Mg2+ improves biomass production from soybean wastewater using purple non-sulfur bacteria

Soybean wastewater was used to generate biomass resource by use of purple non-sulfur bacteria (PNSB). This study investigated the enhancement of PNSB cell accumulation in wastewater by Mg²⁺ under the light-anaerobic condition. Results showed that with the optimal Mg²⁺ dosage of 10 mg/L, biomass production was improved by 70% to 3630 mg/L, and biomass yield also was improved by 60%. Chemical Oxygen Demand (COD) removal reached above 86% and hydraulic retention time was shortened from 96 to 72 hr. The mechanism analysis indicated that Mg²⁺ could promote the content of bacteriochlorophyll in photosynthesis because Mg²⁺ is the bacteriochlorophyll active center, and thus improved adenosine triphosphate (ATP) production. An increase of ATP production enhanced the conversion of organic matter in wastewater into PNSB cell materials (biomass yield) and COD removal, leading to more biomass production. With 10 mg/L Mg²⁺, bacteriochlorophyll content and ATP production were improved by 60% and 33% respectively.     

Auto-adaptive Air Distribution and Structure Optimization of Ejector Burner for Biomass Alcohol Fuels

A plenty of studies on the utilization of biomass alcohol fuels have been conducted, but combustion efficiency and stability of this fuels still need to be improved. Based on biomass alcohol fuels (bio-methanol and bio-ethanol), this paper studied auto-adaptive air distribution characteristics and optimum structure parameters of an ejector burner by numerical simulation method. Also, an experiment was conducted to verify the numerical results. The results show that the mole air entrainment ratio (MAER) keeps almost constant when the ejector fuel nozzle exit locates at the segment between the ejector throat and the suction chamber entrance, but a bigger ratio α would lead to a higher MAER till the α is bigger than 8.5 for bio-methanol and 11.5 for bio-ethanol. The bio-ethanol fuel is more beneficial for air carrying role because of its big molecular weight. Operation pressure (P_w) has a little impact on MAER of the two fuels, but the rise of back pressure (P_b) would lead to rapid decrease of MAER for the two fuels. For the optimum structure burners, the MAER can be maintained at the value of theoretical complete combustion. Its changing rate is less than 2.3% for bio-methanol and 2.5% for bio-ethanol when the burner load changes from 30% to 120%, which is highly consistent with the experimental results. The optimum burner can distribute air supply automatically with the changing of burner load.     

酸性土壤条件下纳米氧化锌长期暴露对蕹菜生长和叶绿素荧光参数的影响

为了探明酸性土壤条件下纳米氧化锌（nano-ZnO）长期暴露对蕹菜的生理生态效应，通过盆栽实验，设置7个浓度系列的nano-ZnO，70 d后测定相对叶绿素含量、生长参数和叶绿素荧光参数。结果显示，随nano-ZnO浓度升高，蕹菜相对叶绿素含量和生长参数先缓慢增加后显著下降。nano-ZnO对蕹菜生物量在根部和冠部间的分配无显著影响。相对叶绿素含量与nano-ZnO浓度呈显著负相关（r=-0.879,p<0.001）。在nano-ZnO质量比为160 mg/kg时，光合有效辐射190μmol/(m²·s)诱导的激发能过剩，但过剩激发能可通过热耗散保护机制消耗，以避免发生光损伤。酸性土壤条件下，弱光诱导的蕹菜叶绿素荧光参数对nano-ZnO长期暴露不敏感，但蕹菜的生物量累积易受nano-ZnO长期暴露的影响。     

Producing biogas from agricultural residues generated during phytoremediation process: Possibility,threshold, and challenges

In the past decades, a novel strategy has arisen, as required by time, to get a rational production of biogas from contaminated biomass, which may be, on purpose, harvested from contaminated soil phytoremediation process. The present review focuses on the possibility and potential of utilizing the agricultural residues generated during phytoremediation for production of biogas. As a general result of the studies compiled in this review, the harvested biomass can subsequently be utilized for the winning of biogas, and it provides a solution of waste disposal for phytoremediation technology. According to the analysis of previous results, not more than 1 mg/L of cadmium in fermenters shows promoting or at least no inhibitory effect on cumulative biogas yields. This strategy is promising for dealing with both environmental and energy problems in spite of many challenges in the coming future.     

Study of lignocellulosic biomass ignition properties estimation from thermogravimetric analysis

In the last decade, the use of renewable resources has increased significantly in order to reduce the energetic dependence on fossil fuels, as they have an important contribution to the global warning and greenhouse gasses effect. Because of that, research on biofuels has been increased in the last years as its characteristics of use match those of the conventional fuel's: solid biomass can be used instead of coals, and biodiesel could replace diesel. Research on solid biomass ignition properties has been considerably developed because of the amount of industrial accidents related to the treatment and use of solid biomass (self-ignition, dust explosions, etc.). On the other hand, thermogravimetric analysis (TGA) is becoming and important characterization technique as it can be used to determine a wide spectrum of properties, such as kinetics, composition, proximate analysis, etc. This research aims to combine thermal analysis and ignition properties, by using the TGA to obtain the elemental composition of lignocellulosic biomass and compare those results to Minimum Ignition Energy (MIE) values test output, so a relation between composition and MIE can be found.To achieve this aim, biomass samples from different origins have been used: oil palm wastes (empty fruit bunches, mesocarp fiber and palm kernel shell), agricultural wastes (straw chops) and forestry wastes (wood chips and wood powder). Also, raw materials and torrefied biomass were compared. The hemicellulose/cellulose ratio was calculated and compared to different flammability properties, finding out that the greater the ratio and the lower the onset temperature (temperature at which the pyrolysis reaction accelerates), the lower was the minimum ignition energy. From this basis it was possible to define “tendency areas” that grouped the samples whose MIE values were similar. Three tendency areas were found: high minimum ignition energy, medium minimum ignition energy, and low ignition energy.     

Combined Municipal Solid Waste and biomass system optimization for district energy applications

Municipal Solid Waste (MSW) disposal has been a controversial issue in many countries over the past years, due to disagreement among the various stakeholders on the waste management policies and technologies to be adopted. One of the ways of treating/disposing MSW is energy recovery, as waste is considered to contain a considerable amount of bio-waste and therefore can lead to renewable energy production. The overall efficiency can be very high in the cases of co-generation or tri-generation. In this paper a model is presented, aiming to support decision makers in issues relating to Municipal Solid Waste energy recovery. The idea of using more fuel sources, including MSW and agricultural residue biomass that may exist in a rural area, is explored. The model aims at optimizing the system specifications, such as the capacity of the base-load Waste-to-Energy facility, the capacity of the peak-load biomass boiler and the location of the facility. Furthermore, it defines the quantity of each potential fuel source that should be used annually, in order to maximize the financial yield of the investment. The results of an energy tri-generation case study application at a rural area of Greece, using mixed MSW and biomass, indicate positive financial yield of investment. In addition, a sensitivity analysis is performed on the effect of the most important parameters of the model on the optimum solution, pinpointing the parameters of interest rate, investment cost and heating oil price, as those requiring the attention of the decision makers. Finally, the sensitivity analysis is enhanced by a stochastic analysis to determine the effect of the volatility of parameters on the robustness of the model and the solution obtained.     

Recovery of biomass wastes by hydrolysis in sub-critical water

The recovery of waste substances is important not only for the prevention of environmental issues, but also for the rational utilization of natural resources. Hydrolysis reaction in sub-critical water is a promising method for the treatment of organic wastes and has been attracting worldwide attention. In this paper, sub-critical water hydrolysis was employed as a method for producing amino acids, reducing sugars, bio-oil and gas fuels from biomass wastes. The current statuses of these useful chemicals production from biomass wastes by hydrolysis in sub-critical water were reviewed. The review indicates that sub-critical water hydrolysis can be an efficient process for recovering useful chemicals from biomass wastes. This method is renewable, sustainable, efficient, and safe for the environment.     

CO2 capture and storage from a bioethanol plant: Carbon and energy footprint and economic assessment

Biomass energy and carbon capture and storage (BECCS) can lead to a net removal of atmospheric CO₂. This paper investigates environmental and economic performances of CCS retrofit applied to two mid-sized refineries producing ethanol from sugar beets. Located in the Region Centre France, each refinery has two major CO₂ sources: fermentation and cogeneration units. “carbon and energy footprint” (CEF) and “discounted cash flow” (DCF) analyses show that such a project could be a good opportunity for CCS early deployment. CCS retrofit on fermentation only with natural gas fired cogeneration improves CEF of ethanol production and consumption by 60% without increasing much the non renewable energy consumption. CCS retrofit on fermentation and natural gas fired cogeneration is even more appealing by decreasing of 115% CO₂ emissions, while increasing non renewable energy consumption by 40%. DCF shows that significant project rates of return can be achieved for such small sources if both a stringent carbon policy and direct subsidies corresponding to 25% of necessary investment are assumed. We also underlined that transport and storage cost dilution can be realistically achieved by clustering emissions from various plants located in the same area. On a single plant basis, increasing ethanol production can also produce strong economies of scale.     

Spatially distributed modeling of the long-term carbon balance of a boreal landscape

Spatially and temporally distributed information on the sizes of biomass carbon (C) pools (BCPs) and soil C pools (SCPs) is vital for improving our understanding of biosphere-atmosphere C fluxes. Because the sizes of C pools result from the integrated effects of primary production, age-effects, changes in climate, atmospheric CO₂ concentration, N deposition, and disturbances, a modeling scheme that interactively considers these processes is important. We used the InTEC model, driven by various spatio-temporal datasets to simulate the long-term C-balance in a boreal landscape in eastern Canada. Our results suggested that in this boreal landscape, mature coniferous stands had stabilized their productivity and fluctuated as a weak C-sink or C-source depending on the interannual variations in hydrometeorological factors. Disturbed deciduous stands were larger C-sinks (NEP₂₀₀₄ = 150 gC m⁻² yr⁻¹) than undisturbed coniferous stands (e.g. NEP₂₀₀₄ = 8 gC m⁻² yr⁻¹). Wetlands had lower NPP but showed temporally consistent C accumulation patterns. The simulated spatio-temporal patterns of BCPs and SCPs were unique and reflected the integrated effects of climate, plant growth and atmospheric chemistry besides the inherent properties of the C pool themselves. The simulated BCPs and SCPs generally compared well with the biometric estimates (BCPs: r = 0.86, SCPs: r = 0.84). The largest BCP biases were found in recently disturbed stands and the largest SCP biases were seen in locations where moss necro-masses were abundant. Reconstructing C pools and C fluxes in the ecosystem in such a spatio-temporal manner could help reduce the uncertainties in our understanding of terrestrial C-cycle.     

Chemical composition and properties of ashes from combustion plants using Miscanthus as fuel

Miscanthus giganteus is one of the energy crops considered to show potential for a substantial contribution to sustainable energy production. In the literature there is little data available about the chemical composition of ashes from the combustion of Miscanthus and practically no data about their physical properties. However, for handling, treatment and utilization of the ashes this information is important. In this study ashes from two biomass combustion plants using Miscanthus as fuel were investigated. The density of the ashes was 2230 ± 35 kg/m~3, which was similar to the density of ashes from straw combustion. Also the bulk densities were close to those reported for straw ashes. The flowability of the ashes was a little worse than the flowability of ashes from wood combustion. The measured heavy metal concentrations were below the usual limits for utilization of the ashes as soil conditioner. The concentrations in the bottom ash were similar to those reported for ash from forest residue combustion plants. In comparison with cyclone fly ashes from forest residue combustion the measured heavy metal concentrations in the cyclone fly ash were considerably lower. Cl-, S and Zn were enriched in the cyclone fly ash which is also known for ashes from wood combustion. In comparison with literature data obtained from Miscanthus plant material the concentrations of K, Cl-and S were lower.This can be attributed to the fact that the finest fly ash is not collected by the cyclone de-dusting system of the Miscanthus combustion plants.