贵阳市大气细颗粒物中多环芳烃时空分布特征

对贵阳市不同功能区在不同季节大气PM_(2.5)中多环芳烃(PAHs)进行了采样观测,利用UVD和FLD双检测器串联HPLC法分析了16种优控PAHs。结果显示,在贵阳市主城区PM_(2.5)中PAHs有检出,5个采样点全年ρ(∑PAHs)为4. 44～114 ng/m~3,平均值为24. 96 ng/m~3,其值呈现出夏季最低冬季最高的特征,各个功能区在不同季节ρ(PAHs)不同,大小趋势也不同;四季PAHs单体中均以4-6环为主,占ρ(∑PAHs)的68%以上; PAHs来源解析结果显示,贵阳市大气PM_(2.5)中PAHs来源具有明显的季节特征,春、夏和秋季主要来源是石油燃烧排放,兼有少量的生物质燃烧排放,冬季PAHs主要来源是燃煤和石油燃烧排放。PM_(2.5)中PAHs毒性评价结果表明,贵阳市大气中PAHs的春季、夏季和秋季健康风险较小,冬季健康风险较大。四季各功能区ρ(Ba P)大部分均低于《环境空气质量标准》(GB 3095—2012)规定限值(2. 50 ng/m~3),但冬季除背景点外,其他监测点均超标,最大超标倍数为3. 80倍。     

地下水中苯系物污染修复研究进展

苯系物(苯、甲苯、乙苯和二甲苯,BTEX)是重要的环境污染物之一。BTEX高溶解,高挥发,高毒性的特点使其成为地下水污染关注的特点。强调了地下水中苯系物的来源及相关性质,总结了治理苯系物的历史应用技术,介绍了新兴修复技术并展望了未来的发展方向,为地下水中苯系物的处理提供借鉴。     

锐钛矿-金红石混合晶型TiO2降解气相苯

用溶胶-凝胶法并通过控制煅烧温度合成不同晶相比的混合晶型纳米TiO_2,在紫外光光照下降解气相苯。考察了苯初始质量浓度、紫外灯光照强度和催化剂加入量对苯去除率的影响;探究了光催化降解气相苯的动力学特征。结果表明:450℃煅烧制备的催化剂降解苯效率最高,此催化剂金红石相质量分数为6.30%;在苯初始质量浓度为74.39 mg/m~3、催化剂加入量为7 g、光照强度为2.18 klux的最佳条件下反应84 min,苯去除率达99.73%;光催化降解率与光照强度之间符合0.5级动力学特征;当催化剂加入量为3 g时,单位时间单位质量催化剂降解苯的质量最多;苯的光催化降解反应均符合一级动力学方程。     

石化企业苯类物质非密闭操作过程的职业暴露分析

采用职业卫生学调查和职业暴露风险评估方法,对选定的苯类物质非密闭操作过程较集中的芳烃装置进行职业暴露分析和评估,为石化企业苯类物质的健康风险控制提供依据。     

顶空毛细柱气相色谱法测定水中七种苯系物研究

选用Elite-FFAP色谱柱,利用顶空-毛细柱气相色谱技术对水中的苯、甲苯、乙苯、对二甲苯、间二甲苯、邻二甲苯、苯乙烯七种挥发性苯系物进行同时测定,并对样品的平衡温度、保温时间、程序升温的条件控制、水中含盐量等影响因素进行了探讨,优化了检测条件,使七种挥发性苯系物得到不错的分离。样品平衡温度控制在70℃,样品平衡时间19 min,进样口温度180℃,检测器温度230℃,10 mL水样中加入4 g NaCl的条件下,分离效果最佳。     

试析气相色谱法测定环境空气中苯系物的要点

随着我国城市化进程的不断加快,我国的环境污染问题越来越严峻。苯系物作为空气污染物中的重要一种,其对人体的健康有着非常大的危害。本文从气相色谱法测定环境空气中苯系物浓度的原理及方法出发,对影响测定结果的因素进行了分析。     

环境空气中苯系物污染物的快速定量研究

本文采用便携式GC/MS仪器对大气中痕量苯系物污染物的快速定量分析进行研究。对比实验结果表明,全扫描和选择离子扫描两种扫描方式下苯系物测定结果的相对标准偏差分别在5.1%²8.4%和13%28.4%和13%¹9%之间,回收率范围分别为46%19%之间,回收率范围分别为46%¹86%和60%186%和60%¹10%,方法检出限范围分别为2.504110%,方法检出限范围分别为2.504¹0.63 ug/m3和0.49410.63 ug/m3和0.494².399 ug/m3。总体而言,选择离子扫描方式在测定结果的精密度与准确度上均优于全扫描方式。     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.