Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

Electroosmotic dewatering of dredged sediments: bench-scale investigation

The Indiana Harbor (Indiana, USA) has not been dredged since 1972 due to lack of a suitable disposal site for dredged sediment. As a result of this, over a million cubic yards of highly contaminated sediment has accumulated in the harbor. Recently, the United States Army Corps of Engineers (USACE) has selected a site for the confined disposal facility (CDF) and is in the process of designing it. Although dredging can be accomplished rapidly, the disposal in the CDF has to be done slowly to allow adequate time for consolidation to occur. The sediment possesses very high moisture content and very low hydraulic conductivity, which cause consolidation to occur slowly. Consolidation of the sediment is essential in order to achieve adequate shear strength of sediments and also to provide enough air space to accommodate the large amount of sediment that requires disposal. Currently, it has been estimated that if a one 3-foot (0.9-m) thick layer of sediment was disposed of at the CDF annually, it would take approximately 10 years to dispose of all the sediment that is to be dredged from the Indiana Harbor. This study investigated the feasibility of using an electroosmotic dewatering technology to accelerate dewatering and consolidation of sediment, thereby allowing more rapid disposal of sediment into the CDF. Electroosmotic dewatering essentially involves applying a small electric potential across the sediment layer, thereby inducing rapid flow as a result of physico-chemical and electrochemical processes. A series of bench-scale electrokinetic experiments were conducted on actual dredged sediment samples from the Indiana Harbor to investigate dewatering rates caused by gravity alone, dewatering rates caused by gravity and electric potential, and the effects of the addition of polymer flocculants on dewatering of the sediments. The results showed that electroosmotic dewatering under an applied electric potential of 1.0VDC/cm could increase the rate of dewatering and consolidation by an order of magnitude as compared to gravity drainage alone. Amending the sediment with polymers at low concentrations (0.5-1% by dry weight) will enhance this dewatering process; however, the optimal polymer concentration and the cost-effectiveness of using polymers should be investigated further.     

安全评价方法在危险废物处置环境风险评价中的应用探讨

对安全评价方法在危险废物处置建设项目环境风险评价中的运用进行初步探索。主要用"工艺过程风险因素分析表"对工艺过程潜在风险性识别;用蒙德法进行源项分析;用池火灾模型、蒸气云爆炸伤害模型对易燃、易爆物质的火灾、爆炸等重大事故后果进行计算,得出人员的伤亡半径和财产损失半径等参数,以便于判断风险的可接受水平。分析结果表明:采用安全评价方法对危险废物处置建设项目进行环境风险评价是适用的、可行的。     

农村生活污水治理措施

介绍了适合于国内农村生活污水治理的一些技术与措施。沼气技术是当前处理农村生活污水的较佳选择。     

焦化废水处理过程中固相物质的形成及处置方法评价

焦化废水处理过程中产生的焦油、污泥和结晶杂盐等固相物质,既有资源属性,又有污染特性,但目前缺乏基于能源、经济及环境影响方面的评估.本研究阐述了3类固相物质的形成机制,建立了质量当量计算及处置方法评价模型.以宝武集团韶关钢铁股份有限公司焦化厂（二期）焦化废水处理工程的A/O/H/O（厌氧/好氧/水解/好氧）流化床工艺作为考察对象,利用工程运行参数和水质统计数据进行固相物质的产量推算,结果发现,焦油、物化污泥、生物污泥（含水率为80%）和工业杂盐的产率分别为0.186、5.80、4.24和1.97 kg·m^-3.通过处置方法评价模型明确了焦油焚烧、污泥热解、结晶杂盐分盐提纯后工业应用是最佳处置方案,在60 m³·h^-1废水处理规模的固相物质处置过程中,每年约产生1177 MWh的能源,获得135.0万元的经济效益,排放627.0 t CO₂,表明能源回收、经济效益和环境影响的协同存在.     

铁基质强化新型功能性化粪池高效处理黑水的试验

以铁基质生物载体为核心,将物理、生物和化学方法结合,对化粪池进行功能强化,实现黑水的原位深度处理.探究了溶解氧（DO）和碳氮比（C/N）等因素对黑水中污染物降解的影响,并在最佳运行参数下考察了氮素在系统中的转化机制.结果表明,当C/N为7.3~8.4时,好氧生物铁基质载体池DO为2.3~2.7mg/L时,系统氨氮（NH₄⁺-N）、总氮（TN） 、COD和总磷（TP）的平均去除率分别可达90.74%、85.81%、92.65%和95.78%;当进水C/N降至3.3~4.2时,系统NH₄⁺-N、TN、COD和TP的平均去除率仍可维持在81.16%、76.62%、93.87%和94.75%.铁基质生物载体内电解作用显著强化了化粪池内TN的脱除、COD的氧化和TP的固定.氮素转化机制分析表明,内电解与反硝化菌的耦合强化了反硝化作用,降低了反硝化过程对有机碳源的需求,强化了低C/N条件下TN、TP的脱除.     

新疆番茄酱企业生产废水处理利用方式探析

近年来,新疆番茄酱加工业得到了迅速发展,目前番茄酱的产销量已占全国的90%以上。与此同时，新疆番茄酱生产企业的废水排放量也大幅增加,大量未经处理的废水直接排放,已对当地的水环境构成严重的污染隐患。本文分析了新疆番茄酱企业生产废水的排放特征与目前排放出路的可行性,并结合新疆的自然地理条件及番茄酱企业的分布情况，着重探讨了土地处理这一适合新疆的废水利用方式,以期有利于新疆的环境保护和废水资源的循环利用。     

混凝沉淀用于铬鞣废液处理方法的探讨

对制革生产废水中的铬鞣废液的处理方法进行了探讨，通过投加处理效率高且费用低廉的混凝剂提高废水中铬的去除效率，并最终应用于实际工程中，取得了良好的效果。     

哈尔滨市生活垃圾处理产业化探讨

随着我国经济发展和人民生活水平的不断提高,城市垃圾产生量也不断增加,垃圾处理越来越受到人们的重视,垃圾处理产业也逐渐兴起.由于地区差异,工业发达程度和生活水平不同,不同的国家和地区有着不同的垃圾组成,相应的也采取不同的垃圾处理方法.哈尔滨市的生活垃圾处理现状具有一定的典型性,文章结合哈尔滨市实际情况,主要论述哈尔滨市生活垃圾的产量、特性及目前的处理状况,分析哈尔滨市生活垃圾问题的实质,对垃圾处理产业化存在的问题及其对策进行探讨,以期更好地促进生活垃圾处理步入产业化的发展轨道.     

重庆城市餐厨垃圾管理对策的初步研究

餐厨垃圾对环境的污染和人们身心健康的危害日益显现,重庆市对餐厨垃圾的统一管理与处置基本还处于空白状态.本文介绍了国内外餐厨垃圾管理的政策和措施,剖析重庆城市餐厨垃圾污染的现状及原因,进而提出全市餐厨垃圾管理的总体思路,并着重从健全法律法规体系、转变政府管理职能、建立市场化机制及引导公众参与等方面提出了相应的对策建议.