Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

Numerical simulation of far-field blast loads arising from large TNT equivalent explosives

Large TNT equivalent explosions usually arise from accidents occurring during the transportation, storage, and manufacturing of chemicals relevant to process industries. The blast wave generated by the explosion will spread and interact with the surrounding factories and storehouses, damaging the building structures within several kilometers and causing significant casualties and property losses. This study aims to develop an efficient numerical simulation method to predict blast loads to estimate the consequences of accidents involving far-field free air bursts or surface burst explosions. Before its interaction with the interested target, a blast wave is generated in the numerical model by specifying the initial and boundary conditions of the disturbed air. Based on empirical data of incident overpressure, an explicit formula to calculate the air particle velocity is derived from the governing equations of a perfect inviscid gas. A simplified path line method is proposed to calculate the air density. The proposed method is applied to the LS-DYNA CESE solver to simulate the blast loads on building structures in the far field. Validations against empirical data and experiments indicate that the proposed method is sufficiently accurate for engineering applications and, through a case study, presents a more efficient performance than the LOAD_BLAST_ENHANCED (LBE) and mapping methods.     

旋流气浮除油装置预处理含油污水

在河南油田开展旋流气浮除油装置的现场试验,考察进水流量和曝气量对旋流气浮除油装置除油效果的影响。试验结果表明:在进水流量为1.8 m³/h、曝气量为0.5 L/min时,除油率最高达到96.03%;在不添加任何药剂的条件下,装置处理效果稳定;连续运行6 d内,进水含油量为174.57~1 193.15 mg/L时,出水含油量可以保持在137.38 mg/L以下,除油率为58.58%~94.53%。     

A new baseline model for estimating willingness to pay from discrete choice models

We show a substantive problem exists with the widely-used ratio of coefficients approach to calculating willingness to pay (WTP) from discrete choice models. The correctly calculated standard error for WTP using this approach is shown to be undefined. This occurs because the cost parameter's standard error implies some possibility the true parameter value is arbitrarily close to zero. We propose a simple yet elegant way to overcome this problem by reparameterizing the (negative) cost variable's coefficient using an exponential transformation to enforce the theoretically correct positive coefficient. With it the confidence interval for WTP is now finite and well behaved.     

引水放流方式对太湖贡湖示范区水质的影响

基于国家水专项太湖贡湖湾示范区水质水量调控的需求,构建了示范区的等比例缩放实体模型。通过研究模型中4种不同调水方案的效果,为示范区调水技术的比较与选择提供决策依据。研究中,通过测定模型中5个断面的流场数据,判断引水方式对模型流场的影响,以此评价不同调水方案效果。同时以墨汁作为示踪剂,通过不同引水放流方式下示踪剂的扩散场变化,验证不同断面流速测定对整个区域流场判断的准确性,从而分析引水放流方式对水质的影响。     

化学环境下的应力-渗流耦合对尾 矿库稳定性影响试验

通过扫描电镜（FE-SEM）、能谱分析（EDX）、X射线衍射（XRD）、LMS-30激光粒度分析等室内试验探究了尾矿库内存在的酸、碱离子对尾矿颗粒的沉降、微观形貌、物质组成以及粒径级配的影响；建立酸、碱影响下的孔隙比与渗透系数的数学关系模型，并将建立的模型用来表征尾矿库内的应力渗-流场两场耦合机制，实现代入有限元计算软件的目的。结果表明:化学因素的存在影响着尾矿颗粒的多项性状，酸性环境下尾矿颗粒发生溶蚀，部分金属元素流失；碱性环境下尾矿颗粒间生成胶结物质，孔隙出现以含氢氧化铁为主的絮状、团簇状堵塞物，改变了渗流速度；尾矿库内浸润线高度在碱性、中性、酸性环境下依次降低，而渗流速度依次升高。     

Multi-stakeholder collaboration in community post-disaster reconstruction: case study from the Longmen Shan Fault area in China

While multi-stakeholder collaboration is critical for effective community post-disaster reconstruction (CPDR), it is often very difficult in practice. The Longmen Shan Fault active seismic zone in China has experienced several recent earthquakes with the 2008 Wenchuan earthquake and 2013 Lushan earthquake, both of which caused extensive and widespread damage to many communities, presenting unprecedented challenges for post-disaster reconstruction. This paper develops a multi-cycle field research method that involves three interconnected cycles: internet research, field visits, and extensive surveys: to examine multi-stakeholder collaboration for the CPDR following the Wenchuan earthquake. It was found that there were 12 types of active stakeholders engaged across four main areas: infrastructure rebuilding, psychological recovery, socio-economic rehabilitation, and ecological restoration. Specifically, local community participation and effective collaboration between the community and the external stakeholders were found to be the most crucial elements for successful reconstruction. Multi-stage field research after the Lushan earthquake verified that CPDR was effective and that multi-stakeholder collaboration had improved from the lessons learnt from the Wenchuan earthquake reconstruction experience. Some advantages and limitations of this research are also given.     

均匀流场水平潜流人工湿地对四环素类抗生素的去除效果

利用均匀流场水平潜流人工湿地实验系统处理含四环素类抗生素废水,考察了湿地系统对抗生素的去除率、出水口差向代谢产物的含量以及抗生素在湿地植物中的累积情况。实验结果表明:在水力停留时间为2 d、土霉素、四环素、金霉素和强力霉素进水质量浓度均为200 μg/L时,出水中上述4种抗生素的平均去除率分别为98.62%、93.06%、99.13%和92.25%;出水可检出3种四环素类抗生素代谢产物,分别为差向土霉素、差向金霉素和差向四环素,质量浓度分别为(3.69±0.23) μg/L、(13.81±0.47) μg/L和(19.00±0.63) μg/L;湿地植物美人蕉的根、茎、叶中可以检测到土霉素和四环素,四环素含量的大小顺序为茎>根>叶。     

Study on the dynamic response of polyurea coated steel tank subjected to blast loadings

Steel tanks are widely used in the storage of various chemical liquids, and the blast resistance of the tanks is very important because of the explosiveness of these liquids. To explore a feasible method to improve the blast resistance of steel tanks, the effect of polyurea coating on the blast resistance of steel storage tank is investigated in this paper. The responses of monolithic steel tanks and polyurea coated tanks under blast loads are studied by field blast experiments using TNT explosive, and the results shows that the polyurea layers are effective in reducing the maximum and residual displacements of the tank. Numerical simulations are performed and validated, and the deformation process and stress and strain distribution of the tanks are analyzed accordingly. The increase on the bending moment of the plastic hinge lines of the tanks and the increase of the area density of the cylindrical shell induced by the polyurea layers are believed to be the two main factors contributing to the displacement reduction effect of polyurea in this paper. The validated numerical model is used to study the influence of polyurea layer's thickness on the deflection of the tank, and a nearly inversely proportional relationship between the thickness and the maximum displacement is found. Three deformation modes of the tanks are identified when subjected to blast load with varying intensity and it is found that the displacement reduction effect of polyurea varies in different deformation modes.     

Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.