衡阳市区和衡山背景站臭氧浓度变化规律的对比分析

选取衡阳市区和衡山背景站臭氧自动监测数据,分析两地的臭氧污染特征。对空气质量的优良率情况、臭氧作为首要污染物的变化情况、臭氧浓度的日变化特征、典型时段的浓度变化特征、臭氧浓度的月际变化特征和臭氧与PM_(2.5)的关联情况等进行了分析。结果表明,多云及阴雨天气时,衡阳市区的臭氧浓度日变化幅度大于衡山背景站。夏季,衡阳市区和衡山背景站的臭氧浓度的日变化特征规律差异较大,臭氧浓度分布比较分散,前者为典型的单峰形,后者则波动平缓。冬季,日变化幅度不大,但衡阳市区的臭氧浓度明显低于衡山背景站。衡山背景站和衡阳市区的臭氧基本同步变化,但日均值高于衡阳市区。     

Ozone facilitated degradation of caffeine using Ce-TiO2 catalyst

The ozone initiated oxidation of 1,3,7-trimethylxanthine (caffeine), commonly found in wastewaters as model compound is reported using cerium (Ce)/titanium dioxide (TiO₂) as catalyst. The effect of pH and loading of ceria on titania were investigated. Effect of reaction conditions on degradation of caffeine based on their pseudo first-order rate constants were compared. The combination of catalyst Ce-TiO₂ and ozone aeration significantly enhanced the degradation of caffeine compared to uncatalysed ozonation. The oxidation of caffeine ensued via the free radical mechanism, through enhanced ozone decomposition into OH radicals. Ce/TiO₂(0.5?wt%) showed good activity in degradation of caffeine at pH 6, in both natural stream and river water samples showing about 60% total organic carbon removal in 2?h ozonation period. Using liquid chromatography-mass spectroscopy, degradation products were analysed. A reaction intermediate and one final product were positively identified. Nano-catalysts with different loadings of Ce on TiO₂ synthesized by sol-gel route were characterized by scanning electron microscope, transmission electron microscopy, BET and powder X-ray diffraction spectrum techniques. The results showed that the material retained a highly ordered mesoporous structure and possessed large surface area.     

臭氧氧化—湿式钙法吸收工艺对烟气的同时脱硫脱硝

采用臭氧氧化—湿式钙法吸收工艺对模拟烟气进行同时脱硫脱硝处理。O₃于150 ℃下具有较高的热稳定性,可将NO氧化为高价态氮氧化物,且NO氧化率随n（O₃）∶n（NO）的增大而逐渐提高。烟气中SO₂和H₂O的存在对NO氧化率的影响不大。O₃对SO₂的氧化率较低,约为5%。3%（w）石灰石浆液对SO₂的吸收率接近100%,NO_x吸收率随n（O₃）∶n（NO）的增大而逐渐提高,当n（O₃）∶n（NO）为1.6时NO_x吸收率可达约65%。SO₂能促进吸收液对NO_x的脱除。石灰石浆液中加入0.2%（w）的（NH₄）₂SO₃或Na₂SO₃后NO_x吸收率可达约85%或82%,且吸收率随添加剂加入量的增加而提高,添加（NH₄）₂SO₃的NO_x吸收率略高于添加Na₂SO₃。     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

臭氧+曝气生物滤池深度处理工艺试验研究

针对某污水厂出水不达标的情况,本研究采用臭氧(O3)和曝气生物滤池(BAF)组合工艺对其进行深度处理.结果表明,当采用两级臭氧+曝气生物滤池工艺时,出水COD在31～46 mg/L,色度在13～29倍,均达到一级A排放标准.在最佳运行条件下,臭氧氧化使相对分子质量大于50 000的有机物含量减少10％,小于1 000的有机物含量增加14％.曝气生物滤池工艺使相对分子质量小于1 000的有机物含量降低了24％.     

硬质聚氨酯泡沫和组合聚醚中消耗臭氧层物质的便携式GC-MS测定方法

建立了便携式顶空/气相色谱-质谱法测定硬质聚氨酯泡沫和组合聚醚中一氟三氯甲烷（CFC-11）、二氟二氯甲烷（CFC-12）、二氟一氯甲烷（HCFC-22）及一氟二氯乙烷（HCFC-141b）的定性分析方法，系统考察了色谱柱、顶空体系、顶空温度和顶空时间对测定结果的影响。结果表明，DB-WAX色谱柱对目标物质的分离效果最好，顶空温度为50℃、顶空时间为10 min条件下，目标物质的检测灵敏度最高。在优化条件下，硬质聚氨酯泡沫取样体积为1 cm³时，4种目标物的方法检出限为0.6~0.8 μg；组合聚醚取样量为10 mg时，4种目标物的方法检出限为0.5~0.6 μg。该方法具有较高的灵敏度，定性准确，适用于实际样品的现场快速定性分析。     

长三角空气质量区域预报准确性评估方法研究

根据长三角空气质量区域预报工作的实际需要,对分区文字预报和落区图预报两种方式分别制定了不同的空气质量指数级别预报准确性评估方法。分区文字预报根据设定的预报准确性判定方法计算预报评分,落区图预报按区域内预报准确城市占比进行准确率统计。分区文字预报结果显示,2017年长三角区域的预报准确天数占比为62.2%,预报评分为70.2,区域预报评估效果良好。落区图预报评估结果显示,预报级别偏差具有地域性差异,安徽北部、江苏北部和江西中北部预报等级偏高,长三角中南部沿海城市预报等级偏低。该套评估方法可为区域空气质量预报偏差成因分析提供依据,为区域预报工作的改进提供定量参考。     

嘉善前体物与气象因子对臭氧生成的影响及臭氧潜在源区分析

利用2017年嘉善善西超级站臭氧（O₃）及其前体物（NO_x和VOCs）以及气象因子（温度、湿度、风速）逐小时数据，分析了2017年全年NO_x和O₃的变化特征以及春季（4—5月）、夏季（7—8月）NO_x和气象因子对O₃生成的影响，利用O₃生成潜势（OFP）评估了VOCs大气化学反应活性，并通过潜在源区贡献（PSCF）和浓度权重轨迹（CWT）方法分析了嘉善春、夏季O₃潜在源区贡献特征。研究发现：O₃日变化特征为单峰结构，NO_x为弱双峰结构。O₃浓度在3—9月较高，春、夏季O₃浓度峰值分别出现在15：00和14：00，春、夏季的NO_x、O₃日变化与2017年全年日变化趋势基本一致。NO_x对O₃存在滴定作用，且低湿高温有利于O₃浓度的升高。春、夏季O₃生成潜势贡献均表现为烯烃 > 芳香烃 > 烷烃，由于烯烃光化学活性较高，夏季烯烃浓度升高导致其贡献较春季增长约18.1个百分点，且夏季VOCs平均最大O₃增量反应活性高于春季。PSCF和CWT分析结果表明，嘉善春季的潜在源区主要为本地、西南方向和东南方向，夏季的潜在源区主要为本地、西北方向、西南方向以及东南方向。     

动态校准仪臭氧间接传递技术

对5台主流动态校准仪开展臭氧间接传递技术研究,对动态校准仪的准确性、可靠性、稳定性及臭氧传递的线性方程等性能参数进行了实验室考察。总体而言,发生型动态校准仪和分析型动态校准仪均可用于臭氧传递工作中。分析型动态校准仪可直接进行臭氧传递,发生型动态校准仪在臭氧传递前必须进行预校准。建议至少每3个月对发生型动态校准仪进行1次臭氧传递,每6个月对分析型动态校准仪进行1次臭氧传递。     

桂林市城区大气VOCs污染特征及对O3和SOA的生成潜势

对桂林市城区大气中挥发性有机物(VOCs)的污染特征,以及VOCs对臭氧(O3)和二次有机气溶胶(SOA)的生成潜势进行了研究。结果显示,研究期间,共检出VOCs物种78种,平均体积分数为21.32×10-9,表现为芳香烃(67.82%)烷烃(19.56%)卤代烃(7.50%)烯烃(2.86%)含氧挥发性有机物(1.41%)。VOCs体积分数空间分布呈现市中心和下风向郊区两个高值区。通过苯与甲苯的浓度比值发现,林科所VOCs主要来自交通源和生物源,师专甲山校区VOCs主要是来自交通源,其余测点VOCs主要来自交通源、工业源和外来传输源。分析乙苯和间/对二甲苯的浓度比值发现,电子科大尧山校区气团光化学年龄较大,光化学反应活性相对较强烈;旅游学院、华侨旅游经开区、大埠中心校气团光化学年龄较小,光化学反应活性相对较弱。VOCs对O3生成潜势最大的为芳香烃(93.81%),其次是烷烃(7.22%)和烯烃(4.75%);对SOA生成潜势最大的为芳香烃(97.45%),其次是烷烃(2.55%)。