填埋场垃圾堆体平面压实工程试验研究

原生垃圾密度很小，为提高填埋垃圾堆体密实度、延长填埋场使用寿命，对填埋垃圾进行压实处理很重要。本文通过现场工程试验对影咱填埋垃圾堆体平面压实效果的主要因素进行了系统研究。实验结果表明：为取得最佳的垃圾堆体平面压实效果，最佳垃圾摊铺厚度在0.5m—0.7m之间，最佳机械行程次数为3次，增加碾压次数有利于提高垃圾堆体密实度，垃圾最佳含水率在30％——50％之间。     

自动变光焊接护目镜响应特性测试仪研究

为制定变光焊接护目镜新产品专业标准提供支撑，进行了焊接弧光特性和变光焊接护目镜响应特性研究，解决了焊接弧光模拟、弧光信号检测、时间小信号检测等技术关键，研制了响应特性测试系统，并进行实测分析。便携式测试仪采用暗箱全封闭结构，能产生模拟的交直流弧焊信号，能检测10^-1～10^4lx照度的光信号并保持线性，能检测弧光作用下护目镜可见光透射比的整个变化过程，最大采样频率达30kHz，确保测试精度，能按响应时间定义进行记录和运算，测试接口具有通用性。     

Biodegradation of phenol by free and immobilized Acinetobacter sp. strain PD12

A new phenol-degrading bacterium with high biodegradation activity and high tolerance of phenol, strain PD 12, was isolated from the activated sludge of Tianjin Jizhuangzi Wastewater Treatment Facility in China. This strain was capable of removing 500 mg phenol/L in liquid minimal medium by 99.6% within 9 h and metabolizing phenol at concentrations up to 1100 mg/L. DNA sequencing and homologous analysis of 16S rRNA gene identified PD12 to be an Acinetobacter sp. Polyvinyl alcohol （PVA） was used as a gel matrix to immobilize Acinetobacter sp. strain PDI2 by repeated freezing and thawing. The factors affecting phenol degradation of immobilized cells were investigated, and the results showed that the immobilized cells could tolerate a high phenol level and protected the bacteria against changes in temperature and pH. Storage stability and reusability tests revealed that the phenol degradation functions of immobilized cells were stable after reuse for 50 times or storing at 4℃ for 50 d. These results indicate that immobilized Acinetobacter sp. strain PD 12 possesses a good application potential in the treatment of phenol-containing wastewater.     

脉冲强光对水中枯草杆菌灭活效果的研究

脉冲强光杀菌技术是近年来开发的一种新型冷杀菌技术,利用强烈的白光闪照进行杀菌。以枯草杆菌为目标微生物,对比研究脉冲强光与紫外线对微生物的灭活效果。并通过改变脉冲强光装置的输入电压和闪照次数,研究了影响脉冲强光杀菌的影响因素。     

Long-range atmospheric transport of three toxaphene congeners across Europe. Modeling by chained single-box FATEMOD program

Background, aims, and scope  Since toxaphene (polychlorocamphene, polychloropinene, or strobane) mixtures were applied for massive insecticide use in the 1960s to replace the use of DDT, some of their congeners have been found at high latitudes far away from the usage areas. Especially polychlorinated bornanes have demonstrated dominating congeners transported by air up to the Arctic areas. Environmental fate modeling has been applied to monitor this phenomenon using parallel zones of atmosphere around the globe as interconnected environments. These zones, shown in many meteorological maps, however, may not be the best way to configure atmospheric transport in air trajectories. The latter could also be covered by connecting a chain of simple model boxes. We aim to study this alternative approach by modeling the trajectory chain using catchment boxes of our FATEMOD model. Polychlorobornanes analyzed in biota of the Barents Sea offered one case to study this modeling alternative, while toxaphene has been and partly still is used massively at southern East Europe and around rivers flowing to the Aral Sea. Materials and methods  Pure model substances of three polychlorobornanes (toxaphene congeners P26, P50, and P62) were synthesized, their environmentally important thermal properties measured by differential scanning calorimetry, as evaluated from literature data, and their temperature dependences estimated by the QSPR programs VPLEST, WATSOLU, and TDLKOW. The evaluated property parameters were used to model their atmospheric long-range transport from toxaphene heavy usage areas in Ukraine and Aral/SyrDarja/AmuDarja region areas, through East Europe and Northern Norway (Finnmarken) to the Barents Sea. The time period used for the emission model was June 1997. Usual weather conditions in June were applied in the model, which was constructed by chaining FATEMOD model boxes of the catchment’s areas along assumed maximal air flow trajectories. Analysis of the three chlorobornanes in toxaphene mixtures function as a basis for the estimates of emission levels caused by its usage. High estimate (A) was taken from contents in a Western product chlorocamphene and low estimate (B) from mean contents in Russian polychloroterpene products to achieve modeled water concentrations. Bioaccumulation to analyzed lipid of aquatic biota at the target region was estimated by using statistical calculation for persistent organic pollutants in literature. Results  The results from model runs A and B (high and low emission estimate) for levels in sea biota were compared to analysis results of samples taken in August 1997 at Barents Sea. The model results (ng g⁻¹ lw): 4–95 in lipid of planktovores and 7–150 in lipid of piscivores, were in fair agreement with the analysis results from August 1997: 21–31 in Themisto libellula (chatka), 26–42 in Boreocadus saida (Polar cod), and 5–27 in Gadus morhua (cod) liver. Discussion  The modeling results indicate that the application of chained simple multimedia catchment boxes on predicted trajectory is a useful method for estimation of volatile airborne persistent chemical exposures to biota in remote areas. For hazard assessment of these pollutants, their properties, especially temperature dependences, must be estimated by a reasonable accuracy. That can be achieved by using measurements in laboratory with pure model compounds and estimation of properties by thermodynamic QSPR methods. The property parameters can be validated by comparing their values at an environmental temperature range with measured or QSPR-estimated values derived by independent methods. The chained box method used for long-range air transport modeling can be more suitable than global parallel zones modeling used earlier, provided that the main airflow trajectories and properties of transported pollutants are predictable enough. Conclusions  Long-range air transport modeling of persistent, especially photo-resistant organic compounds using a chain of joint simple boxes of catchment’s environments is a feasible method to predict concentrations of pollutants at the target area. This is justified from model results compared with analytical measurements in Barents Sea biota in August 1997: three of six modeled values were high and the other three low compared to the analysis results. The order of magnitude level was similar in both modeled (planktovore and piscivore) and observed (chatka and polar cod) values of lipid samples. The obtained results were too limited to firm validation but are sufficient to justify feasibility of the method, which prompts one to perform more studies on this modeling system. Recommendations and perspectives  For assessment of the risk of environmental damages, chemical fate determination is an essential tool for chemical control, e.g., for EU following the REACH rules. The present conclusion of applicability of the chained single-box multimedia modeling can be validated by further studies using analyses of emissions and target biota in various other cases. To achieve useful results, fate models built with databases having automatic steps for most calculations and outputs accessible to all chemical control professionals are essential. Our FATEMOD program catchments at environments and compound properties listed in the database represent a feasible tool for local, regional, and, according our present test results, for global exposure predictions. As an extended use of model, emission estimates can be achieved by reversed modeling from analysis results of samples corresponding to the target area. This article is dedicated to the memory of Professor Alexander B Terentiev (who passed away in November 2006), our true friend. With his Institute of Organo-Element Compounds, Russian Academy of Science, Moscow, he was an important main organizer of the six joint Finnish–Russian seminars (every third year since 1989) on the field (‘Chemistry and Ecology of Organo-Element Compounds’). He prompted us especially to search properties and environmental fates for various polyhalogen compounds. We remember him for his friendly character and great sense of humor.     

PHYSICAL PROCESSES AND EUTROPHICATION1

ABSTRACT: Biological responses to physical-chemical processes were examined in Toronto and Hamilton Harbours of Lake Ontario. Nutrient loadings to the harbors are large and are of similar magnitude, yet the trophic conditions of the harbors were considerably different. Lake oscillations were found to determine the flushing rates and environmental stability of the harbors. LOW residence times (<10 days) resulted in homogenous chemical conditions in Toronto Harbour, and prevented the establishment of large phytoplankton crops. The longer retention time of Hamilton Harbour permitted the establishment of huger phytoplankton crops. There probably exists a critical retention time where nutrient input events persist for a sufficient period of time for the algal community to adapt to and exploit the environmental conditions of nearshore areas.     

废催化剂浸出规律的静态实验方法

利用静态浸出实验方法对废催化剂中重金属在不同固水比和浸出次数条件下的浸出规律进行了系统研究。实验发现浸出次数大于３次后,重金属的浸出浓度和浸出速率趋于稳定,同时固水比的增加也没有明显改变废催化剂中重金属的浸出。认为在浸取次数大于３次以后,随着表面溶质的溶解,浸出过程主要为内扩散所控制。     

水样中镉镍的两次双波长分光光度法测定

研究采用两次双波长分光光度法 ,一次采用双峰双波长法 ,一次采用系数补偿法同时测定水样中的镉和镍。实验结果表明 ,以 5 Br PADAP为显色剂 ,镉和镍的最大吸收峰分别为 544 .8nm和 559.2nm ,最小吸收峰均为 430nm ;镉镍的线性范围为 1～ 1 6μg/ 2 5mL。此法的灵敏度同单波长法相比有明显的提高 ,应用于合成和电镀水样中的镉镍的测定 ,均得到了满意的结果。     

填埋场垃圾堆体斜面压实工程试验研究

通过现场工程试验对填埋垃圾堆体斜面压实效果进行了影响因素的研究．试验证明：在垃圾填埋作业过程中，压实机械对填埋垃圾堆体斜面压实的效果受垃圾堆体斜面坡度、垃圾堆体构造层厚度、压实机械行程次数以及压实机械的行驶方向等因素影响显著．实验结果表明：为取得最佳的垃圾堆体斜面压实效果，斜面最佳坡度在1：5～1：4之间，最佳垃圾摊铺厚度在0．6m～0．7m之间，最佳机械行程次数为3次，压实机械的行驶方向为坡下向坡上．