A multidecadal oscillation in precipitation and temperature series is pronounced in low flow series from Puget Sound streams

In Pacific Northwest streams, summer low flows limit water available to competing instream (salmon) and out-of-stream (human) uses, creating broad interest in how and why low flows are trending. Analyses that assumed linear (monotonic) change over the last ~60 years revealed declining low flow trends in minimally disturbed streams. Here, polynomials were used to model flow trends between 1929 and 2015. A multidecadal oscillation was observed in flows, which increased initially from the 1930s until the 1950s, declined until the 1990s, and then increased again. A similar oscillation was detected in precipitation series, and opposing oscillations in surface temperature, Pacific Decadal Oscillation, and Interdecadal Pacific Oscillation series. Multidecadal oscillations with similar periods to those described here are well known in climate indices. Fitted model terms were consistent with flow trends being influenced by at least two drivers, one oscillating and the other monotonic. Anthropogenic warming is a candidate driver for the monotonic decline, and variation in (internal) climatic circulation for the oscillating trend, but others were not ruled out. The recent upturn in streamflows suggests that anthropogenic warming has not been the dominant factor driving streamflow trends, at least until 2015. Climate projections based on simulations that omit drivers of multidecadal variation are likely to underestimate the range, and rate of change, of future climatic variation.     

含氮生物降解促进剂对土壤吸附正十六烷的影响

选用正十六烷模拟润滑油,通过振荡平衡实验,考察了两种含氮脂肪酸型生物降解促进剂（甲基二乙醇胺油酸酯（MDEAO）和油酸二乙醇酰胺（ODEA））对水土体系中正十六烷吸附行为的影响。实验结果表明：正十六烷在水土体系中的有机质标化分配系数与土壤种类无关,与生物降解促进剂种类有关;土壤对正十六烷的吸附过程更符合Freundlich等温吸附模型;MDEAO的临界胶束浓度为2.0 mg/L,对土壤吸附正十六烷有一定的促进作用,ODEA的临界胶束浓度为0.7 mg/L,形成的胶束对正十六烷的增溶效果明显,促进了正十六烷在土壤中的解吸。     

Enhancing the adsorption function of biochar by mechanochemical graphitization for organic pollutant removal

• Mechanochemical treatment reduced the calcination temperature for biochar synthesis. • Biochar is converted to graphite after mechanochemical treatment. • Biochar was reduced to nanoscale after mechanochemical treatment. Biochar (BC) has been extensively studied as adsorbent for the treatment of water pollution. Despite the distinct advantages, the high calcination temperature and low adsorption capacity of pristine BC limit its practical applications. Most of the former studies focused on the structure and/or surface modification to improve the adsorption capacity of BC. However, the harsh experiment conditions involved in the biochar modification limited the application in industrial level. Herein, we introduced mechanical treatment into BC preparation to reduce the calcination temperature and improve the adsorption capacity simultaneously. The results indicated that the calcination temperature was reduced and the adsorption capacity of the treated BC was improved after mechanochemical treatment. Characterization of the samples disclosed that BCs were graphitized with the particle size reduced to nanoscale after treatment. Adsorption tests indicated that the mechanochemically treated BCs showed much better removal performance of organic contaminants than that of pristine BCs. For instance, among four pristine BCs (BC600, BC700, BC800, and BC900), only BC900 has strong adsorption capacity for MB, while BC600 has low adsorption capacity (1.2 mg/g). By comparison, the adsorption capacity of MB increased greatly to 173.96 mg/g by BC600-500/1 (treated at 500 r/min for 1 hour). To optimize the mechanochemical treatment, the effects of rotation speed and agitation duration were also investigated.     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

新制备生物炭的特性表征及其对石油烃污染土壤的吸附效果

生物炭作为一种绿色环保的功能材料因其在污水处理和污染土壤修复方面具有显著效果而受到极大关注.采用红外光谱、元素分析仪及微孔分析对不同温度(200、300、400、500和600℃)条件下制备的木屑和麦秆生物炭进行特性表征,并采用制备的生物炭净化石油污染土壤,分别考察了污染物性质、生物质原料和热解温度对其净化效果的影响.结果表明,随着热解温度的增高,生物炭芳香化程度增加,极性降低,微孔结构逐渐发育,表面积增大.加入生物炭33 d后,污染土壤中总石油烃及其组分烷烃的浓度比对照略有降低,而PAHs浓度下降显著.随着热解温度升高,2种生物炭对PAHs的吸附强度均逐渐增大,芳香度增高、表面积增大是强吸附的主要原因.2种生物炭在400℃及以下温度制备时对PAHs的吸附强度为:木屑生物炭＞麦秆生物炭;而400℃以上温度制备的生物炭吸附强度则相反,即麦秆生物炭＞木屑生物炭,说明生物炭原料对其吸附强度也具有显著影响.     

2002—2012年京津唐PM10变化规律及差异

对2002年6月—2012年5月京津唐城市群大气可吸入颗粒物(PM10)质量浓度的长期监测数据进行分析,结合3市的地理、气候气象条件,分析了京津唐城市群大气颗粒物质量浓度的变化特征;根据3市PM10相互之间的发散系数,定量分析了3市PM10变化的差异。结果表明,2002—2012年北京市的PM10质量浓度变化范围为0.012~0.600 mg/m3,天津、唐山2市的PM10质量浓度变化范围分别为0.014~0.600、0.019~0.452 mg/m3。2008、2011年天津市PM10质量浓度年平均值达到二级标准,唐山市从2008年后PM10质量浓度年平均值达到二级标准;北京市PM10质量浓度总体变化趋势为春季秋季冬季夏季,天津、唐山市均为冬季春季秋季夏季,但不同年份的变化趋势略不同;北京-唐山、北京-天津、天津-唐山之间PM10的月度发散系数范围分别为0.402 7~0.159 2、0.406 8~0.142 9、0.323 1~0.107 8,说明空间距离最近的天津-唐山之间大气污染的相互影响较北京-天津、北京-唐山之间大。     

供水管网震后流量监测点的动态分级优化布局研究

为了提高管网地震监测点布局的准确性和合理性，基于管网微观水力计算模型和动态分级法，提出供水管网震后流量监测点的动态分级优化布局模型。首先，利用管网微观水力计算模型计算管段流量的影响系数，构建管段的影响系数矩阵，并利用信息熵确定管段权重；其次，标准化处理影响系数矩阵，通过聚类迭代提出供水管网地震流量监测点优化布局的动态分级方法，对供水管网震后流量监测点进行优化布置分级评定；最后，根据工程实例进行方法实践，结果表明:供水管网中的管线分类较为科学合理，地震监测点在供水管网上分布也比较均匀，而且该模型在一定程度上消除了人为因素的影响，保障了震时管网的监控效果和日常建设的合理性。     

高温高压下煤孔隙结构的变化对瓦斯吸附特性的影响

为了研究高温高压条件下煤孔隙结构变化对瓦斯吸附特性的影响，选取九里山矿无烟煤，在压力为7 MPa、温度为40～130℃的条件下进行等温吸附实验和压汞实验。研究结果表明:煤样对甲烷的等温吸附曲线在该压力、温度条件下符合Ⅰ型吸附曲线特性，吸附规律符合Langmuir吸附模型；在压力7 MPa和温度130℃条件下，煤样的孔隙结构发生一定的变化，煤的比表面积增大、累计孔体积降低，可见孔及裂隙的数量比例增高，加强了煤样孔隙之间的连通度，导致原本吸附在煤样表面的甲烷分子大量解吸；在压力不变的情况下，随着温度的不断增高，煤的极限吸附量逐渐减小，其主要原因是样品孔隙结构的破坏和分子间作用力的变化。     

基于Landsat 8遥感数据的天津市地表温度反演

以Landsat 8遥感数据为数据源,进行天津市地表温度反演研究。首先采用单通道算法反演地表温度,并利用均值标准差法进行温度分级。然后建立不同温度等级面积比例的估算模型。再通过随机样点,从不同温度等级和土地覆盖类型2个角度,分别建立并比较不同类样点的地表温度与各指数的拟合模型。结果表明:次高温区域面积比例与人口密度、人均GDP都具有较高的决定系数;地表温度与NDVI、BAEM的二元线性回归决定系数高于地表温度与单一指数的决定系数;将样点分类后,低温点与MNDBI的决定系数高于其他温度等级样点,水域和植被样点与各种指数的决定系数高于其他地物类型样点。     

Spatial and Seasonal Response of Municipal Water Use to Weather across the Contiguous U.S.

Weather variability has the potential to influence municipal water use, particularly in dry regions such as the western United States (U.S.). Outdoor water use can account for more than half of annual household water use and may be particularly responsive to weather, but little is known about how the expected magnitude of these responses varies across the U.S. This nationwide study identified the response of municipal water use to monthly weather (i.e., temperature, precipitation, evapotranspiration [ET]) using monthly water deliveries for 229 cities in the contiguous U.S. Using city‐specific multiple regression and region‐specific models with city fixed effects, we investigated what portion of the variability in municipal water use was explained by weather across cities, and also estimated responses to weather across seasons and climate regions. Our findings indicated municipal water use was generally well‐explained by weather, with median adjusted R² ranging from 63% to 95% across climate regions. Weather was more predictive of water use in dry climates compared to wet, and temperature had more explanatory power than precipitation or ET. In response to a 1°C increase in monthly maximum temperature, municipal water use was shown to increase by 3.2% and 3.9% in dry cities in winter and summer, respectively, with smaller changes in wet cities. Quantifying these responses allows urban water managers to plan for weather‐driven variability in water use.