聚合物/表面活性剂二元体系对油水界面性质的影响

文章应用界面张力仪、Zeta电位仪和表面黏弹性仪测定了聚合物、表面活性剂及其二元复合体系的质量浓度对油水界面性质的影响,并应用透射电镜观察了采出液的液膜结构。结果表明,随着聚合物质量浓度的增加,油水界面的界面剪切黏度值和界面张力值增大,颗粒表面Zeta电位的绝对值增大;随着表面活性剂质量浓度的增加,油水界面的界面剪切黏度变化幅度很小,但界面张力显著减小,颗粒表面Zeta电位绝对值增大;聚合物与表面活性剂复合能够形成稳定的聚合体,具有较大的界面剪切黏度值,较小的界面张力和较高的Zeta电位值;体系中聚合物、表面活性剂及水中悬浮物形成了类似"晶体"结构。     

Adsorption of mixed cationic-nonionic surfactant and its effect on bentonite structure

The adsorption of cationic-nonionic mixed surfactant onto bentonite and its effect on bentonite structure were investigated. The objective was to improve the understanding of surfactant behavior on clay mineral for its possible use in remediation technologies of soil and groundwater contaminated by toxic organic compounds. The cationic surfactant used was hexadecylpyridinium bromide (HDPB), and the nonionic surfactant was Triton X-100 (TX100). Adsorption of TX100 was enhanced significantly by the addition of HDPB, but this enhancement decreased with an increase in the fraction of the cationic surfactant. Part of HDPB was replaced by TX100 which decreased the adsorption of HDPB. However, the total adsorbed amount of the mixed surfactant was still increased substantially, indicating the synergistic effect between the cationic and nonionic surfactants. The surfactant-modified bentonite was characterized by Brunauer-Emmett-Teller specific surface area measurement, Fourier transform infrared spectroscopy, and thermogravimetric-derivative thermogravimetric/differential thermal analyses. Surfactant intercalation was found to decrease the bentonite specific surface area, pore volume, and surface roughness and irregularities, as calculated by nitrogen adsorption-desorption isotherms. The co-adsorption of the cationic and nonionic surfactants increased the ordering conformation of the adsorbed surfactants on bentonite, but decreased the thermal stability of the organobentonite system.     

Removal of polycyclic aromatic hydrocarbons and phenols from coking wastewater by simultaneously synthesized organobentonite in a one-step process

The optimal condition for a one-step process removing organic compounds from coking wastewater by simultaneously synthesized organobentonite as a pretreatment was investigated. Results showed that sorption of organic compounds by organobentonite was positively correlated to the cation surfactant exchange on the bentonite and the octanol-water partition coefficient (K_ow) of the solutes. With 0.75 g/L bentonite and 180 mg/L (60% of bentonite cation exchange capacity) cetyltrimethylammonium bromide, the removal efficiencies of the 16 polycyclic aromatic hydrocarbon (PAHs) specified by the US Environmental Protection Agency in coking wastewater except naphthalene were more than 90%, and that of benzo(a)pyrene was 99.5%. At the same time, the removal efficiencies of COD_Cr, NH₃-N, volatile phenols, colour and turbidity were 28.6%, 13.2%, 8.9%, 55% and 84.3%, respectively, and the ratio of BOD₅/COD_Cr increased from 0.31 to 0.41. These results indicated that the one-step process had high removal efficiency for toxic and refractory hydrophobic organic compounds, and could improve the biodegradability of the coking wastewater. Therefore it could be a promising technology for the pretreatment of toxic and refractory organic wastewater.     

未经处理或仅简单处理生活污水中阴离子表面活性剂浓度测定方法研究

采用碱性亚甲蓝萃取去除蛋白质、硫化物等干扰,然后经酸性亚甲蓝萃取法分析未经处理或仅简单处理生活污水中的阴离子表面活性剂浓度。结果表明：该方法能得到满意的分析结果。     

表面活性剂协同膨润土处理染料废水的研究

文章用两种阳离子表面活性剂溴化十六烷基三甲铵(CTMAB)、氯化十六烷基吡啶(CPC)与膨润土直接混合,协同处理模拟印染废水。研究了不同配比的CTMAB、CPC和膨润土混合物对靛红染料废水脱色的适宜条件,并与经过这两种表面活性剂改性的有机膨润土脱色效果作对比,初步分析了其作用机理。结果表明:表面活性剂(CTMAB和CPC)用量对脱色效果影响最大;表面活性剂协同膨润土体系的脱色效果明显优于其改性有机土,其中CTMAB混合膨润土体系效果最好,脱色率达99%以上;且表面活性剂混合膨润土体系的脱色效果受pH值和处理时间变化的影响较小,沉降速度快,表现出良好的吸附、脱色、絮凝沉降的协同效应。     

不同表面活性剂改性有机膨润土的稳定性研究

文章利用CTMAB、DTMAB、CPB、DPB四种表面活性剂对膨润土进行了有机改性,并研究了改性后各有机膨润土在不同条件下的稳定性。实验结果表明,在同一影响因素下,CTMAB、CPB长碳链表面活性剂改性后的有机膨润土的稳定性较好,而DTMAB、DPB短碳链表面活性剂改性后的有机膨润土的稳定性较差。振荡时间、振荡强度,温度对有机膨润土的稳定性基本没有影响。超声波和pH处理可使有机膨润土的稳定性有所降低。随着处理溶液中NaCl、CaCl2浓度的提高,表面活性剂的烷基链含12个碳原子的改性有机膨润土的稳定性呈现先下降后逐渐上升的趋势。溶液中NaCl和CaCl2的浓度对烷基链含16个碳原子的表面活性剂改性的有机土的稳定性影响不大。     

福建近岸表层海水中阴离子表面活性剂和PCB的污染

用亚甲蓝分光光度法和GC-ECD法分别对福建近岸表层海水中的阴离子表面活性剂和PCBs进行了分析,初步探讨了表层海水中这两类污染物的来源.表层海水中阴离子表面活性剂浓度范围为0.04～1.987 mg/L,较高浓度值站点主要位于九龙江口、闽江口和湄洲湾海域.PCBs的浓度在3.9～367.1 ng/L之间,整体上近岸站点浓度值比离岸站点高,中北部浓度值比南部高.与其他地区的研究结果及海水水质标准进行比较,福建沿海表层海水中阴离子表面活性剂和PCB的污染都较为严重.     

超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

阳离子表面活性剂对污泥脱水性能影响研究

研究了两种含有不同长度疏水链的阳离子表面活性剂十六烷基三甲基溴化铵(CTMAB)和四甲基溴化铵(TMAB)对活性污泥脱水性能的影响,探讨了两种表面活性剂的作用机理。实验数据表明,在同样的投加量下,CTMAB比TMAB能更有效地改善污泥的脱水性能。结果表明,与TMAB相比,投加约为泥样干质量25%的CTMAB可以释出更多污泥胞外聚合物总量,约为231mg/L;污泥毛细吸水时间(CST)可缩短为73s左右,离心后污泥上清液浊度降至15.9,离心后污泥含水率为73.2%;CTMAB和TMAB对污泥沉降性能的改善不是非常明显。     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.