全文获取类型
收费全文 | 332篇 |
免费 | 44篇 |
国内免费 | 155篇 |
专业分类
安全科学 | 19篇 |
废物处理 | 45篇 |
环保管理 | 21篇 |
综合类 | 226篇 |
基础理论 | 71篇 |
污染及防治 | 115篇 |
评价与监测 | 11篇 |
社会与环境 | 23篇 |
出版年
2023年 | 2篇 |
2022年 | 5篇 |
2021年 | 9篇 |
2020年 | 9篇 |
2019年 | 13篇 |
2018年 | 21篇 |
2017年 | 14篇 |
2016年 | 28篇 |
2015年 | 33篇 |
2014年 | 28篇 |
2013年 | 73篇 |
2012年 | 25篇 |
2011年 | 30篇 |
2010年 | 23篇 |
2009年 | 17篇 |
2008年 | 14篇 |
2007年 | 29篇 |
2006年 | 23篇 |
2005年 | 28篇 |
2004年 | 19篇 |
2003年 | 16篇 |
2002年 | 12篇 |
2001年 | 12篇 |
2000年 | 9篇 |
1999年 | 6篇 |
1998年 | 6篇 |
1997年 | 3篇 |
1996年 | 8篇 |
1995年 | 2篇 |
1994年 | 6篇 |
1993年 | 2篇 |
1992年 | 1篇 |
1991年 | 2篇 |
1990年 | 1篇 |
1989年 | 1篇 |
1988年 | 1篇 |
排序方式: 共有531条查询结果,搜索用时 31 毫秒
1.
选用正十六烷模拟润滑油,通过振荡平衡实验,考察了两种含氮脂肪酸型生物降解促进剂(甲基二乙醇胺油酸酯(MDEAO)和油酸二乙醇酰胺(ODEA))对水土体系中正十六烷吸附行为的影响。实验结果表明:正十六烷在水土体系中的有机质标化分配系数与土壤种类无关,与生物降解促进剂种类有关;土壤对正十六烷的吸附过程更符合Freundlich等温吸附模型;MDEAO的临界胶束浓度为2.0 mg/L,对土壤吸附正十六烷有一定的促进作用,ODEA的临界胶束浓度为0.7 mg/L,形成的胶束对正十六烷的增溶效果明显,促进了正十六烷在土壤中的解吸。 相似文献
2.
采用溶胶-凝胶法,在聚苯乙烯(PS)/CdS核壳纳米颗粒表面包覆致密TiO_2层,制备出具有双壳层结构的PS/CdS/TiO_2纳米复合颗粒,考察了制备条件对材料结构的影响,并利用甲基橙溶液对其光催化性能进行了评价。SEM、TEM、XRD和FTIR分析结果表明,制得的微球单分散性良好,壳层包覆完整,厚度均匀。PS/CdS/TiO_2制备的适宜反应时间为12~18 h,适宜反应pH为7~9。PS/CdS/TiO_2较PS/CdS具有更为优异的可见光催化性能。 相似文献
3.
In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NOx emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NOx and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate. 相似文献
4.
不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解 总被引:1,自引:0,他引:1
高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18%、23%和35%;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2~ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究. 相似文献
5.
6.
采用浸渍法制备了磷钨酸(PW12)/g-C3N4复合光催化剂,并将其用于溶液中甲基橙的光催化降解,运用IR技术对使用前后的光催化剂进行了表征。表征结果显示,PW12和g-C3N4的结构未在浸渍负载中发生改变,且PW12和g-C3N4结合牢固。实验结果表明:最佳的PW12负载量(光催化剂中PW12的质量分数)为50%;光催化降解甲基橙的优化反应条件为初始甲基橙质量浓度5 mg/L、光催化剂加入量0.6 g/L、初始溶液p H=7;在优化条件下,分别采用紫外光、模拟太阳光、可见光照射120 min后,甲基橙的降解率分别为96.59%,82.23%,42.78%;该光催化剂固载良好,使用中不易发生溶脱,稳定性好,可重复使用。 相似文献
7.
采用等体积浸渍法制备了负载型有序介孔Fe-Ce/MCM-41催化剂。研究了该催化剂降解甲基橙的适宜工艺条件,并采用XPS,XRD,TEM技术对该催化剂进行了表征。实验结果表明,该催化剂Fenton氧化降解甲基橙的较适宜工艺条件为:溶液pH 5.0、甲基橙溶液初始质量浓度100 mg/L、催化剂加入量2.0 g/L、H_2O_2浓度20 mmol/L,在此适宜条件下反应120 min时,甲基橙去除率接近100%。表征结果显示:Fe-Ce/MCM-41催化剂主要由铁、铈、氧、碳4种元素组成;铁与铈的摩尔比接近3∶1;铁和铈主要以Fe_3O_4和CeO_2的形态存在于催化剂表面。 相似文献
8.
9.
The recovery of anionic azo dyes namely Congo red (CR), methyl orange (MO) from acidic aqueous solutions using tri-octyl amine (TOA) as an extractant has been investigated. The percentage of extraction of MO and CR increases with an increasing TOA concentration. The anionic dyes were extracted from aqueous solution at pH 2.0 ± 0.1. The extracted dye has been back extracted into aqueous solutions using sodium hydroxide, sodium carbonate and sodium bicarbonate. The organic phase obtained after the stripping of dyes was washed with dilute sodium hydroxide solution to neutralize any sulphuric acid trapped or adhered to the solvent and then with distilled water. This solvent was reused in succeeding extraction of dyes. The influencing parameters were; the effect of diluents, effect of extractant concentration, effect of pH, effect of interference study, effect of equilibrium time, various stripping reagents and stripping phase ratio. The characterization studies such as UV and IR spectra of extracted and stripped MO and CR was also studied. 相似文献
10.