高烈度地震区隧道软硬围岩交接段刚柔并济抗减震技术研究*

为提高高烈度地震区隧道抗震性能，以某铁路隧道为研究背景，分析3种抗减震措施下隧道不同监测点隧道拱顶沉降、边墙收敛、衬砌结构PGA及最小安全系数，通过对比分析得到最优抗减震措施。结果表明:相比于工况1，工况2隧道拱顶沉降减小10.54%~81.10%，边墙收敛减小13.92%~78.77%，衬砌结构PGA减小31.42%~72.02%，最小安全系数增加18.04%~66.13%；相比于工况1，工况3结构拱顶沉降减小3.04%~18.02%，边墙收敛减小4.70%~32.00%，PGA增加13.95%~27.48%，最小安全系数增加7.49%~30.99%；工况4即“减震层+SFRC衬砌”刚柔并济法，相比于工况1，隧道拱顶沉降减小18.46%~83.98%，结构边墙收敛减小17.54%~85.47%，PGA减小30.00%~69.98%，最小安全系数增加47.95%~83.56%；4种工况抗减震性能由高到低依次为:工况4＞工况2＞工况3＞工况1。研究结果可为隧道软硬围岩交接段抗震设防提供理论参考。     

A proactive process risk assessment approach based on job hazard analysis and resilient engineering

Complex systems often experience a long period of incubation before accidents occur. Therefore, a proactive risk assessment is essential for process safety. The conventional job hazard analysis (JHA) method has been an effective tool to conduct a process risk assessment in the high-risk industrial field. However, the conventional JHA is inadequate for the proactive risk assessment since it is usually conducted during and before one specific operation process. Operations such as startup and maintenance are performed repeatedly on the lifecycle of a plant. Therefore, the risk reduction measures for the industrial process should include not only preventive actions obtained from the conventional JHA but also recovery ones. Resilience engineering (RE) has proven to be helpful for the recovery analysis of a complex system. The objective of this paper is to propose a proactive and comprehensive process risk assessment approach based on JHA and RE. The mechanism of applying RE to address operation process risk is illustrated. The integrated approach can provide guidelines to establish proactive risk reduction measures as well as maintain a low-risk level. Finally, a gas transmission startup process risk assessment case is presented to demonstrate its applicability.     

A new baseline model for estimating willingness to pay from discrete choice models

We show a substantive problem exists with the widely-used ratio of coefficients approach to calculating willingness to pay (WTP) from discrete choice models. The correctly calculated standard error for WTP using this approach is shown to be undefined. This occurs because the cost parameter's standard error implies some possibility the true parameter value is arbitrarily close to zero. We propose a simple yet elegant way to overcome this problem by reparameterizing the (negative) cost variable's coefficient using an exponential transformation to enforce the theoretically correct positive coefficient. With it the confidence interval for WTP is now finite and well behaved.     

Climate engineering and human rights

ABSTRACT

In this Forum, three scholars discuss how climate engineering will pose novel human rights challenges, and may well force reconsideration of how human rights are applied as a guide to action. Following a short introduction, the first section introduces three competing approaches to human rights, arguing views which emphasize fairness or attempt to maximize satisfaction are more promising than one viewing human rights as inviolable ‘side-constraints’. The second section draws lessons from climate migration that are relevant for climate engineering in terms of incorporating a human rights approach to duties, rights, and participation. The final section compares the ‘needs-based’ and ‘rights-based’ approaches to humanitarian work in the face of climate change and climate engineering, raising concerns for duty-bearers and right-holders. The Forum’s conclusion draws together points of overlap and suggests a path forward for policy and research on this topic.     

济南市空气污染现状及控制对策

利用2013年1—12月济南市大气监测数据,分析该市空气质量现状及时空分布特征,结果表明:2013年济南市空气主要污染物质量浓度均超过《环境空气质量标准》(GB 3095—2012)二级标准限值,空气污染严重时段为冬季采暖期,颗粒物污染严重区域为该市西部和西北部地区,SO2、NO2污染严重区为中心城区,并从点源、面源和移动源3个方面提出相应的污染防治对策。在SO2、NOx和工业烟粉尘分别减排22.5%、18.2%和31.4%的条件下,运用Models-3/CMAQ模型模拟计算得出:2015年1月和7月,济南市空气中SO2、NO2、PM10和PM2.5的质量浓度与2010年同期相比将分别降低23.9%和29.7%、11.4%和15.9%、21.9%和32.6%、13.5%和26.9%,空气质量得到明显改善。     

Double Green Process: a low environmental impact method for recycling of CdTe,a-Si and CIS/CIGS thin-film photovoltaic modules

On the basis of the method for managing the end of life of CdTe photovoltaic panels previously proposed by the authors, a new method for the recycling of all types of thin-film panels (CdTe, a-Si and CIS/CIGS) has been developed and optimised under a research project founded by Enel Foundation and CRUI Foundation. The DGP process has been developed through a feasibility study carried out from three points of view: technical, environmental and economic. The process is composed by two sub-processes matched to each other, one suitable for CdTe panels (named DGPa) and the other one for a-Si and CIS/CIGS panels (DGPb). The Double Green Panel process is based mainly on mechanical treatments with a minimum use of chemicals and it is characterised by a greater level of automation and a high flexibility in production capacity. The potential environmental impacts of various configurations of the DGP process have been extensively analysed with LCA tool in order to develop an environmentally friendly process. The economic feasibility has been assessed through the Discounted Cash Flow Analysis (DCFA) method. The revenues associated to the recovery of valuable and common materials and the recycling costs have been taken into account.     

非柔性连接石化储罐配管温差应力分析与对策

储罐配管在温差作用下产生热位移会导致管壁产生热应力，未采用柔性连接的配管由于热应力集中作用可能发生破漏。针对与石油化工储罐非柔性连接的配管的安全问题，应用ANSYS有限元分析软件模拟计算石化企业典型配管的热应力分布；根据不同类型配管的分析结果，提出了工程技术与管理方面的针对性安全措施。研究结果表明:温差效应对石化储罐配管热应力影响显著，随内外温差的增加，配管应力集中的区域增大，最大热应力值增大；补偿措施能够改善配管的柔性，降低配管应力；约束载荷限制配管热膨胀从而增大配管应力；三通管是多根配管接合的区域，这种复杂管道交汇处会形成明显应力集中。研究结果对于提高石油化工非柔性连接配管安全性有一定的指导意义。     

提高电捕焦油器安全生产运行的措施

简要叙述了电捕焦油器开工以来存在的问题,对电捕捕焦油器不能安全稳定运行的原因进行了分析,并采取改进措施。实践证明,改进工艺技术合理,方法可行,电捕焦油器运行效果达到指标要求。     

矿热炉炉壳安装作业危险性分析

为减少事故损失,必须对矿热炉安装施工危险源进行分析。基于此,对矿热炉安装工序中最重要工序炉壳安装应用作业危险性分析进行分析。将炉壳安装作业分成3大部分,用鱼刺图分析方法进行分析,总结出矿热炉炉壳安装中事故发生的主要原因并提出对策措施,以预防和减少事故的发生。     

包装企业有机废气深度处理技改实例探讨

有机废气的治理方法有很多,应选择合适的治理方法或组合来提高处理效率,来着力改善大气环境质量。以某包装企业有机废气深度处理技术改造项目为实例,探讨采取RTO焚烧法取得的治理效果。