Biohythane production from pineapple peel using Methanosarcina mazei enhanced with palm oil mill effluent (POME) sludge in single-stage anaerobic digestion

Biohythane production via single-stage anaerobic digestion (AD) is an effective way for sustainable energy recovery from lignocellulosic biomass. In this paper, biohythane was produced through the AD process from pineapple peel waste substrate using purely cultured Methanosarcina mazei with the enhancement of palm oil mill effluent (POME) sludge as the inoculum. This study focuses on the effects of the lignocellulosic pre-treatment method, the addition of POME sludge into M. mazei culture medium as inoculum, and various operational conditions (food to microorganisms (F/M) ratios, temperature, pH) on gas production performances. The experimental results indicate that these parameters influenced the efficiency of biohythane production by producing the peak maximum biohythane production rate values (HPR_max) and (MPR_max), H₂:CH₄ = 1.93:0.67 L/L-d, and biohythane yield (HY) and (MY), H₂:CH₄ = 1.18:0.55 mL/L-substrate. This study demonstrates that biohythane gas (H₂ + CH₄ + CO₂) production from pineapple waste can be accelerated by M. mazei only with the enhancement of POME sludge through single-stage AD system under mesophilic batch process conditions.     

除镉最佳混凝剂的筛选及应用条件研究

通过采用聚合氯化铝铁（PAFC）、氯化铁（FeCl3）及聚合硫酸铁（PFS）对含镉废水的处理研究表明,三种混凝剂对含镉水体均有良好的处理效果,同等条件下,三种混凝剂对含镉水体去除率分别为98.22%、92.19%和93.63%。研究了PAFC对含镉水体的混凝沉淀效果,实验结果表明：碱性条件有利于镉离子的沉淀,当pH为9～11时,去除率可达98.00%左右;对于初始浓度为4.000 0 mg.L-1的含镉废水,经处理后,水体浓度可降至0.184 0 mg.L-1,对于初始浓度为0.400 0 mg.L-1的含镉废水,经处理后水体浓度降至0.007 2 mg.L-1;废水中投加一定量的石灰乳对PAFC除镉起一定的作用,投加量达30.00 mg.L-1时,其去除率达99.91%;通过对PAFC除镉动力学拟合,符合一级线性动力学方程。     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

Degradation kinetics and mechanism of aniline by heat-assisted persulfate oxidation

Oxidation of aniline by persulfate in aqueous solutions was investigated and the reaction kinetic rates under different temperature, persulfate concentration and pH conditions were examined in batch experiments. The results showed that, the aniline degradation followed pseudo first-order reaction model. Aniline degradation rate increased with increasing temperature or persulfate concentration. In the pH range of 3 to 11, a low aniline degradation rate was obtained at strong acid system (pH 3), while a high degradation rate was achieved at strong alkalinity (pH 11). Maximum aniline degradation occurred at pH 7 when the solution was in a weak level of acid and alkalinity (pH 5, 7 and 9). Produced intermediates during the oxidation process were identified using liquid chromatography-mass spectrometry technology. And nitrobenzene, 4-4’-diaminodiphenyl and 1-hydroxy-1,2-diphenylhydrazine have been identified as the major intermediates of aniline oxidation by persulfate and the degradation mechanism of aniline was also tentatively proposed.     

UV/H2O2氧化微囊藻毒素-LR的动力学模型

介绍了一种UV/H2O2光氧化体系降解微囊藻毒素MC-LR的动力学模型.根据UV光分解、H2O2和·OH氧化MC-LR的反应以及稳态近似法,导出了MC-LR降解的动力学方程.解释了体系中H2O2、HO-2、CO23-、HCO-3等对降解MC-LR动力学的影响.实验结果表明,在一定的光强和H2O2浓度情况下,由于反应产生的CO23-、HCO-3和HO-2等离子的影响,UV/H2O2光氧化MC-LR的过程只能近似用准一级动力学方程描述.     

光合细菌黑暗好氧降解2-氯酚的特性研究

研究了光合细菌PSB-1D在黑暗好氧条件下处理2-氯苯酚时的降解规律和影响因素。考察了不同培养时间、碳源、氮源、初始pH值、PSB-1D接种量、摇床转速、不同初始2-氯苯酚浓度等因素对PSB-1D生长和2-氯苯酚处理效果的影响。结果表明:以葡萄糖、硫酸铵和酵母膏作为最佳碳氮营养源,初始pH值为7.0、接种量为10%、摇床转速为130r/min为最佳工艺条件,在此条件下PSB-1D处理2-氯苯酚降解率可达61.50%。黑暗好氧条件下光合细菌PSB-1D降解2-氯苯酚的规律符合一级降解动力学模型。随着初始2-氯苯酚的浓度逐渐由20mg/L提高到150mg/L,半衰期由39.36h延长为92.88h,也即2-氯苯酚浓度越高,降解所需的时间越长,降解速率常数Kb亦逐渐减小,由0.01754mg(/L·h)降到0.007458mg(/L·h)。     

紫外光降解反应器去除氯苯气体模型的建立与应用

从光化学反应过程出发,基于线性光源球面辐射能量分布（LSSE）,以反应器内部空间的辐射能吸收密度、空塔停留时间、进口浓度等为主要参数,建立了气相环境中紫外光化学反应器去除氯苯的数学模型.结果表明,建立的模型能很好地模拟和预测紫外光化学反应器对氯苯气体的去除性能.氯苯气体的紫外光化学反应表现出一级反应动力学的特征.该模型包含了紫外光降解反应器设计的主要参数,同时被用于预测了反应器在不同进口浓度和不同空塔停留时间条件下的出口氯苯浓度,进而获得不同进口浓度达标排放所需要的最小空塔停留时间,为气相污染物的紫外光降解反应器的设计与运行提供了重要的理论指导.     

中国南方森林黄壤的铝活化模式

将酸化模型应用于我国区域酸沉降影响的预测和控制对策的制定,需要选择有区域代表性的土壤铝活化模式并确定其参数.利用我国南方4个森林小流域的土壤化学长期观测资料,对常见的铝活化模式,如三水铝石模式、斜矾石模式、高岭石模式、伊毛缟石模式和有机质吸附模式等在中国南方森林黄壤的区域适用性进行了分析.结果表明,广泛应用于各种酸化模型的三水铝石模式实际上并不适用,而修正后的三水铝石经验模式在土壤水pH值≥4时能够适用,经验常数可取pK=-2.40、 a=1.65（上层土壤）和pK=-2.82、a=1.66（下层土壤）.其他模式与经验三水铝石模式相比,模拟性能并无明显的改善.观测结果还表明,当pH<4时,pAl不随pH明显变化,这些模式均不能解释其机制.     

黄绵土N2O排放的水分效应及动力学特征

通过室内模拟试验,研究湿度对西北地区黄绵土N2O排放的影响.结果表明:在试验温度下,随着土壤湿度增加,土壤N2O捧放量增加;但土壤孔隙含水量(WFPS)为20.67%时例外.此时黄绵土对空气中N2O有吸附现象,即在低含水量时,黄绵土有可能是N2O的汇.在试验设计的土壤湿度范围内,15℃条件下土壤N2O排放的最大水分效应区间在49.18%～57.86%(WFPS)之间,20℃条件下在38.14%～49.18%(WFPS)之间,25℃、30℃和35℃时累积量湿区在20.67%～38.14%(WFPS)之间,即随着温度的升高,N2O的最大水分效应区间提前.土壤N2O累积排放量(y)动力学曲线符合修正的Elovich方程(P<0.01),随着湿度的增加,表观排放速率(b)增大,25℃、300C和35℃时,N2O初始排放量(a)也随着湿度增加而增大;15℃、20℃和25℃时,土壤湿度(20.67%～57.86%WFPS)对农田土样N2O排放总量的作用表现为线性关系,30℃和35℃时表现为对数关系.     

反相流动注射催化动力学分光光度法测定海水中的痕量Cu

在弱碱性的介质中,Cu能够对H2O2氧化对苯二酚的反应起到明显的催化作用,反应产物在500 nm波长处有最大吸收峰.据此,发展了一种反相流动注射催化动力学分光光度法测定海水痕量Cu的新方法.在最佳条件下,Cu2+的浓度在0～40 μg/L具有良好的线性关系,相关系数0.9993,检出限为0.2 μg/L,回收率为98.7%～104.2%,用5 μg/L标准溶液进样的相对标准偏差为1.03%(n=10).