微生物菌剂在包头市外五区生活垃圾处理上的应用前景

通过对包头市外五区生活垃圾处理现状分析,对垃圾腐解过程中,微生物的作用进行研究,探讨了生活垃圾处理菌剂在外五区生活垃圾处理上的可行性与适应性,为解决该地区生活垃圾的快速无害化处理提供思路。     

甲烷氧化菌在填埋场覆盖层中的工程应用(Ⅱ):基质选择性及长效性

针对已筛选获得的甲烷氧化混合菌,选取填埋场覆盖土(LCS)、矿化垃圾(AR)和塘渣(TZ)3种填埋场周边易得的材料为供试生存基质,从基质选择性及长效性角度进行了甲烷减排应用条件的探究及使用效能评估.结果表明,在TZ、LCS、AR、TZ-AR和LCS-AR这5种生存基质中,TZ-AR最适合甲烷氧化混合菌的生长,且TZ与AR的复配比例以5∶5为最佳.甲烷氧化混合菌在TZ-AR的粒径≤4 mm和含水率为20%时具有最高甲烷氧化能力.一次性接种甲烷氧化混合菌在静态体系中的最佳使用有效期为31 d.其在接种量为0.08、0.16、0.20 m L·g-1和0.25m L·g-1时甲烷氧化速率无明显差异,从工程应用角度而言,8%的接种量为最佳.     

渗滤液耦合矿化垃圾制备甲烷氧化菌菌液

利用甲烷氧化菌菌液增加材料中甲烷氧化菌的数量,可以得到高甲烷氧化率的填埋场甲烷生物氧化覆盖材料。研究发现,渗滤液原水和渗滤液处理尾水均能促进甲烷氧化菌的生长,可利用渗滤液耦合矿化垃圾混合培养制备甲烷氧化菌菌液用于填埋场甲烷减排。填埋龄长的渗滤液原水有着较好的培养效果,得到的菌液在4 d内最高甲烷氧化速率达到2.68 mL/h,超过甲烷氧化菌培养液(nitrate minimal salt medium,NMS)的实验结果。渗滤液中总氮、无机碳、总有机碳和Ni元素的含量对甲烷氧化菌的培养过程影响较大,适用于甲烷氧化培养的渗滤液应满足:总氮1 400 mg/L,总有机碳55 mg/L,Ni元素0.4 mg/L,总磷含量较高。     

矿化垃圾中的微生物区系与酶活性变化特征研究

选择某市郊城市生活垃圾填埋场为研究对象,对填埋时间分别达6、8、10年的矿化垃圾中的微生物区系与酶活性变化特征进行了比较。结果表明,表层(0～50 cm)和底层(100～150 cm)矿化垃圾中的微生物数量和酶活性变化幅度大于中层(50～100cm);填埋达6、8、10年后的各层矿化垃圾中的细菌数量明显低于对照,放线菌数量则明显高于对照,而真菌数量在表层和中层中高于对照或与对照相当,在底层则低于对照,各层中的脲酶、碱性磷酸酶、碱性磷酸酶活性则明显高于对照或与对照相当;总体来说,相同填埋深度的矿化垃圾中,填埋达6～8年的细菌、真菌、放线菌数量和脲酶、碱性磷酸酶、酸性磷酸酶活性的变化幅度要大于填埋8～10年的,且均在填埋8～10年趋于稳定。     

DOC/CCRT老化对柴油公交车气态物排放特性的影响

基于重型底盘测功机,研究新鲜及老化氧化型催化器(DOC)、氧化型催化器耦合催化型颗粒捕集器(DOC+CDPF,CCRT)对在用国Ⅲ柴油公交车进行中国典型城市公交车循环CCBC时一氧化碳(CO)、总碳氢化合物(THC)、一氧化氮(NO)、二氧化氮(NO_2)和氮氧化物(NO_x)、二氧化碳(CO_2)等气态物排放特性的影响.结果表明:采用新鲜及老化DOC/CCRT,均可以降低CO、THC、NO排放,增加NO_2排放,NO_x及CO_2排放基本不变;在怠速、加速、减速及匀速这4种工况下,新鲜DOC比老化DOC对CO、THC氧化效率好,新鲜CCRT比老化CCRT对THC氧化效率好,但老化CCRT对CO氧化效率更好,新鲜DOC/CCRT比老化DOC/CCRT对NO减少幅度高,对NO_2增加幅度高,但对NO_x排放总量基本无影响.     

两段式进水两级矿化垃圾反应器处理中晚期垃圾渗滤液

针对矿化垃圾反应器处理中晚期垃圾渗滤液时由于反硝化区缺少碳源而导致总氮去除率不佳的问题,开展以优先利用原水中的有机物充当碳源为目的的两段式进水两级矿化垃圾反应器处理工艺的研究。通过控制反应器的曝气量、好氧区和反硝化区,研究了两段式进水两级矿化垃圾反应器处理垃圾渗滤液的效果。结果表明,当进水渗滤液水力负荷为46.0 L/(m~3·d)时,在第一级反应器底部曝气量为1.86 m~3/(m~3·d),第二级反应器中上部曝气量为0.37 m~3/(m~3·d)的条件下,COD、NH_4~+-N、TP的平均去除率分别为84.1%、92.6%、85.6%,运行稳定后TN平均去除率达76.0%,处理效果较好。     

生活垃圾焚烧处理技术发展分析

综述了国内外的城市生活垃圾焚烧处理概况,探讨了生活垃圾焚烧处理与环境的关系,介绍了生活垃圾焚烧处理工艺,并对我国生活垃圾焚烧处理技术现状进行了分析。     

利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse de-rived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。     

Energy efficacy used to score organic refuse pretreatment processes for hydrogen anaerobic production

The production of hydrogen through Anaerobic Digestion (AD) has been investigated to verify the efficacy of several pretreatment processes. Three types of waste with different carbon structures have been tested to obtain an extensive representation of the behavior of the materials present in Organic Waste (OW). The following types of waste were selected: Sweet Product Residue (SPR), i.e., confectionary residue removed from the market after the expiration date, Organic Waste Market (OWM) refuse from a local fruit and vegetable market, and Coffee Seed Skin (CSS) waste from a coffee production plant. Several pretreatment processes have been applied, including physical, chemical, thermal, and ultrasonic processes and a combination of these processes. Two methods have been used for the SPR to remove the packaging, manual (SPR) and mechanical (SPRex). A pilot plant that is able to extrude the refuse to 200 atm was utilized. Two parameters have been used to score the different pretreatment processes: efficiency (ξ), which takes into account the amount of energy produced in the form of hydrogen compared with the available energy embedded in the refuse, and efficacy (η), which compares the efficiency obtained using the pretreated refuse with that obtained using the untreated refuse. The best result obtained for the SPR was the basic pretreatment, with η = 6.4, whereas the thermal basic pretreatment gave the highest value, η = 17.0 for SPRex. The best result for the OWM was obtained through a combination of basic/thermal pretreatments with η = 9.9; lastly, the CSS residue with ultrasonic pretreatment produced the highest quantity of hydrogen, η = 5.2.     

Fate and availability of glyphosate and AMPA in agricultural soil

The fate of glyphosate and its degradation product aminomethylphosphonic acid (AMPA) was studied in soil. Labeled glyphosate was used to be able to distinguish the measured quantities of glyphosate and AMPA from the background values since the soil was sampled in a field where glyphosate had been used formerly. After addition of labeled glyphosate, the disappearance of glyphosate and the formation and disappearance of AMPA were monitored. The resulting curves were fitted according to a new EU guideline. The best fit of the glyphosate degradation data was obtained using a first-order multi compartment (FOMC) model. DT₅₀ values of 9 days (glyphosate) and 32 days (AMPA) indicated relatively rapid degradation. After an aging period of 6 months, the leaching risk of each residue was determined by treating the soil with pure water or a phosphate solution (pH 6), to simulate rain over a non-fertilized or fertilized field, respectively. Significantly larger (p < 0.05) amounts of aged glyphosate and AMPA were extracted from the soil when phosphate solution was used as an extraction agent, compared with pure water. This indicates that the risk of leaching of aged glyphosate and AMPA residues from soil is greater in fertilized soil. The blank soil, to which 252 g glyphosate/ha was applied 21 months before this study, contained 0.81 ng glyphosate/g dry soil and 10.46 ng AMPA/g dry soil at the start of the study. Blank soil samples were used as controls without glyphosate addition. After incubation of the blank soil samples for 6 months, a significantly larger amount of AMPA was extracted from the soil treated with phosphate solution than from that treated with pure water. To determine the degree of uptake of aged glyphosate residues by crops growing in the soil, ¹⁴C-labeled glyphosate was applied to soil 6.5 months prior to sowing rape and barley seeds. After 41 days, 0.006 ± 0.002% and 0.005 ± 0.001% of the applied radioactivity was measured in rape and barley, respectively.