环状扩散管-分级采样器的建立和细粒子酸性的测定

建立了国内第一台扩散管－分级采样器，用来研究大气气胶溶胶的组成和细粒子的酸性，实验证明该采样系统能够有效地避免大气中的碱性物质对颗粒物采样的干扰。在北京，湖南等地进行了现场实验，测定了气溶胶的酸性。     

双级虚拟撞击采样器应用于固定污染源PM10和PM2.5排放测量

为贯彻落实《大气污染防治行动计划》,环境保护部指导各地开展大气污染源排放清单编制工作,其中包括固定源PM_(10)和PM_(2.5)的排放清单.但目前国内尚无固定源PM_(10)和PM_(2.5)标准采样方法.本研究提出了适合我国固定源PM_(10)和PM_(2.5)测量的双级虚拟撞击采样方法,开发了相应的分级采样系统,并用该方法对各类固定源进行了现场测试.测试结果表明,所测试的煤粉炉电厂的烟囱入口PM_(2.5)质量浓度为(0.93±0.03)mg·m~(-3),PM_(10)质量浓度为(1.13±0.11)mg·m~(-3).所测试的垃圾焚烧电厂的烟囱排放口PM_(2.5)质量浓度为(3.3±0.65)mg·m~(-3),PM_(10)质量浓度为(6.9±0.86)mg·m~(-3).所测试的大型循环流化床发电厂的烟囱排放口PM_(2.5)质量浓度为(0.59±0.04)mg·m~(-3),PM_(10)质量浓度为(1.12±0.16)mg·m~(-3).所测试的钢铁转炉的烟囱排放口PM_(2.5)质量浓度为(0.15±0.04)mg·m~(-3),PM_(10)质量浓度为(0.43±0.15)mg·m~(-3).     

模拟烹饪油烟的粒径分布与扩散

烹饪油烟颗粒物粒径分布与扩散特性研究有助于解析其对室内空气质量和居民健康的影响,采用电子低压撞击器(ELPI)实时监测了油烟机开启和关闭状态下,模拟烹饪油烟发生处和3 m外位置处,0.03~10μm范围内油烟颗粒数浓度和质量浓度随粒径分布.油烟颗粒主要以655 nm以下的细颗粒为主.油烟机能够显著降低室内油烟浓度,开启油烟机后,油烟发生处颗粒数浓度从2.8×106个·cm-3降低到2.3×105个·cm-3,PM2.5(空气动力学直径≤2.5μm的颗粒)质量浓度从85.9 mg·m-3降低到6.2 mg·m-3.油烟机对PM10的净化效率高于PM2.5.油烟迅速从发生处扩散到3 m外,无通风状态下,总颗粒数浓度衰减达65%,PM2.5质量浓度衰减达75%.计算流体动力学(CFD)模拟了油烟机对油烟PM2.5质量浓度场扩散分布影响.红外摄像仪监测了油烟温度场分布扩散,以扇形向外扩散,伴随着油烟温度梯度降低.     

Particle-size distribution and gas/particle partitioning of atmospheric polybrominated diphenyl ethers in urban areas of Greece

Ambient concentrations, gas/particle partitioning and particle-size distribution of polybrominated diphenyl ethers (PBDEs) were investigated in two urban areas (Athens and Heraklion) of Greece. Atmospheric (gas + particle) concentrations of ∑PBDE varied from 21 to 30 pg m⁻³ in the center of Athens and from 4 to 44 pg m⁻³ in the suburbs of Heraklion. A predominance of particulate PBDEs was observed in Athens (71-76% in particles), whereas the opposite was evident in Heraklion (69-92% in gas phase). In both urban areas, PBDE particle-size distribution featured a distinct enrichment in smaller particles. A similar trend was also observed in aerosols of a background marine site. For all sampling sites, more than 46% of ∑PBDE was associated with particles of <0.57 μm in diameter. Our results imply that particulate PBDEs may have long atmospheric residence time and they may be capable of reaching the deeper parts of the human respiratory system.     

广州秋季不同功能区大气颗粒物中PAHs粒径分布

利用MOUDI^TM级联分段式采样器采集了秋季广州市区(荔湾采样点和五山采样点)及郊区(新垦采样点)3个采样点的气溶胶样品并使用GC-MS分析了样品中13种多环芳烃的含量.发现3～4环的多环芳烃呈双峰分布,5～7环的多环芳烃呈单峰分布.广州市区和郊区的多环芳烃具有不同粒径分布模式;相对于城区,郊区的多环芳烃存在于更大的颗粒物中,这可能是气溶胶的陈化过程不同导致的.城区的多环芳烃可能主要受吸附作用控制,而郊区的多环芳烃则可能受多种机制控制,如吸附作用、吸收作用和多层吸附.诊断参数值在粒径1～2.5μm和0.1～0.56μm存在较大差异;从浓度上看新垦13种多环芳烃的总浓度为39ng/m³,五山为71～94ng/m³,荔湾为32～154 ng/m³;从组成上看广州市大气颗粒物种多环芳烃以5～7环为主.     

一种气溶胶测量仪器标定系统的设计及性能评估

对气溶胶测量仪器进行准确标定是保证大气环境及污染源颗粒物测量数据质量的重要前提.本研究搭建了一套多分散在线标定气溶胶测量仪器的系统,该系统采用超声气溶胶发生装置产生多分散颗粒物,并用空气动力学粒径谱仪对颗粒物粒径分布进行测量.评测结果表明该系统干燥腔室内气溶胶稳定、均匀,且符合对数正态分布.以采样器为例,已有研究多使用单分散离线标定方法对采样器切割性能进行标定,该方法操作繁琐、实验周期长.利用多分散在线标定系统对PM_(2.5)和PM_(10)双级虚拟撞击采样器进行标定,并与单分散离线标定方法进行了对比,两套系统的标定结果呈现较好的一致性,但多分散在线方法大大缩短了标定实验周期.     

新型多级冲击采样器切割粒径的标准粒子实验分析

大气溶胶对环境污染、气候变化以及人体健康有着重要的影响,大气溶胶的采集和分析已成为当前大气环境研究领域中的一个重要课题.论述的新型多级冲击采样器能够实现大气溶胶颗粒物按空气动力学粒径的大小7级分离采集,提供大致均匀的平面样品以进行后续的物理、化学分析,同时保证各分级切割粒径的稳定性.利用振动孔溶胶发生器产生均匀、粒径大致相同、单分散相的1.5～17μm空气动力学粒径标准粒子,对新型多级冲击采样器前三级的切割粒径和收集效率进行鉴定性分析实验,结果表明,能够满足对大气溶胶颗粒物分级采集的要求.     

ELPI 测定环境空气 PM2．5的现场比对研究

采用ELPI自动监测方法与手工采样－重量法对环境空气PM2．5监测进行现场比对研究,按照两种方法数据的相对偏差来评价ELPI方法的数据质量。实验结果表明,两种方法数据的相对偏差范围为－12．9％～17．4％,加权平均值为3．0％;相对偏差的绝对值范围为1．1％～17．4％,平均值为9．3％。 ELPI法的数据质量总体较好,方法的准确度尚可。只是随着空气PM2．5浓度测定值的升高,ELPI法与重量法相对偏差的绝对值显著减小,可见,在低浓度下,ELPI法的数据质量相对较差,此时方法的准确度有待进一步验证、提高。     

矩形喷嘴PM2.5惯性冲击采样器的研制

惯性冲击器是最重要的颗粒物采样器之一,被广泛用于大气颗粒物的分级采样。设计了一种中流量的矩形喷嘴PM2.5惯性冲击采样器。根据Marple准则设计了冲击器的结构参数,用CFX软件进行了惯性冲击器内部气固两相流场的CFD模拟,得出了惯性冲击器的最优结构参数。根据得出的最优设计参数,进行了PM2.5惯性冲击器样机的结构设计,并在实验室用APS气溶胶空气动力学粒度仪进行了标定。实验标定和CFD数值模拟的结果基本吻合,当采样流量为100L/min,冲击器的切割粒径dp50=2.55μm,切割锐度σg=1.4,满足设计要求。     

Comprehensive characterization of ambient nanoparticles collected near an industrial science park: Particle size distributions and relationships with environmental factors

We investigated the characteristics of ambient particles and their relationships with various environmental factors, including gaseous pollutants (CH4, non-methane hydrocarbons (NMHC), total hydrocarbons (THC), NOx, CO, SO2), meteorological parameters (humidity, temperature), and time (day/night, workday/weekend). We used an electrical low-pressure cascade impactor to measure the number and size distributions of ambient particles (0.007–10 m) that were collected approximately 1 km northwest of Hsinchu Science Park in Taiwan between February and May 2007. The number concentrations of particles were enhanced through photochemical reactions during the day. In addition, high traffic flow during workdays increased the formation of particulates. Except for SO2, all of the gaseous pollutants we studied (CH4, NMHC, THC, NOx, CO) correlated positively with the total number concentrations of ambient particles during daytime, indicating that they might contribute to the particulate burden. The poorer relationship between the SO2 level and the total number concentration of particles suggests that SO2 might participate indirectly in the nucleation process during particle formation, The high enrichment factors for Zn, Pb, Cu, and Mn, which mostly comprised the ultrafine particles (diameter: < 0.1 m) and fine particles (diameter: 0.1–1 m), presumably arose from emissions from traffic and high technology factories. Heterogeneous reactions on solid particles might play a role in the removal of SOx and NOx from the atmosphere. Sulfides and nitrides can further react with these local pollutants, forming specific Cu-containing compounds: CuO (39%), CuSO4 (34%), and Cu(NO3)2 (27%), within the ambient particles in this industrial area.