典型地区农用地污染调查及风险管控标准探讨

针对《土壤污染风险管控标准——农用地土壤污染风险管控标准》(GB 15618—2018),提出以土壤中全量浓度筛选值和管控值作为衡量农用地土壤污染风险管控的标准,对湖南省部分稻田农用地土壤及点对点稻米样品中镉、铅、砷、汞的总量和有效态浓度及稻米中含量进行监测,根据重金属总量浓度分为低风险、中风险、高风险3组。结果显示:(1)土壤及稻米中镉含量基本为随着风险级别的升高而增加,铅、砷在土壤和稻米中含量无规律性结果,汞监测结果均为未检出。(2)低风险组稻米镉超标率为12. 0%,高风险组稻米镉达标率为33. 3%,表明利用总量浓度对农用地土壤潜在风险进行分组存在一定的局限性。(3)依据4种重金属在土壤中总量及稻米(早稻)中含量情况,对风险级别进行调整并综合判断:有58个样品为低风险组,占样品总数的68. 2%,超标率为零;有15个样品为中风险组,占样品总数的17. 7%,超标率为80. 0%;有12个样品为高风险组,占样品总数的14. 1%,超标率为100. 0%。调整后评价结果与上述标准的划分目标更接近,能够提高上述标准的准确性和实用性。     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

Perceived mastery climate,felt trust,and knowledge sharing

Interpersonal trust is associated with a range of adaptive outcomes, including knowledge sharing. However, to date, our knowledge of antecedents and consequences of employees feeling trusted by supervisors in organizations remains limited. On the basis of a multisource, multiwave field study among 956 employees from 5 Norwegian organizations, we examined the predictive roles of perceived mastery climate and employee felt trust for employees' knowledge sharing. Drawing on the achievement goal theory, we develop and test a model to demonstrate that when employees perceive a mastery climate, they are more likely to feel trusted by their supervisors at both the individual and group levels. Moreover, the relationship between employees' perceptions of a mastery climate and supervisor‐rated knowledge sharing is mediated by perceptions of being trusted by the supervisor. Theoretical contributions and practical implications of our findings are discussed.     

萃取法分离回收不锈钢酸洗污泥硫酸浸出液中的重金属

采用非皂化P204和皂化P204萃取剂对不锈钢酸洗污泥的硫酸浸出液进行萃取。在浸出液pH为0.80、非皂化P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取时间为5 min的条件下,Fe~(3+)萃取率达99.64%,Cr~(3+)和Ni~(2+)萃取率为3.98%和6.99%,一次萃余液pH为0.64。采用皂化P204对除Fe~(3+)后的一次萃余液进行萃取,在P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取剂皂化率为60%、一次萃余液pH为1.50、萃取时间为5 min的条件下,Ni~(2+)萃取率为93.12%,Cr~(3+)萃取率为20.69%,二次萃余液pH为2.63。     

交通干道沿线土壤重金属监测与评估综述

公路运营所带来的铅、镉、锌等重金属污染物对人体健康安全存在着潜在和长期的影响。近年来,开展交通干道沿线重金属污染监测与评估工作已经成为环境监测工作的重要内容。从监测技术、评估方法、可能影响因素等几个方面对该领域的研究进展及成果进行了综述。采样段面的选取、点位的布设与样品的收集应该同时遵循全面性和代表性的原则。在同一交通干道内,均匀布置采样段面的同时可以尽量包含高车流量、中车流量与低车流量3种类型。考虑到重金属在横向距离上的分布规律,可以在0~100 m处设置密集采样点位,在100~300 m处设置适量采样点位。评估方法一般同时采用Kriging空间插值分析、污染指数分析、多元统计分析,生态风险评价与健康风险评价等多种分析方法。     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

松花江野生鱼类重金属残留分析与评价

以松花江流域的野生鱼类为研究对象,在松花江流域选取松林、大顶子山、佳木斯3个具有代表性的点位,在2014—2016年的每年5月底6月初采集鲤鱼和鲫鱼样品,3年内共制备45个鲤鱼单样,44个鲤鱼混样,30个鲫鱼混样,共计119个。采用电感耦合等离子体-质谱法对鱼类肌肉组织中残留的As、Cd、Cr、Pb、Hg 5种重金属进行检测。检测结果显示,As、Cd、Cr、Pb、Hg 5种重金属全部检出,检测结果全部达标,达标率为100%。根据检测结果采用单因子指数法和金属污染指数法等评价了松花江流域鱼体重金属残留状况及食用安全性,评价结果为松花江流域鱼类重金属残留量相对较少,鱼体健康,食用安全。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

我国高速公路周边土壤重金属污染现状及研究进展

以我国高速公路周边土壤重金属为研究对象，综述了我国高速公路周边土壤重金属污染特征、影响因素、来源、环境风险及其研究进展。高速公路周边土壤主要受Pb、Cd、Cr、Cu、Zn等重金属污染，主要呈现指数分布、偏态分布和两者混合分布等特点，并且受到土地利用、风向、地形、车流量等多种因素的综合影响。土壤重金属的来源除了受成土母质等自然因素影响以外，公路交通和周边工农业活动也会对其来源产生较大影响。传统的土壤重金属评价方法主要采用单因子指数法、地累积指数法、生态风险评价法等对重金属的污染等级和环境风险进行评价。未来的研究应将重金属形态分析、空间和地统计分析、重金属稳定同位素示踪和源解析模型以及预测模型等多种手段相结合，开展高速公路周边土壤重金属的污染特征、时空分布、来源及预测预警研究等，为我国高速公路沿线工农业生产布局及其土壤重金属污染防控提供科学依据和决策支撑。     

基于双指标多等级的土壤重金属生态风险评价

采用土壤中重金属的全量和有效态双重指标,建立基于多等级综合评估的土壤中重金属生态风险评价模型,将联合概率曲线法引入土壤评价模型,分析重金属暴露浓度与毒性数据的概率分布,考察重金属对土壤生物的毒害程度,从而确定土壤中重金属对于生态系统的风险。建立从简单到复杂的多等级综合评价方法,表征重金属的污染等级、浓度效应、多种重金属污染物的协同效应、不同重金属的毒性效应和土壤对不同重金属污染物的敏感性。选择典型地区采集有代表性的土壤样品,测定不同重金属的总量和有效态,验证评价模型的实用性和评价分级的合理性。旨在解决土壤重金属风险评价的方法学问题,为土壤环境质量管理提供支持。