固氮鱼腥藻Anabaena sphaerica和念珠藻Nostoc muscorum对有机氯农药林丹的降解效应和机理

研究了固氮鱼腥藻A.sphaerica和念珠藻N.muscorum对林丹(γ-HCH)的降解效应及机理.结果表明,在初始藻种叶绿素含量约为37mg·L-1,林丹起始浓度均为0.2mg·L-1条件下,A.sphaerica和N.muscorum均能明显降解林丹,5d降解率分别为66.1%和69.5%,其降解半衰期分别为3.19和3.23d.在培养过程中,0.2mg·L-1林丹并不会抑制两种固氮藻的生长,培养5d后,叶绿素a的含量分别增加0.82倍和1.36倍.升高温度和增强光照均能增加林丹的降解率.相对于N2,NaNO3作为唯一氮源更能刺激固氮蓝藻对林丹的降解,对于A.sphaerica和N.muscorum,其对林丹的5d降解率分别增加44.6%和40.5%.气质联用检测结果表明,脱去HCl生成γ-五氯环己烯是两种固氮蓝藻降解林丹的主要脱氯分子机理.     

Pd-Ni/GC电极电化学还原水中三氯甲烷的研究

通过电沉积法在玻碳板(GC)电极上负载钯镍双金属,并利用正交实验对其进行循环伏安(CV)研究. CV结果表明,钯镍双金属比钯、镍单金属具有更大的氢吸附峰值,可以在- 500 mV(以Hg/Hg2SO4 为参比电极)左右获得- 24.83 mA的氢吸附峰.扫描电镜分析(SEM)表明,镍的加入改变了钯颗粒在GC表面的分布形态,钯镍双金属颗粒形貌明显不同于钯、镍单金属颗粒,钯镍双金属颗粒粒径介于钯、镍单金属颗粒粒径之间.实验考察了脱氯电流、脱氯时间对三氯甲烷去除率的影响.三氯甲烷的去除率随脱氯电流的增大而增大,随脱氯时间的延长而提高.在优化条件下制备的Pd-Ni/GC电极在0.5 mA、180 min的脱氯条件下对三氯甲烷的去除率为42.53%.可以推测,随着脱氯时间的继续延长,三氯甲烷去除率可得到进一步提高.     

Degradation of chlorinated phenols by nanoscale zero-valent iron

Chlorophenols (CPs), as important contaminants in groundwater, are toxic and difficult to biodegrade. Recently nanoscale zero-valent iron received a great deal of attention because of its excellent performance in treating recalcitrant compounds. In this study, nanoscale zero-valent iron particles were prepared using chemical reduction, and the reductive transformations of three kinds of chlorinated phenols (2-CP, 3-CP, and 4-CP) by nanoscale zero-valent iron under different conditions were investigated. The transformation process of the CPs was shown to be dechlorination first, then cleavage of the benzene ring. The removal efficiency of the CPs varied as follows: 2-CP > 3-CP > 4-CP. The reactivity of CPs was associated with their energy of lowest unoccupied molecular orbit (E _LUMO). With the increase in initial concentrations of CPs, removal efficiency decreased a little. But the quantities of CPs reduced increased evidently. Temperature had influence on not only the removal efficiency, but also the transformation pathway. At higher temperatures, dechlorination occurred prior to benzene ring cleavage. At lower temperatures, however, the oxidation product was formed more easily. __________ Translated from China Environmental Science, 2006, 26(6): 698–702 [译自: 中国环境科学]     

Decomposition of hexachlorobenzene over Al2O3 supported metal oxide catalysts

Decomposition of hexachlorobenzene(HCB)was investigated over several metal oxides(i.e.,MgO,CaO,BaO,La2O3,CeO2,MnO2, Fe2O3,and Co3O4)supported on Al2O3,which was achieved in closed system at a temperature of 300°C.Catalysts were prepared by incipient wetness impregnation with different metal oxides loading and impregnating solvents.The decomposition effciency of different catalysts for this reaction depends on the nature of the metal oxide used,and Al2O3 supported La2O3 was found to be the most active one.Pe...     

Radiolysis of pentachlorophenol (PCP) in aqueous solution by gamma radiation

Steady-state radiolysis experiments were performed to investigate the γ-irradiation treatment of pentachlorophenol (PCP) in aqueous solution. The e?ect of initial concentration on the PCP degradation was also investigated. The experimental results showed that γirradiation was able to degrade PCP in aqueous solution successfully, and the radiolytical degradation process of PCP could be described by the first-order kinetic model. When the initial concentration of PCP was 25 and 50 mg/L and the radiation dose ...     

二氧化钛脱除高温烟气中的氯化氢

HCl是城市垃圾焚烧产生的主要气体污染物之一。将一种新型脱氯剂TiO2引入到垃圾焚烧系统中,并与其他脱氯剂的性能进行比较。研究了不同脱氯剂使用量、不同反应温度和不同HCl气体浓度对TiO2、CaO和CaTiO3脱氯效果的影响。结果显示,TiO2能在高温(800~1 000℃)、高HCl浓度(1 303.6~1 629.5 mg/m3)下获得较好的脱氯效果。与传统的脱氯剂CaO相比,TiO2更适合于高温烟气脱氯,其在1 000℃时的氯容(36.3 mg HCl/g TiO2)几乎是相同情况下的CaO氯容(9.3 mg HCl/g CaO)的4倍。而CaTiO3的脱氯效果不但受到自身分解效率的影响,还受到TiO2和CaO脱氯效果的影响,其脱氯效果较差。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺，氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时，在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下，处理后废酸中的氯离子质量浓度为0.22 g/L，氯离子去除率为98.59%，铜离子质量浓度为0.45 g/L，铜离子去除率为95.08%，其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

有机蒙脱石负载纳米铁去除溶液中四溴双酚A的研究

研究了改性蒙脱石负载纳米铁材料(NZVI-CMT)在甲醇-水体系中对四溴双酚A(TBBPA)的去除作用,并确定了反应温度、TBBPA初始浓度以及材料投加量等因素对去除效果的影响.结果表明,在25℃条件下,0.02 g NZVI-CMT对初始浓度为10 mg·L-1TBBPA溶液的去除率可达97.5%,而且NZVI-CMT对TBBPA的去除率明显高于两种单一材料即纳米零价铁(NZVI)及有机蒙脱石(CMT)的去除率(18.3%、67.3%),同时也大于两者之和(85.6%).利用NZVI-CMT对TBBPA进行重复去除实验时,前3次的去除率均可达到90%以上.通过检测降解产物并分析材料对TBBPA去除过程的特性,发现NZVI-CMT对TBBPA的去除以吸附为主,并伴有少量还原脱溴反应发生,而且较高的反应温度对降解反应有利.     

EDTA优化纳米Pd/Fe对2,4-D的催化脱氯研究

采用EDTA优化纳米Pd/Fe催化脱氯水中2,4-二氯苯氧乙酸(2,4-D),并考察了EDTA投加浓度、pH、钯化率、温度等因素对2,4-D还原的影响.结果表明,EDTA的加入络合了纳米Pd/Fe在催化脱氯过程中生成的铁离子,抑制纳米Pd/Fe颗粒表面钝化层的形成,提高了体系的反应活性.适宜的EDTA浓度、低pH、高钯化率、低温等有利于2,4-D的还原脱氯.当EDTA浓度为25.0 mmol·L-1,纳米铁含量为1.0 g·L-1,初始pH=4.3、钯化率为0.5%,温度为25.0℃,搅拌速率为200 r·min~(-1)时,反应50 min,10.0 mg·L-1的2,4-D去除率及苯氧乙酸(PA)生成率均达到100%.     

金属氧化物降解六氯苯的活性比较及催化机理研究

以氧化铝(α-Al_2O_3、γ-Al_2O_3)、氧化钙(CaO)、过渡金属氧化物(Mn O_2、α-Fe_2O_3、γ-Fe_2O_3、Ni_2O_3、CuO)为催化剂,考察了催化剂种类、添加比例等因素对六氯苯(Hexachlorobenzene,HCB)降解效果和产物组分的影响.结果表明,催化效果随催化剂添加比例的提高显著增加.在反应温度为350℃,反应时间1 h,金属氧化物添加比例为100∶1的条件下,碱土金属氧化物CaO及过渡金属氧化物中的α-Fe_2O_3和Ni_2O_3降解活性较好,这3种氧化物对HCB的降解率分别达到65.5%、100.0%和100.0%,脱氯率D_1分别为54.4%、81.9%和77.5%.HCB降解有机产物分析结果显示,8种金属氧化物与HCB样品反应产物中均存在低氯代苯,在α-Fe_2O_3和Ni_2O_3的催化作用下有2~4氯代低氯苯检出,说明在降解过程中存在明显的逐级脱氯/加氢反应;与CaO反应后的产物中低氯代苯较少,经拉曼光谱定性分析,有无序碳的检出,说明除了脱氯/加氢还存在脱氯缩合反应.