杭州市环境空气中黑碳质量浓度变化特征

采用2013年环境空气自动监测数据,分析杭州市空气中黑碳质量浓度的变化规律,并对变化特征的产生原因进行探讨。结果表明:黑碳测定年均值为4.10μg/m3,日变化有明显双峰结构,峰值出现在早7时和晚8时左右;从季节看,黑碳质量浓度冬季高(5.20μg/m3)、夏季低(3.00μg/m3);黑碳质量浓度与NO2、CO、PM10、PM2.5显著相关,与O3、风速、气温呈负相关,降水对黑碳的清除作用明显。     

Optimal Absorbent Evaluation for the CO2 Separating Process by Absorption Loading,Desorption Efficiency,Cost, and Environmental Tolerance

The CO₂ absorption capacities of potassium glycinate, potassium sarcosinate (choline, proline), mono-ethanolamine (MEA), and tri-ethanolamine were evaluated to find the optimal absorbent for separating CO₂ from gaseous products by a CO₂ purification process. The absorption loading, desorption efficiency, cost, and environmental tolerance were assessed to select the optimal absorbent. MEA was found to be the optimum absorbent for separating the CO₂ and H₂ mixture in gaseous product. The maximum absorption loading rate was 0.77 mol CO₂ per mol MEA at temperature of 20°C and absorbent concentration of 2.5 mol/L, whereas desorption efficiency was 90% by heating for 3 h at 130°C. MEA was found to be an optimal absorbent for the purification process of CO₂ during gaseous production.     

Feasibility of honeycomb monolith supported sugar catalyst to produce biodiesel from palm fatty acid distillate (PFAD)

Carbon coated monolith was prepared by sucrose solution 65 wt.% via dip-coating method. Sulfonation of incomplete carbonized carbon coated monolith was carried out in order to synthesize solid acid catalyst. The textural structure characteristics of the solid acid catalyst demonstrated a low surface area and pore volume. Palm fatty acid distillate (PFAD), a by-product of palm oil refineries, was utilized as oil source in biodiesel production. The esterification reaction subjected to different reaction conditions was performed by using the sulfonated carbon coated monolith as heterogeneous catalyst. The sulfonation process had been performed by using vapour of concentrated H₂SO₄ that was much easier and efficient than liquid phase sulfonation. Total acidity value of carbon coated monolith was measured for unsulfonated sample (0.5 mmol/g) and sulfonated sample (4.2 mmol/g). The effect of methanol/oil ratio, catalyst amount and reaction time were examined. The maximum methyl ester content was 89% at the optimum condition, i.e. methanol/oil molar ratio (15:1), catalyst amount (2.5 wt.% with respect to PFAD), reaction time (240 min) and temperature 80 °C. The sugar catalyst supported on the honeycomb monolith showed comparable reactivity compared with the sugar catalyst powder. However, the catalyst reusability studies showed decrease in FFA% conversion from 95.3% to 68.8% after four cycles as well as the total acidity of catalyst dropped from the value 4.2 to 3.1 mmol/g during these cycles. This might be likely due to the leaching out of SO₃H group from the sulfonated carbon coated monolith surface. The leaching of active species reached a plateau state after fourth cycle.     

上海城区交通干道黑碳污染调查

采用设置在上海市中心城区交通主干道旁空气质量自动监测站2018年1—12月的观测数据,分析黑碳气溶胶(BC)污染特征及其与PM_(2.5)、SO_2、NO_x、CO、O_3、苯、甲苯、乙苯、二甲苯和气象参数的相关性。结果表明,观测期间内,BC小时均值为(3 038±22) ng/m~3,ρ(BC)在ρ(PM_(2. 5))中占比为(11. 48±0. 12)%。日内ρ(BC)变化呈双峰型,各月份之间ρ(BC)变化不大。ρ(BC)与风速呈负相关,与PM_(2. 5)、NO_x、CO、苯、甲苯、乙苯和二甲苯呈正相关。     

遥感技术在水生态环境管理的应用与前景

随着遥感数据源的不断丰富,遥感技术不断提高,可以解决越来越多的水环境问题。指出了当前水生态环境管理方面的主要需求,结合目前遥感技术的发展,对国内外的水环境遥感研究进展进行综述。以湖泊富营养化监测与评估、核电站温排水遥感监测及城市黑臭水体遥感监测为案例,具体阐述遥感在水环境管理中的应用方法及成效。未来水生态环境管理发展趋势将以水污染防治为主向水污染防治和水生态修复与保护并重发展。基于此趋势,提出遥感在水生态修复的应用潜力,利于更多地方部门积极有效应用遥感技术,解决水生态环境问题。     

城市黑臭水体的产生原因及治理对策

在我国经济发展势头如此迅猛的背景下,城市污染问题日益严重。城市黑臭水体对城市生态环境造成严重影响,如果不能及时进行治理,则会对原有水生态循环系统造成破坏,影响城市居民正常生活。本文首先对城市黑臭水体产生原因进行分析,然后提出有效的治理对策。     

南京市黑臭河流水体中细菌多样性的研究

以南京市城南河为研究对象,分别提取上中下游的水体样本,分析水质中的氮、磷、COD等水质指标,并利用变性梯度凝胶电泳技术(DGGE)分析了城南河不同位置的细菌多样性。结果表明:城南河水体中的平均总氮为30.06 mg/L,总磷为6.14 mg/L,COD为42.03 mg/L,均超过国家V类水质标准。结合外观,城南河属于严重污染的典型黑臭河流。DGGE分析的结果表明:城南河具有较高的细菌多样性,优势菌群主要是变形菌门和拟杆菌门2大类群,且不同取样点细菌种类差别不大。     

低碳高氮污水处理应用技术研究

针对碳氮比小于7的污水,其碳源不能满足硝化与反硝化的要求这一问题,通过改变SBR工艺的运行方式、调解工艺参数等技术手段,使其能够达标处理此类工业废水,并通过某淀粉厂的工程实例进行了验证:采用改良的SBR工艺可以对低碳高氮污水进行有效的处理。     

Effect of oxide-based fluxes on mechanical and metallurgical properties of Dissimilar Activating Flux Assisted-Tungsten Inert Gas Welds

Present investigation is to study the “Effect of Activating Fluxes on Mechanical and Metallurgical Properties of Dissimilar Activated Flux-Tungsten Inert Gas Welds”. Effect of current, welding speed, joint gap and electrode diameter on weld bead dimensions on 6 mm thick dissimilar weld between carbon steel to stainless steel, was studied under Activated Flux-Tungsten Inert Gas Welding process. During this investigation three different types of oxide powders were used-TiO₂, ZnO and MnO₂. After welding samples were subject to mechanical testing, in addition to characterization via micro hardness and microstructures of Normal Tungsten Inert Gas Welds and Activated Flux-Tungsten Inert Gas Welds. Activating fluxes TiO₂ and ZnO are effective fluxes for Activated Flux-Tungsten Inert Gas Welding of dissimilar weld between CS to SS. Highest depth/width (D/W) ratio reported under TiO₂ and ZnO fluxes compare to Normal-Tungsten Inert Gas Welds. Lowest angular distortion was observed under TiO₂ flux compare to Normal-Tungsten Inert Gas Welds. Mechanical properties, Joint Efficiency of Activated Flux-Tungsten Inert Gas Welds are higher than normal-Normal Tungsten Inert Gas Welds. Tensile Test specimens of both the processes failed from the parent metal (carbon steel side). Carbon migration from CS to SS, had occurred which led to failure of weld joints from CS side.     

Beyond hypoxia：Occurrence and characteristics of black blooms due to the decomposition of the submerged plant Potamogeton crispus in a shallow lake

Organic matter-induced black blooms(hypoxia and an offensive odor) are a serious ecosystem disasters that have occurred in some large eutrophic shallow lakes in China. In this study, we investigated two separate black blooms that were induced by Potamogeton crispus in Lake Taihu, China. The main physical and chemical characteristics, including color- and odor-related substances, of the black blooms were analyzed. The black blooms were characterized by low dissolved oxygen concentration(close to 0 mg/L), low oxidation-reduction potential, and relatively low pH of overlying water. Notably higher Fe2+and∑S2-were found in the black-bloom waters than in waters not affected by black blooms. The black color of the water may be attributable to the high concentration of these elements, as black FeS was considered to be the main substance causing the black color of blooms in freshwater lakes. Volatile organic sulfur compounds, including dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, were very abundant in the black-bloom waters. The massive anoxic degradation of dead Potamogeton crispus plants released dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, which were the main odor-causing compounds in the black blooms. The black blooms also induced an increase in ammonium nitrogen and soluble reactive phosphorus levels in the overlying waters. This extreme phenomenon not only heavily influenced the original lake ecosystem but also greatly changed the cycling of Fe, S, and nutrients in the water column.