固定化多酚氧化酶对水中苯酚和氯酚的去除

以壳聚糖/蒙脱土插层复合物为载体,吸附法制备固定化多酚氧化酶,并以此催化氧化去除水中的苯酚、4-氯苯酚和2,4-二氯苯酚.考察了固定化多酚氧化酶的制备条件,对酚类化合物的催化氧化条件、动力学特性以及固定化酶的重复使用性能.结果表明,固定化多酚氧化酶的最佳制备条件为p H 5.0,酶与载体质量比20 mg·g-1,固定化6 h,所得固定化酶的载酶量为12.12 mg·g-1,每克单位载体酶活为12.76×103U·g-1.固定化多酚氧化酶对酚类化合物的最佳去除条件为:苯酚溶液p H 7.0,温度30℃;4-氯苯酚溶液p H 5.0,温度20℃;2,4-二氯苯酚溶液p H 5.0,温度30℃.在最佳反应条件下,酶与底物质量比为20 mg·mg-1时,固定化多酚氧化酶对苯酚、4-氯苯酚和2,4-二氯苯酚溶液去除率分别为63.6%、85.8%和87.8%.苯酚、4-氯苯酚和2,4-二氯苯酚的米氏常数Km值依次减小,最大反应速率Vmax依次增大,表明固定化酶对2,4-二氯苯酚的亲和力最强,催化速度最快.固定化酶循环使用6次(24 h)后对苯酚、4-氯苯酚和2,4-二氯苯酚的去除率分别为15.7%、24.2%和27.8%.     

蒙脱石对有机物料施入土壤磷形态和有效性的影响

以冷砂黄泥和矿子黄泥为研究对象,猪粪沼渣为有机物料,分别添加0%、5%、7.5%和10%质量分数的蒙脱石,采用室内培养试验研究了蒙脱石对施有机物料土壤pH、磷形态和有效性的影响.结果表明,有机物料对两种土壤pH无显著影响,而蒙脱石使土壤pH显著提高.施加有机物料使两种土壤铝结合态磷(Al-P)含量和分布比例提高,铁结合态磷(Fe-P)含量培养后期提高、比例略有下降,闭蓄态磷(O-P)含量无明显变化、比例下降.有机物料对冷砂黄泥中钙结合态磷(Ca-P)的含量无明显影响、比例下降,却使矿子黄泥Ca-P含量和比例提高.在施加有机物料基础上添加蒙脱石后,冷砂黄泥Al-P和O-P含量和比例下降,Fe-P含量无明显变化、比例下降,Ca-P含量和比例大幅度提高;矿子黄泥Fe-P和O-P含量和比例下降,Al-P含量无明显变化、比例下降,Ca-P含量和比例大幅度提高.培养过程中,有机物料使冷砂黄泥和矿子黄泥有效磷含量分别提高了17.9%~38.0%和17.1%~33.7%,土壤磷的活化系数也显著提高,添加蒙脱石后使两种土壤有效磷含量分别降低8.8%~35.5%和1.1%~11.6%.相关分析结果表明,蒙脱石通过提高pH和Ca-P含量、降低Al-P含量降低冷砂黄泥磷的有效性,通过提高pH、降低Fe-P含量降低矿子黄泥磷的有效性,对冷砂黄泥磷有效性的影响较矿子黄泥大.     

TiO2-Cu2O/蒙脱土复合光催化剂的制备与性能

以钠基蒙脱土（MMT）为载体，先采用溶胶-凝胶法将纳米TiO₂引入到MMT层间，再采用化学沉积法将纳米Cu₂O负载在TiO₂/MMT上，制备出TiO₂-Cu₂O/MMT纳米复合光催化剂。采用XRD、SEM、紫外-可见漫反射技术对催化剂进行了表征。以甲基橙为目标污染物，考察了催化剂的光催化性能。表征结果显示：TiO₂与Cu₂O均匀分布在MMT的表面与片层孔隙中;TiO₂-Cu₂O/MMT结合了TiO₂和Cu₂O的特性，拓宽了催化剂的光吸收范围。实验结果表明，在光源为可见光、初始甲基橙质量浓度为20 mg/L、光催化剂加入量为2 g/L的条件下，TiO₂-Cu₂O/MMT纳米复合光催化剂对甲基橙的光催化降解效果明显优于单一负载的Cu₂O/MMT和TiO₂/MMT，大幅提高了催化剂的光催化效率，反应300 min时TiO₂-Cu₂O/MMT对甲基橙溶液的脱色率达到93%。     

聚(丙烯酸-co-丙烯酰胺)/膨润土/腐植酸钠三维网络凝胶吸附剂对Cd2+吸附性能研究

制备了一种聚(丙烯酸-co-丙烯酰胺)/膨润土/腐植酸钠三维网络凝胶吸附剂,重点考察了吸附剂对Cd2+吸附的pH依赖性、吸附动力学和吸附等温线.结果表明,Cd2+溶液pH值对吸附容量有较大影响.在pH=8、吸附时间30 min、Cd2+溶液初始浓度0.02 mol/L和吸附剂用量0.10 g的条件下,吸附剂对Cd2+的饱和吸附量可达294.7 mg/g.与膨润土相比,三维网络凝胶吸附剂具有更高的吸附容量和更快的吸附速率.     

The electron density distribution in pyridinium and bipyridylium compounds and its relevance to their adsorption by expanding lattice clays

Abstract

Charge distributions in 1, 1'‐ethylene‐2, 2'‐bipyridylium (diquat), 1,1'‐dimethyl‐4,4'‐bipyridylium (paraquat) and 1‐methylpyridinium organocations were calculated by a Complete Neglect of Differential Overlap semi‐empirical quantum mechanical procedure. The data show that the positive charges in the organocations are distributed around the molecules and are greatest in the positions ortho and para to the heterocyclic nitrogen atoms. Earlier interpretations of the mechanisms of adsorption of paraquat and diquat by soils and clays assumed that the charges were located in the heterocyclic nitrogen atoms. Here some consideration is given to the influence of the charge delocalizations on the processes of adsorption by montmorillonite and vermiculite clay preparations.     

羟基铝及复合改性蒙脱石对As(V)的去除性能

采用无机羟基铝及阳离子表面活性剂十六烷基三甲基溴化铵对天然蒙脱石进行无机及复合改性。在吸附过程中研究了反应时间、投加量和pH等变量对吸附性能的影响,同时进行吸附动力学及吸附等温线研究,吸附规律符合Langmuir等温方程式。采用X射线衍射、X射线荧光、傅里叶红外光谱等表征手段对未改性及改性蒙脱石进行性能表征。研究结果表明,羟基铝及复合改性蒙脱石对As(V)具有良好的吸附性能,在pH为4～10,初始砷浓度为2 mg/L,改性蒙脱石对As(V)的去除率接近99%。吸附机理主要为羟基铝表面络合吸附和静电吸附。     

Sorption and Desorption Behavior of Chloroanilines and Chlorophenols on Montmorillonite and Kaolinite

The bioavailability of pollutants, pesticides and/or their degradation products in soil depends on the strength of their sorption by the different soil components, particularly by the clay minerals. This study reports the sorption-desorption behavior of the environmentally hazardous industrial pollutants and certain pesticides degradation products, 3-chloroaniline, 3,4-dichloroaniline, 2,4,6-trichloroaniline, 4-chlorophenol, 2,4-dichlorophenol and 2,4,6-trichlorophenol on the reference clays kaolinite KGa-1 and Na-montmorillonite SWy-l. In batch studies, 2.0 g of clay were equilibrated with 100.0 mL solutions of each chemical at concentrations ranging from 10.0 to 200.0 mg/L. The uptake of the compounds was deduced from the results of HPLC-UV-Vis analysis. The lipophilic species were best retained by both clay materials. The most lipophilic chemical used in the study, 2,4,6-trichloroaniline, was also the most strongly retained, with sorption of up to 8 mg/g. In desorption experiments, which also relied on HPLC-UV-Vis technique, 2,4,6-trichloroaniline was the least desorbed from montmorillonite. However, on kaolinite all of the compounds under study were irreversibly retained. The experimental data have been modelled according to the Langmuir and Freundlich isotherms. A hypothesis is proposed concerning the sorption mechanism and potential applications of the findings in remediation strategies have been suggested.     

Adsorption of chlorpyrifos,penconazole and metalaxyl from aqueous solution by modified clays

Sorption of three pesticides (chlorpyrifos, metalaxyl and penconazole) has been measured on a commercial clay montmorillonite and on the same mineral modified with either of two cationic-surfactant micelles. Both micelle–clay complexes, commercial names Cloisite 20A and Cloisite 30B, showed a good capacity to sorb all three pesticides from water, whereas their sorption on the natural montmorillonite was not described by an isotherm. Modelling sorption on both micelle–clay complexes showed that the Freundlich sorption constant (K _F) was higher for chlorpyrifos on Cloisite 20A (K _F = 7.76) than on Cloisite 30B (K _F = 5.91), whereas the sorption of metalaxyl was stronger on Cloisite 30B (K _F = 1.07) than on Cloisite 20A (K _F = 0.57). Moreover the micelle–clay complex Cloisite 20A also showed a good affinity for penconazole, the maximum quantity adsorbed (q _m) of 6.33 mg g^?1 being 45% more than that on Cloisite 30B. Single-batch adsorption of each pesticide onto both micelle–clay complexes was studied using the Freundlich isotherm for chlorpyrifos and metalaxyl and the Langmuir isotherm for penconazole. The Cloisite 20A micelle–clay complex was predicted to require 23% less adsorbent to treat certain volumes of wastewater containing 30 mg L^?1 chlorpyrifos, 43% more to treat metalaxyl similarly and 57% less to treat penconazole compared with Cloisite 30B.     

Adsorptive property of Cu^2＋-loaded montmorillonite clays for Escherichia coli K_（88） in vitro

The Cu²⁺-loaded montmorillonite clays (MMT-Cu) may be a good material for the adsorbed and eliminated pathogenic bacteria from aqueous solution.     

Remediation of copper polluted red soils with clay materials

Attapulgite and montmorillonite were utilized to remediate heavy metal polluted red soils in Guixi City, Jiangxi Province, China. The e ects of clay minerals on availability, chemical distribution, and biotoxicity of Cu and Zn were evaluated. The results provided a reference for the rational application of clay materials to remediate heavy metal contaminated soils. From the sorption experiment, the maximum adsorbed Cu2+ by attapulgite and montmorillonite was 1501 and 3741 mg/kg, respectively. After polluted red soil was amended with attapulgite or montmorillonite and cultured at 30 and 60 days, soil pH increased significantly compared to the control. An 8% increase in the amount of montmorillonite in soil and 30 days incubation decreased acid exchangeable Cu by 24.7% compared to the control red soil. Acid exchangeable Cu decreased with increasing amounts of attapulgite and montmorillonite, with best remediation e ect reached at a dose of 8%. Results also showed that the Cu poisoning e ect on earthworms was reduced with the addition of attapulgite and montmorillonite. Montmorillonite showed the best e ect, with the addition of a 2% dose the mortality of earthworms decreased from 60% to zero compared to the control. Our results indicated that the bioavailability of Cu in soils was reduced more e ectively with the application of montmorillonite than attapulgite.