复合混凝剂用于夏季太湖水混凝脱浊研究

用特征粘度系列化的聚二甲基二烯丙基氯化铵(PDM)与聚合氯化铝(PAC)复合得到稳定的复合混凝剂,用于夏季高藻太湖水强化混凝脱浊处理.通过混凝烧杯实验.考察了无机/有机复合比例、PDM特征粘度对脱浊效果及絮团沉淀性能的影响.结果表明,对浊度为30-33 NTU,温度为28～30℃,藻含量为2.6×107个儿的太湖水,在与某市水厂混凝强度相近的搅拌强度下.当达到该水厂2NTU沉淀池出水的余浊标准时,PAC需7.00 mg/L的投加量.质量复合比例为5:1、10:1、20:1的PAC(以Al2O3计)/PDM复合混凝剂所需PAC投加量随PDM特征粘度0.52、1.53、2.46 dL/g的增加分别为3.00-2.83 ms/L、3.50-3.49ms/L、5.37-4.67 mg/L,相对于PAC减少投加量57.14%-59.57%、50%-50.14%、23.29%-33.29%;作为深度处理的技术准备.当沉淀出水浊度要求提高至1NTU的情况下,复合药剂依然可发挥好的作用,PAC需10 mg/L的投加量,PAC(以Al2O3计)与PDM质量复合配比为20:1、10:1、5:1的复合混凝剂需8.33-3.91 mg/L的投加量,能比PAC减少投加量16.7%～60.9%.可见,PDM明显提高了PAC的混凝脱浊效果与沉淀性能,且PAC/PDM质量复合配比越低,PDM特征粘度越高,脱浊效果与沉淀性能越好.     

化学混凝法强化城市污水一级处理的研究

对化学混凝法强化洛阳市涧西城市污水一级处理的效果进行了初步研究.实验中选择几种常用的混凝剂FeCl3、Al2(SO4)3、PAC、PFS和PAM,通过实验结果以及处理费用的比较,最终确定最佳混凝剂为聚合硫酸铁(PFS),且去浊率和CODCr去除率都较好,分别为98.29%和66.36%;其投药量为233 g/m3,处理费用为0.419 4元/t.     

PAS-PDMDAAC复合混凝剂研究

以Al2（SO）4和PDMDAAC为原料进行了无机-有机复合絮凝剂的复合实验研制,确定其制备工艺条件,并对油田现场采集的钻井废水作絮凝沉降实验,所研制的PAS-PDMDAAC复合絮凝剂对COD的去除效率可大大提高.     

絮凝沉降技术在水处理中的应用研究

絮凝沉降技术在水处理工艺中是一项广泛应用的技术。它不仅可用于给水处理,还可用于工业废水处理。许多工业废水经絮凝澄清后可返回工艺过程使用。这样不仅充分利用了水资源,而且有利于保护环境,因而有明显的经济社会效益。本研究采用明矾(硫酸铝钾KAl(SO4)2.12H2O)作混凝剂,用云龙湖小南湖水分析表明,加混凝剂前,总悬浮物含量为260mg/l,加混凝剂后,总悬浮物含量为52mg/l,比原来降低了80%,絮凝澄清效果较好,而且药剂消耗费用低,经济、社会效益显著。     

PFS-PDM复合混凝剂对微污染河水的强化混凝处理

用聚合硫酸铁(PFS)和聚二甲基二烯丙基氯化铵(PDM)制备了复合混凝剂—聚合硫酸铁-聚二甲基二烯丙基氯化铵(PFS-PDM),并对微污染的流溪河水源水进行了强化混凝处理,对比分析了复合混凝剂与PFS2种处理的混凝效果.结果表明,与单独用PFS相比,用复合混凝剂处理冬季微污染流溪河水源水时,其对浊度、UV254及藻类去除能力更强;当投加量为3mg/L(以Fe计)时,PFS-PDM复合混凝剂的去浊率、除藻率和UV254去除率,分别提高22.1%、19.5%、14.9%,表现出优良的强化混凝效果.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

赤泥制备含钛聚硅酸铝铁及亚甲基蓝溶液的混凝脱色

以拜耳法赤泥为原料、Na Cl为助溶剂,采用酸浸法溶出赤泥中的铁、铝元素,再与硅酸钠、硫酸氧钛反应制备出高效混凝剂含钛聚硅酸铝铁(T-PSAF),并将其用于模拟亚甲基蓝印染废水的脱色。实验结果表明:在硫酸浓度为8 mol/L、液固比(硫酸体积与干赤泥质量之比)为14 m L/g、酸浸温度为80℃、酸浸时间为80 min、Na Cl加入量为0.10 g/g(以干赤泥计)的优化酸浸条件下,铁、铝的浸出率分别为88.25%和73.21%;在n(Fe+Al)∶n(Ti)∶n(Si)=0.3∶0.3∶1、熟化p H为4~5、熟化时间为2 h、混凝剂加入量为25 m L/L的优化混凝条件下,初始亚甲基蓝质量浓度为10 mg/L的废水的脱色率可达87.1%,而当初始亚甲基蓝质量浓度增至150~200 mg/L时废水脱色率可达99%以上。     

聚合铁钛混凝剂对印染废水的处理

采用钛铁矿为主要原料,以硫酸溶出部分铁和钛,并调节Ti/Fe比、碱化度制备高效的新型含钛聚合硫酸铁混凝剂(T-PSF),将其用于分散兰和活性黄2种模拟印染废水的脱色处理并研究其混凝去除机理。实验结果表明,在Ti/Fe为1∶6和碱化度为2.0时,制备出的T-PSF混凝效果最好。T-PSF对分散兰的去除率为94.3%,比FeCl_3的去除率提高53.8%;对活性黄的去除率为34.0%,比FeCl_3提高12.7%。T-PSF处理分散兰和活性黄的最佳投加量均为0.3 mmol·L~(-1),最佳水样初始pH分别为6和8。絮体粒径及结构分析结果表明,T-PSF处理分散兰过程中形成的絮体粒径较FeCl_3大,处理活性黄过程中所形成的絮体粒径较FeCl_3小,但絮体结构均比FeCl_3更密实。结合T-PSF的表征、Zeta电位及絮体特性分析表明,在分散染料去除过程中,T-PSF产生的多羟基钛铁聚合物的电中和及吸附架桥起主要作用;对于活性染料的去除,主要机制为T-PSF水解产生的带正电的多羟基钛铁聚合物的吸附络合作用。     

Efficacy of two chemical coagulants and three different filtration media on removal of Aspergillus flavus from surface water

Aquatic fungi are common in various aqueous environments and play potentially crucial roles in nutrient and carbon cycling as well as interacting with other organisms. Species of Aspergillus are the most common fungi that occur in water. The present study was undertaken to elucidate the efficacy of two coagulants, aluminum sulfate and ferric chloride, used at different concentrations to treat drinking water, in removing Aspergillusflavus, as well as testing three different filtration media： sand, activated carbon, and ceramic granules, for their removal of fungi from water. The results revealed that both coagulants were effective in removing fungi and decreasing the turbidity of drinking water, and turbidity decreased with increasing coagulant concentration. Also, at the highest concentration of the coagulants, A. flavus was decreased by 99.6% in the treated water. Among ceramic granules, activated carbon, and sand used as media for water filtration, the sand and activated carbon filters were more effective in removing A.flavus than ceramic granules while simultaneously decreasing the turbidity levels in the test water samples. Post-treatment total organic carbon （TOC） and total nitrogen （TN） concentrations in the experimental water did not decrease; on the contrary, TN concentrations increased with the increasing dosage of coagulants. The filtration process had no effect in reducing TOC and TN in tested water.     

混凝调理印染污泥脱水研究

通过对佛山市某工业园集中式印染污水处理厂的污泥进行调查和研究,分别考察了单独使用聚合氯化铝(PAC)、聚丙烯酰胺(CPAM)以及两种混凝剂联合使用调理印染污泥效果。实验表明:使用单一调理剂PAC、CPAM时,污泥离心脱水后含水率分别为89.02%和84.88%。经真空抽滤,测得污泥比阻为3.46×1012,0.687×1012m/kg,所得泥饼含水率分别为77.04%和75.24%。使用两种混凝剂联合调理印染污泥,离心后污泥含水率为86.18%。真空抽滤脱水后,污泥比阻为6.007×1012m/kg,滤饼含水率为75.28%。因此针对该污水厂产生的印染污泥,优选投加CPAM,投加量为50 mg/L。