Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

• Strong metal-support interaction exists on Pt/Fe₃O₄ catalysts. • Pt metal particles facilitate the formation of oxygen vacancies on Fe₃O₄. • Fe₃O₄ supports enhance the strength of CO adsorption on Pt metal particles. The self-inhibition behavior due to CO poisoning on Pt metal particles strongly impairs the performance of CO oxidation. It is an effective method to use reducible metal oxides for supporting Pt metal particles to avoid self-inhibition and to improve catalytic performance. In this work, we used in situ reductions of chloroplatinic acid on commercial Fe₃O₄ powder to prepare heterogeneous-structured Pt/Fe₃O₄ catalysts in the solution of ethylene glycol. The heterogeneous Pt/Fe₃O₄ catalysts achieved a better catalytic performance of CO oxidation compared with the Fe₃O₄ powder. The temperatures of 50% and 90% CO conversion were achieved above 260°C and 290°C at Pt/Fe₃O₄, respectively. However, they are accomplished on Fe₃O₄ at temperatures higher than 310°C. XRD, XPS, and H₂-TPR results confirmed that the metallic Pt atoms have a strong synergistic interaction with the Fe₃O₄ supports. TGA results and transient DRIFTS results proved that the Pt metal particles facilitate the release of lattice oxygen and the formation of oxygen vacancies on Fe₃O₄. The combined results of O₂-TPD and DRIFTS indicated that the activation step of oxygen molecules at surface oxygen vacancies could potentially be the rate-determining step of the catalytic CO oxidation at Pt/Fe₃O₄ catalysts. The reaction pathway involves a Pt-assisted Mars-van Krevelen (MvK) mechanism.     

石墨烯薄膜原子氧剥蚀行为及电阻特性

目的研究石墨烯薄膜在原子氧空间环境的适应性,为其在航天器上应用提供参考。方法采用刮涂法制备石墨烯薄膜,将石墨烯薄膜材料及石墨烯电阻传感器置于微波源原子氧设备内开展原子氧试验,原子氧剂量分别为3.0×10^20 atoms/cm2和7.5×10^20 atoms/cm^2,研究薄膜表面形貌、结构、成分及电阻性能的变化。结果采用刮涂法可制备氧含量较低的石墨烯薄膜,原子氧剂量为7.5×10^20 atoms/cm^2情况下,石墨烯薄膜的厚度损失为5.3μm,原子氧反应率为7.14×10^-25 atoms/cm^3。原子氧作用后,石墨烯薄膜中碳原子无序程度增大,C—O、—COOH官能团含量降低,C=O官能团含量增加。石墨烯电阻传感器的R0/R比值随原子氧剂量增加线性降低,0.8μm厚度薄膜可探测最大原子氧剂量为5×10^19 atoms/cm^2,增加薄膜厚度有望提高传感器的使用寿命。结论得到了石墨烯薄膜厚度损失、原子氧反应率、微观结构及电阻特性的变化规律,可为石墨烯薄膜的空间应用提供技术支撑。     

极端干旱水文年(2011年)夏季珠江口溶解氧的分布特征及影响因素研究

气候变化背景下,极端气候事件对河口生态环境的影响已引起许多研究者的关注.基于2011年夏季的调查资料,分析了珠江口在极端干旱情况下溶解氧的分布特征及其与海水稳定性、营养盐和浮游植物分解之间的关系,并对河口底层低氧区的成因进行初步探讨.调查结果发现,在珠江特低径流量的情况下,珠江口邻近海域底层明显出现低氧状态,DO的最低值仅为1.38 mg.L-1.相关性分析显示,表层水和底层水之间的ΔDO与ΔT、ΔS、ΔDIN、ΔSS和ΔPOC都达到显著相关的水平,其中ΔDO与ΔT和ΔPOC呈极显著的正相关,而与ΔS呈极显著的负相关关系.研究表明,与1999年和2009年夏季不同,2011年夏季珠江口底层低氧环境的形成主要与极端干旱气候下低径流导致河口水体滞留时间延长及颗粒态有机物质在沉降过程中的分解耗氧有关.另外,从最低DO值的角度分析,珠江口季节性缺氧程度在过去20 a间并未呈现显著的变化趋势.     

提高快速法测定C OD准确度及精密度的方法

介绍了用快速法测定COD分析中提高准确度及精密度的方法。     

V2O5/TiO2催化剂脱除NO的研究

采用了等体积浸渍法制备二氧化钛负载钒氧化物催化剂（V2O5/TiO2）,研究了V2O5负载量、反应温度、烟气流量、氨氮比以及运行时间各因素对NH3选择性催化还原NO反应（SCR）效率的影响.研究结果表明：经过500℃温度下煅烧,烟气流量为200ml/min,负载量为7wt％的V2O5/TiO2催化剂,在400℃温度下反应,NO脱除率可达70.5％.     

五日生化需氧量测定的影响因素

五日生化需氧量是一种表间接表示水体中有机物含量,是水质监测的一个重要参数。本文对水样的保存、溶解氧、pH值、温度、接种稀释水和稀释度等影响测定五日生化需氧量成败的因素进行探讨,并提出相应的解决方法。     

水库渗漏水流溶解氧与水温沿程恢复的试验研究

水库底层低温低氧水从坝体下泄或渗漏,可能对下游生态产生不利影响。通过对湖北温峡水库下游温峡河225 km河段的野外试验,测量溶解氧、水温等指标的日变化和沿程变化,开展复氧试验研究阶梯深潭结构和沙洲对溶解氧的影响,并取样分析大型底栖无脊椎动物的沿程分布。结果表明,流速对水温与溶解氧日变化规律无明显影响。试验河段水温和溶解氧恢复很快,经过17 km的河段,水温从123℃升高至300℃,且溶解氧饱和度基本达到饱和。河宽对水温恢复起重要作用,对溶解氧影响较小,对复氧速度基本无影响。流量通过改变淹没程度影响阶梯深潭的复氧能力。溶解氧在沙洲下游存在横向分布,滞水区溶解氧高于左右汊道。溶解氧是水库下游水生态的控制因素,物种多样性随溶解氧的升高而增加     

胞外聚合物磷酸盐形态对生物除磷过程的影响研究

以不同DO条件下污泥龄(SRT)分别为10 d和30 d的两组实验室A/O-SBR反应器活性污泥为研究对象,探讨了胞外聚合物(EPS)磷酸盐形态对生物除磷过程的影响.结果表明,污泥絮体中的磷主要分布于EPS中,PO3-4-P和聚磷酸盐(Poly-P,包括低分子量聚磷酸盐LMW PolyP和高分子量聚磷酸盐HMW Poly-P)是EPS磷的主要形态;EPS对生物除磷的影响明显大于细菌细胞,EPS磷的厌氧降低量和好氧升高量为胞内磷变化量的2.8~6.4倍.EPS中的LMW Poly-P和HMW Poly-P含量均表现厌氧降低和好氧升高的变化规律;对于相同SRT的污泥,中DO(2.5~3.5 mg·L-1)条件较低DO(0.7~1.0 mg·L-1)条件下EPS的LMW Poly-P和HMW Poly-P有更大的厌氧降低量和好氧升高量,对应着更明显的生物除磷过程,说明EPS不仅是生物除磷过程的中转站,而且参与了生物聚磷过程.     

水和废水中化学需氧量测定方法的改进研究

在水的CODcr测定中,将30 ml回流量确定为常规检测回流量,可节省浓硫酸和硫酸银用量50%;将消解回流时间从120 min缩短为30 min,已满足对地表水和各类废水中CODcr的准确测定,可节省水电费用75%以上,含氯水样中Cl-的掩蔽研究表明:按国标法用10倍Cl-重量的HgSO4 掩蔽Cl-,加标(CODcr =100 mg/L)回收率为110%~120%左右,用30~40倍Cl -重量的HgSO4 掩蔽Cl-,加标回收率为100%左右,对HgSO4 掩蔽Cl-的条件和机理作了适当探讨.另外,采用加入H2 SO4-后加入HgSO4 的方法可减少HgSO4 的耗用量70%以上.     

Antimony induces oxidative stress and cell death in normal hepatocytes

Antimony (Sb) accumulates in the liver which is one of the target organs for metal-mediated toxicity. Although toxicity of Sb was previously investigated, the precise mechanism of Sb-induced hepatotoxicity remains to be determined. The aim of this study was to examine the role of oxidative stress, and mitochondria in the induction of cell death by Sb. Our results showed that liver cell lysis induced by Sb is mediated by reactive oxygen species (ROS) formation, lipid peroxidation and decline of mitochondrial membrane potential (MMP). Antimony-induced ROS formation, lipid peroxidation and reduction of MMP were significantly diminished by antioxidants and ROS scavengers such as dimethyl sulfoxide and mannitol; mitochondrial permeability transition (MPT) pore sealing agents such as carnitine and trifluoperazine; and adenosine triphosphate (ATP) generator, L-glutamine. Antimony-induced ROS formation, lipid peroxidation and fall in MMP were potentiated by glutathione (GSH) depletion via n-bromoheptane. MPT pore sealing agents and ATP generator inhibited hepatotoxicity, indicating Sb-activated cell death via mitochondrial pathway. Pretreatment of hepatocytes with antioxidants and ROS scavengers also blocked cell death induced by Sb, whereas GSH depletion enhances Sb-induced cell death, suggesting that oxidative stress may be directly involved in the reduction of MMP. These findings contribute to a better understanding of the mechanisms that mediate Sb-induced cell death in isolated rat hepatocytes.