The deflectors influence on flow complexity,bed morphology,sediment transport and water quality of urban lotic waters - A laboratory study

In this laboratory study different combinations of bed (sand, pebble gravel [gravel], and a mix of sand and gravel) and flow (typical and overtopping) were experimented with to investigate the impact of porous deflectors in flow diversity, water quality, and fish performance in prismatic open channels. Deflectors changed the gradually varied flow to a rapidly varied flow, as a sudden change in the water depth was observed at the deflectors, and this change was large for smooth beds. With the presence of gravel, the scouring near the downstream deflector was almost twice that of the sand bed, and with the scouring at its own upstream deflector, irrespective of whether the flow was typical or overtopping. This behavior was a result of sand mobilization due to shear stress and sand mobilization aided gravel transport. The mixed bed showed less gravel movement compared to the gravel-only bed. The percentage of sediment washed out was minor for all bed scenarios, indicating that sediment transport was local. Relative to the sand bed without deflectors (representing a typical urban canal), deflectors resulted in reduced and improved water quality (in terms of sediment load) for sand, and mixed bed, respectively. The fishes found refuge and were comfortable in the pool areas created by deflectors unlike in channels without deflectors where they showed exhaustion.     

集输油环境氟橡胶O形圈老化行为实验研究*

为研究氟橡胶O形圈在集输油环境中的老化行为特征，以长庆油田使用的氟橡胶O形圈(位于非金属复合管连接接头处)为研究对象，采用宏观与微观相结合的方法，通过挂片实验分析氟橡胶O形圈在不同介质（采出油，采出水）、温度（25，50 ℃）、压力条件（0.1,4,6 MPa）下老化后的形貌、质量、拉伸性能及硬度。结果表明:采出油、采出水均能引起O形圈发生溶胀，从而降低O形圈的强度、韧性、硬度；采出水引起的溶胀显著高于采出油更易导致O形圈表面产生坑洞缺陷；渗透速率随温度升高而急剧增加，压力对渗透速率的影响不明显；硬度降低较小，最大降幅为4.17%。结合现场服役813 d的密封圈SEM形貌，证实集输介质渗透会引起氟橡胶圈溶胀、导致表面产生坑洞等缺陷。     

超声波/零价铁协同体系作用机理探讨

在超声波/零价铁协同体系中,探讨了OH.的产生途径及其影响因素,并分析了Fe0表面形态变化。结果表明:在超声波/零价铁体系中,羟基自由基的产生途径主要有四种:声空化导致水分子热解、Fenton反应、超声波与类Fenton反应的复合效应、铁粉颗粒效应;pH值过低或过高都不利于羟基自由基产生;当铁粉投加量为2.0g/L时最有利于羟基自由基产生;超声波通过冲刷、碎裂、清洗、气蚀和熔合等多种效应,活化和增强铁粉的表面性能。     

两种基因型菜心根系形态和生理特性差异对其吸收累积DEHP影响的初步研究

在前期筛选出油青60天菜心和特青60天菜心分别为PAEs高/低吸收累积基因型菜心的基础上,进行邻苯二甲酸二(2-乙基己基)酯(DEHP)不同污染水平的溶液培养试验,对比研究两种基因型菜心的根系形态和生理特性的差异,初步探讨其与菜心吸收累积DEHP的关系.结果表明,随着培养液中DEHP浓度的增加,在根系形态方面,两种基因型菜心根系生物量、总根长和根表面积均下降,油青60天菜心根直径变粗,而特青60天菜心根直径变细;在根系生理特性方面,油青60天菜心除了根系活力下降外,总吸收面积、活跃吸收面积、比表面积和根系脂肪含量均增加,而特青60天菜心除了根系活跃吸收面积增加外,其余指标均下降.因此,两种基因型菜心的根系形态和生理特性对DEHP胁迫响应存在差异.除根直径外,油青60天菜心根系形态和生理指标总体上均高于特青60天菜心,更有利于其根系对DEHP的捕获和吸收.     

微生物絮凝剂的絮凝性能及其絮凝形态研究

利用本实验室分离、筛选的微生物絮凝剂菌株G15,对其进行发酵培养,研究了絮凝剂投加量、絮凝反应体系pH值等对其絮凝性能的影响;对反应体系的ζ电位进行了测定,并且对所形成絮体的微观形态进行了观察。研究结果表明:该微生物絮凝剂在碱性条件下有较强的絮凝活性,当pH=10时最佳投加量为2.5mL;絮凝剂具有较强的热稳定性;加入菌株G15的发酵液后,高岭土悬浊液的ζ电位从-36.27mV显著上升至-12.97mV;并且该微生物絮凝剂产生的絮体颗粒大且结构密实,形态上有明显的分形特征。     

基于形态滤波遗传算法对目标红外图像特征检测

将形态滤波和自适应遗传算法结合起来,提出了一个用于目标检测的形态滤波器参数优化遗传算法。通过设计了形态滤波的遗传算法,寻求最佳结构元,以实现对目标的自适应检测。作为2个特殊环境中的应用检测实例,分别对固体推进器尾喷焰红外图像和复杂背景下的弱小目标进行检测。实验结果表明该方法能够更好地适应环境变化,更大程度地提高目标信号检测的信号噪声（SNR）比,有效地检测出复杂背景下的目标。     

氮对酵母菌-SBR系统效能及酵母形态的影响研究

在酵母菌-SBR系统处理高含油废水中研究了氮添加对酵母细胞形态、沉降性、废水处理效果的影响及恢复能力.结果表明,氮添加量直接影响到系统中酵母菌的生物量,沉降性、pH和处理效果;氮缺乏诱发某些酵母菌菌株细胞由酵母形态向真菌丝形态转化,进而影响到酵母菌的沉降性;从系统运行效果和稳定性方面综合考虑,运行时最佳的进水BOD/N为20/1;恢复最佳氮添加能提高不同程度缺氮系统的处理效果,并可使轻度菌丝化系统快速恢复酵母形态为主,但在短期内对高度菌丝化系统的恢复效果不明显.     

铝合金材料腐蚀形貌及裂纹扩展分析

通过加速腐蚀试验,利用QUESTAR三维光学显微镜观察,将蚀坑看作是椭球形,其深度及宽度都符合幂函数的形式,都随腐蚀时间的增加而增加,但增加的速率都降低;腐蚀能显著降低试件的疲劳寿命,是疲劳裂纹形成的主要原因;AFGROW软件较好地拟合了腐蚀试件的裂纹扩展寿命,拟合误差较低,且所得的裂纹扩展寿命及临界裂纹长度比实际试验...     

絮凝条件对絮体分形结构的影响

在85kg/m³的含沙高浊水中投加阳离子高分子聚合物,借助图像分析技术与沉降技术分析探讨了不同絮凝条件下泥沙絮凝形态学参数:絮体粒径、絮体有效质量密度、絮体自由沉速、浑液面沉速与上清液余浊等的变化规律.利用表征参数“分维”定量控制不同絮凝条件(如搅拌速率、搅拌时间、高分子浓度等)对含沙高浊水絮体结构分形特性的影响.实验证明,不合适的絮凝条件将导致絮体分形构造疏松脆弱,分维值低.絮凝条件合适时(快速絮凝强度为:r₁=300r/min,t₁=10s;慢速絮凝强度:r₂=120r/min,t₂=180s;CP浓度:0.1%),絮体分形结构处于最佳状态.该状态下的絮体具有粒径较大、沉速快、有效质量密度高、粒度分布均匀,分维值最高(D₃=2.16)的特点.而且,由静沉实验测得浑液面沉速高,上清液余浊也低.泥沙絮体分形结构达最佳时的混凝性能、沉降性能与结构密实性均较理想.     

Effect of two-stage sodium hydroxide pretreatment on the composition and structure of Napier grass (Pakchong 1) (Pennisetum purpureum)

ABSTRACT

Sodium hydroxide is ideal in removing lignin from lignocellulosic materials at an effective operational cost. Two-stage NaOH pretreatment was employed herein to investigate lignin and hemicellulose removal and understand the morphology of Napier grass (Pakchong 1) (Pennisetum purpureum), which is considered lignocellulosic due to its high carbohydrate content. NaOH was used at different concentrations (0, 1, 2, 3, and 4 wt.%) and presoak times (1, 2, 3, and 4 h). The results demonstrated that 3 wt.% NaOH at 121°C without presoak resulted in 83.5% lignin removal, with a cellulose to lignin ratio of 3.0. Moreover, the treated samples showed cracking and irregular patterns at optimal conditions.