微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

Ru/AC催化臭氧氧化难生物降解有机物

研究了臭氧单独氧化和Ru/AC催化臭氧氧化DMP、酚类物质和消毒副产物前体物.结果表明,Ru/AC能显著提高臭氧氧化中有机物的矿化效果.在DMP降解中,反应100 min后TOC的去除率由单独臭氧氧化的28.84%提高到66.13%.在23种酚类物质降解中,反应60min后TOC的去除率由单独臭氧的9.57%~56.08%提高到41.81%~82.32%.相对于单独臭氧,Ru/AC催化臭氧氧化更能有效地降低水源水中消毒副产物的生成势,以卤乙酸生成势的降低最为明显,100 min后卤乙酸生成势由144.02μg/L降到58.50μg/L,低于美国环保局规定的限制浓度60μg/L.而使用单独臭氧处理并不能使卤乙酸生成势降到符合美国EPA的规定.比较了BAC、O3+BAC、O3/AC+BAC以及Ru/AC+O3+BAC工艺处理水源水的效果,TOC平均去除率分别为3.80%、20.14%、27.45%和48.30%;COD平均去除率分别为4.37%、27.22%、39.91%和50.00%;UV254去除率分别为8.16%、62.24%、67.03%和84.95%.Ru/AC+O3+BAC工艺相比其他工艺,更能有效地...     

二甲基甲酰胺中毒研究进展

介绍了二甲基甲酰胺(DMF)在人体的代谢、毒性作用和临床表现,以及DMF职业接触标志物的研究进展。     

Potential particulate pollution derived from UV-induced degradation of odorous dimethyl sulfide

UV-induced degradation of odorous dimethyl sulfide (DMS) was carried out in a static White cell chamber with UV irradiation. The combination of in situ Fourier transform infrared (FT-IR) spectrometer, gas chromatograph-mass spectrometer (GC-MS), wide-range particle spectrometer (WPS) technique, filter sampling and ion chromatographic (IC) analysis was used to monitor the gaseous and potential particulate products. During 240 min of UV irradiation, the degradation e ciency of DMS attained 20.9%, and partially oxidized sulfur-containing gaseous products, such as sulfur dioxide (SO2), carbonyl sulfide (OCS), dimethyl sulfoxide (DMSO), dimethyl sulfone (DMSO2) and dimethyl disulfide (DMDS) were identified by in situ FT-IR and GC-MS analysis, respectively. Accompanying with the oxidation of DMS, suspended particles were directly detected to be formed by WPS techniques. These particles were measured mainly in the size range of accumulation mode, and increased their count median diameter throughout the whole removal process. IC analysis of the filter samples revealed that methanesulfonic acid (MSA), sulfuric acid (H2SO4) and other unidentified chemicals accounted for the major non-refractory compositions of these particles. Based on products analysis and possible intermediates formed, the degradation pathways of DMS were proposed as the combination of the O(1D)- and the OH- initiated oxidation mechanisms. A plausible formation mechanism of the suspended particles was also analyzed. It is concluded that UV-induced degradation of odorous DMS is potentially a source of particulate pollutants in the atmosphere.     

Carbonyl sulfide and dimethyl sulfide fluxes in an urban lawn and adjacent bare soil in Guangzhou, China

Carbonyl sulfide (COS) and dimethyl sulfide (DMS) fluxes from an urban Cynodon dactylon lawn and adjacent bare soil were measured during April–July 2005 in Guangzhou, China. Both the lawn and bare soil acted as sinks for COS and sources for DMS. The mean fluxes of COS and DMS in the lawn (–19.27 and 18.16 pmol/(m2 sec), respectively) were significantly higher than those in the bare soil (–9.89 and 9.35 pmol/(m2 sec), respectively). Fluxes of COS and DMS in mowed lawn were also higher than those in bare soils. Both COS and DMS fluxes showed diurnal variation with detectable but much lower values in the nighttime than in the daytime. COS fluxes were related significantly to temperature and the optimal temperature for COS uptake was 29°C. While positive linear correlations were found between DMS fluxes and temperature. COS fluxes increased linearly with ambient COS mixing ratios, and had a compensation point of 336 ppt.     

Al2O3催化臭氧化处理邻苯二甲酸二甲酯

'Al₂O₃催化剂对邻苯二甲酸二甲酯(DMP)溶液臭氧化过程的影响结果表明:Al₂O₃可以显著提高臭氧氧化的效果,反应120min后,TOC的去除率从单独臭氧氧化的23.9%提高到55.1%.实验中还考察了制备条件对Al₂O₃催化剂活性的影响并确定了反应的最佳工艺条件.在实验考察的范围内:焙烧温度600℃,Al₂O₃粒径为0.5～1.0mm时催化活性最高;最佳反应工艺条件为:催化剂投加量20g/L,混和气体流速200mL/min,反应温度15℃.通过单独臭氧氧化,单独臭氧氧化后再进行催化剂吸附,催化臭氧化的对比实验证明了Al₂O₃催化剂对体系TOC的去除主要是基于催化作用.     

高铁酸钾对水中藻类及其次生嗅味污染物二甲基三硫醚同步去除研究

模拟高藻期碱性水源水,采用高铁酸钾对水中以颤藻和二甲基三硫醚为代表的藻类及微量嗅味污染物进行同步控制研究.在高铁酸钾与聚合氯化铁(PFC)单独混凝对藻类的控制效果对比的基础上,展开了高铁酸钾与高锰酸钾预氧化-PFC联用方法对藻类及嗅味污染物的控制效果对比,探讨了pH、预氧化时间和浊度等条件对控制效果的影响.结果表明,PFC单独混凝除藻率最高为90.6%,以Fe计的等量投加条件下,高铁酸钾控藻效果较PFC混凝好,除藻率可达92.4%.高锰酸钾对PFC具有强化混凝效果,可明显提高除藻率(94.5%).高铁酸钾较高锰酸钾预氧化对二甲基三硫醚的去除效果理想,且氧化时间大大缩短,高铁酸钾氧化时间1 min可去除92.5%二甲基三硫醚,高于高锰酸钾预氧化10 min后达到的去除率(74.6%).     

活性炭纤维负载TiO2催化剂的制备及其电催化性能

采用溶胶-凝胶法制备了活性炭纤维负载TiO₂催化剂（TiO₂/ACF），并通过SEM和XRD等手段对TiO₂/ACF进行了表征。以邻苯二甲酸二甲酯（DMP）为目标降解物，考察了催化材料的电催化活性。实验结果表明：在反应温度为25 ℃、初始DMP质量浓度为100.0 mg/L、电解质Na₂SO₄质量浓度为100 mg/L、电流密度为62.5 mA/cm²、电极板间距为4 cm的条件下，经过40 min的降解，DMP质量浓度为1.8 mg/L，DMP去除率为98.2%;TiO₂/ACF在反应过程中可以原位再生，经6次重复使用后仍保持很高的催化活性，对DMP的去除率仍达90%以上。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天，DMSO去除率达98.5%，表明MBR内的污泥已驯化成功；在MBR运行的正式期，当DMSO处于高负荷状态时，DMSO去除率较低；随蔗糖加入量的增加，DMSO去除率逐渐提高，最终恢复到DMSO高负荷冲击前的DMSO去除效果；正常运行时，装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L），DMSO去除率为96.4%~99.6%（平均值为98.9%）；在MBR运行的正式期，污泥体积指数小于100 mL/g，表明污泥的沉降性能较好，MLVSS/MLSS较高，表明污泥的活性高，MBR内MLSS的平均值为5.52 g/L，MLVSS的平均值为4.78 g/L；MBR适宜的HRT为12 h。     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。