Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

Inhibition character of crotonaldehyde manufacture wastewater on biological acidification

• The inhibition of the main organic pollutions in CMW was demonstrated. • Variations of AK and BK showed a high correlation with the SAA of Ac and n-Bu. • The inhibitory degree was in the order of Ac>n-Bu for individual toxicants. • Biodegradation products of the main toxicants were analyzed. This work aims to investigate the inhibitory effect of crotonaldehyde manufacture wastewater (CMW) on biological acidification. To reveal the inhibitory effect of wastewater to the anaerobic granular sludge (AnGS), variations of the specific acidogenic activity (SAA) and activities of key enzymes were investigated. The results indicated that the dosage of CMW causing a 50% effect concentration (EC₅₀) on the activity of total volatile fatty acids (TVFA) production was 380 mg COD/g VSS. The inhibitory effect of individual toxicants in CMW on the activity of TVFA production were in the order of crotonaldehyde>ethyl sorbate>(E,E)-2,4-hexadienal, and their inhibitory degrees on individual VFA products were acetic acid (Ac)>n-butyric acid (n-Bu), which could correspond to the variations in the activities of acetate kinase (AK) and butyrate kinase (BK). Furthermore, the combined effect of three toxicants on the activity of TVFA production was significantly higher than that of any individual toxicant, and the contribution of the relative toxicity to CMW was 77.27%. Additionally, the biodegradation products of the main toxicants indicated that the removal of crotonaldehyde and (E,E)-2,4-hexadienal was primarily due to the hydrogenation of alkene and aldehyde and the oxidation of aldehyde. Nevertheless, the removal of ethyl sorbate was primarily based on adsorption. In conclusion, biological acidification has a limited ability to treatment CMW, therefore, a further pretreatment technology should be used to remove the main toxicant of wastewater.     

高氯酸铁可见分光光度法测定水中叠氮化物研究

基于Fe~(3+)显色技术,建立了测定地表水、地下水、生活污水和工业废水中叠氮化物的高氯酸铁分光光度法。研究结果表明:N_3~-与Fe~(3+)反应生成的棕红色络合物的特征吸收峰为454 nm;氨基磺酸铵可有效掩蔽NO_2~-的干扰,蒸馏能消除色度、CN~-、SCN~-硫化物等对测定的影响;当取样体积为150 mL、蒸馏定容体积为100 mL、使用10 mm比色皿时,方法检出限为0.08 mg/L(以N_3~-计),测定下限为0.32 mg/L;平均回收率为88.0%~104%,相对标准偏差(n=6)为0.3%～5.6%。对实际工业废水样品进行了测定,结果为1.37 mg/L。该方法准确度高、精密度好、操作简单,能够满足水污染物排放标准中叠氮化物的测定要求。     

Ingestion and egestion of microplastic by aquatic insects in Egypt wastewater

Microplastics (MPs) are frequently regarded as environmental and biota contaminants. Yet, research on the accumulation of MPs in living entities, particularly aquatic insects that serve as food resources in the aquatic food chain, is limited. This study to investigate the accumulation of MPs in aquatic insects from water and sediment in an Egyptian wastewater basin. Four typical freshwater insect groups were used. The highest MP load per gram wet weight was reported by collector-gatherers (Chironomus sp. and Hydrophilus sp.), followed by collector-filterers (Culex sp.) with the second highest MP load. However, Predators (Aeshna sp.) had the lowest values. Also, the present results showed a reduction in the number of MPs in all insect taxa tested after a 24 h depuration time, with differences in the observed egestion ability. The mean number of MPs per individual significantly reduced after 24 h in both Chironomus sp. and Culex sp. larvae, where 53% and 40% of MPs particles were ejected from them, respectively. However, the ability of MP egestion decreases in Aeshna sp. nymph (25%), and the lowest proportion of ejection was observed in Hydrophilus sp. adults (9%). Polyethylene terephthalate fibers were the most abundant type of MP in both sediment and water, followed by fragments (polyethylene and polypropylene). Yet, only polyester fibers were detected in the various insect species. The average length of fibers in the various insects was somewhat shorter than in the surrounding environment. The current study reveals that MP ingestion by aquatic insects is not always related to levels of pollution in the environment, since other factors such as feeding strategies may play a role in MP ingestion. Based on these observations, further studies should be carried out on studies on toxicological impacts of MPs on freshwater/aquatic biota.     

旋流气浮除油装置预处理含油污水

在河南油田开展旋流气浮除油装置的现场试验,考察进水流量和曝气量对旋流气浮除油装置除油效果的影响。试验结果表明:在进水流量为1.8 m³/h、曝气量为0.5 L/min时,除油率最高达到96.03%;在不添加任何药剂的条件下,装置处理效果稳定;连续运行6 d内,进水含油量为174.57~1 193.15 mg/L时,出水含油量可以保持在137.38 mg/L以下,除油率为58.58%~94.53%。     

工业废水毒性评估与致毒物质鉴别技术进展

综述了工业废水毒性的化学评估方法、生物毒性评估方法、毒性鉴定评估(TIE)程序以及效应引导的毒物鉴别分析(EDA)中污染物提取、分离、毒性测试、致毒物质识别等技术。指出,工业废水毒害风险评估方法正逐渐向化学分析与生物毒性测试相结合的关键致毒物质鉴别方法转变,便捷、高通量是致毒物质鉴别技术的发展方向,质谱技术及替代定性监测技术的发展将提供更为准确、便捷的致毒物质鉴别方法,为工业废水潜在风险防控提供依据。     

高含盐废水脱盐处理技术研究进展

综述了几种常见的高含盐废水脱盐处理技术的发展历程、工艺原理、优缺点及目前的研究进展，分析了热分离、膜分离、电渗析、离子交换、电吸附、微生物脱盐等方法的优缺点，展望了未来废水脱盐工艺的发展方向。指出：脱盐方法将根据各类水体的水质特点更加精细化；多种脱盐技术联合应用也是今后废水脱盐的发展方向。     

氨废水资源化利用的折流式超重力床集成技术

利用折流式超重力床将氨废水处理的精馏和吸收过程集成在一台设备中,开发出一种设备小型化、流程紧凑的氨废水资源化利用集成技术。与传统技术相比,该技术在大幅节省占地面积和空间的同时,还可大幅节约设备建设所用钢材。工业规模试验结果表明,不同浓度的氨废水经该技术处理后可转化为氨质量分数大于22%的氨水资源,处理出水中氨氮质量浓度低于8.2 mg/L,尾气中未检测到氨,处理结果优于GB 31573—2015《无机化学工业污染物排放标准》。     

SMBBR-AF-SMBBR组合工艺处理高氨氮农药废水

采用特异性移动床生物膜反应器(SMBBR)和厌氧生物滤池(AF)组合工艺处理高氨氮农药废水。考察了HRT、pH和DO等工艺条件对SMBBR-AF-SMBBR组合工艺运行稳定期COD和氨氮去除率的影响。试验结果表明,在进水COD为2 408~7 440 mg/L、ρ(NH_4~+-N)为160.21~433.84 mg/L、TN为208.27~537.65 mg/L、HRT为8d、pH为8.0、DO为4 mg/L的条件下,处理后出水平均COD为342 mg/L,COD去除率达92.3%;ρ(NH_4~+-N)小于4.0mg/L,氨氮平均去除率为89.2%;TN小于50 mg/L,平均TN去除达83.0%。出水各指标均优于原A2O工艺出水。     

活性炭吸附和两级Fenton氧化组合工艺处理高盐对氨基苯酚生产废水

采用活性炭吸附和两级Fenton氧化组合工艺对高盐度对氨基苯酚生产废水进行了处理实验研究。结果表明,p H值对活性炭去除有机物的影响较小。当活性炭投加量为4 g/L时,TOC去除率61%。分级加药可以有效提高Fenton氧化对有机物的去除效率。在温度为25℃、p H为3、30%H2O2投加量为3%(V/V)、Fe2+/H2O2摩尔比为0.05时,两级Fenton氧化处理后,出水TOC降至150 mg/L以下。此外,Fenton氧化后形成氢氧化铁污泥颗粒粒径为4.5μm,经过聚丙烯酰胺(PAM)絮凝之后,污泥的粒径明显增加,过滤特性改善。PAM絮凝效果依赖于溶液的p H值,当p H超过10后会失去作用,故在使用过程中需要严格控制溶液的p H值。