性和排放水平.     

电动增压补气消除柴油机瞬态加速冒烟的试验

将自行开发的、适用车载24V电源的电动增压补气系统在一台490QDI柴油机上进行了实验研究.实验工况包括起始负荷分别为0和40N.m的加载加速的瞬态工况以及1400r·min-1、60N·m,1600 r·min-1、90N-m和1800 r.min-1、120N·m 3种低转速、大扭矩稳态工况,针对以上工况分别进行了有无电动增压补气的实验.试验结果表明,有电动增压补气的柴油机同原机相比,零负荷加载加速时的微粒排放降低达70%以上,瞬间输出功率最大可提高54.5%;在稳态工况时,HC、CO排放都随着电机转速的升高而降低,最大减少量分别达到66.7%和75.O%;波许烟度平均减小50%以上.此外,加速补气对提高燃油经济性也有一定效果,比油耗最大能降低7.46%.     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

柴油低温临界吸收法回收装车挥发油气

研究了采用柴油低温临界吸收法回收装车挥发油气的效果。实验结果表明：按装车挥发油气中的总烃体积分数为20.88%、装车挥发油气流量为280 m³/h、年运行时间为2 668 h计，装置年回收油气量为291 t，装置年最大运行功率为206.770 MW，装置投资回收期为3 a;处理后净化气中的总烃体积分数为1.24%，排放质量浓度低于25 g/m³，油气回收率达95%。处理后净化气满足GB 20950—2007《储油库大气污染物排放标准》，取得了较好的环保效益和经济效益。     

柴油机冷起动辅助措施的匹配优化试验研究

重点论述了柴油机冷启动辅助装置燃油加热器的选型试验。对燃油加热器优劣的评价指标进行了分析研究,提出了燃油加热器的评价方法。最后通过样本CFD分析,优化了燃油加热器与发动机之间水路系统的匹配,实际效果进行了试验验证。