Research on flow assurance of deepwater submarine natural gas pipelines: Hydrate prediction and prevention

The formation of hydrate will lead to serious flow assurance problems in deepwater submarine natural gas transmission pipelines. However, the accurate evaluation model of the hydrate blocking risk for submarine natural gas transportation is still lacking. In this work, a novel model is established for evaluating the hydrate risk in deepwater submarine gas pipelines. Based on hydrate growth-deposition mechanism, the mathematical model mainly consists of mass, momentum and energy conservation equations. Meantime, the model results are obtained by finite difference method and iterative technique. Finally, the model has been applied in the production of deepwater gas field (L Gas Field) in China, and the sensitivity analysis of relevant parameters has been carried out. The results show that: (a). The mathematical model can well predict the hydrate blockage risk in deepwater natural gas pipelines after verification. (b). Hydrate is easily formed at the intersection of horizontal pipeline and vertical riser, and the maximum blocking position often occurs in middle of the riser. (c). The hydrate blockage degree and length of hydrate formation region (HFR) decrease with the increase of gas transport rate. (d). The hydrate blockage degree and length of HFR decrease with the increase of gas transport temperature. (e). The hydrate blockage degree and length of HFR increase with the extension of horizontal pipeline. (f). Injecting inhibitors can effectively inhibit hydrate formation and blockage, but the improvement of transmission measures can significantly reduce the dosage of inhibitor. It is concluded that measures such as increasing gas transportation rate and temperature, shortening horizontal pipeline length, optimizing inhibitor injection point and injection rate can play a safe, economic and efficient role in hydrate preventing and controlling.     

苦味酸测定中关键问题的研究

目前测定苦味酸的国标方法为《生活饮用水标准检验方法有机物指标》(GB/T 5750.8—2006)中的衍生物-液液萃取-气相色谱法,在实际测试过程中,发现水样pH值和基质效应会影响苦味酸测定。当pH值为8~12时,生成的氯化苦响应强度变化不大;在pH约为13时,响应强度最大。水质中除腐殖酸、硝基甲烷及2,4,6-三硝基甲苯会影响苦味酸测定外,硝基酚类和甲基酚类同样起到正干扰作用,因此,国标方法不能全面和准确地测定水中的苦味酸含量。     

基于活性污泥微生物冻后再生对废水基质降解效能的研究

采用高径比为12.5的序批式反应器(SBR)对冷冻的成熟好氧颗粒污泥（AGS）解冻驯化，研究母体颗粒冻后富集培养及其在番茄废水基质降解中的循环利用。结果表明：冻后恢复活性的污泥第60天全部颗粒化，平均粒径不小于0.45 mm；高通量测序结果显示，相较母体颗粒，该污泥中与颗粒化相关的变形菌门(Proteobacteria)和拟杆菌门(Bacteroidetes)优势菌群富集，微生物丰度呈显著差异（P<0.05）；复合菌株对COD、NH3-N和PO3-4-P去除率分别为98.9%、82.1%和82.2%，可实现番茄废水的有效降解。     

Risk assessment method of polyethylene dust explosion based on explosion parameters

The explosion characteristic parameters of polyethylene dust were systematically investigated. The variations in the maximum explosion pressure (P_max), explosion index (K_st), minimum ignition energy (MIE), minimum ignition temperature (MIT), and minimum explosion concentration (MEC) of dust samples with different particle sizes were obtained. Using experimental data, a two-dimensional matrix analysis method was applied to classify the dust explosion severity based on P_max and K_st. Then, a three-dimensional matrix was used to categorize the dust explosion sensitivity based on three factors: MIE, MIT, and MEC. Finally, a two-dimensional matrix model of dust explosion risk assessment was established considering the severity and sensitivity. The model was used to evaluate the explosion risk of polyethylene dust samples with different particle sizes. It was found that the risk level of dust explosion increased with decreasing particle size, which was consistent with the actual results. The risk assessment method can provide a scientific basis for dust explosion prevention in the production of polyethylene.     

BP 神经网络模型在环境气象灾害预测中的应用研究--以湖南省为例

依据环境气象数据与自然灾害统计数据,建立BP神经网络模型,对湖南主要气象灾害（洪灾、旱灾、冰冻灾）及受灾经济损失进行实例预测,将在MATLAB7软件中的仿真结果与传统的多元线性回归模型分析结果进行比较和误差分析。结果表明,BP神经网络模型在洪灾、旱灾受灾率方面的预测效果和精度优于多元回归模型,而由于冰灾训练样本不足及经济损失与输入因子的线性相关程度高,在冰灾与受灾经济损失率方面稍逊于多元回归模型。     

南昌市大气降水化学特征及来源分析

为分析南昌市大气降水离子来源和源区,对南昌市2016年4—9月大气降水样品主要阴阳离子的组成进行了测定分析,并运用PMF（正定矩阵因子分解）模型分析来源和TrajStat软件模拟后向轨迹.结果表明:NH₄+和Ca2+是南昌市大气降水中的主要阳离子,加权平均浓度为65.3和23.9 μmol/L,分别占阳离子总量的57%和21%;SO₄2-和NO₃-是主要阴离子,加权平均浓度为60.4和25.3 μmol/L,分别占阴离子总量的56%和23%.c（NH₄+）、c（Ca2+）、c（K+）、c（Mg2+）、c（Na+）、c（Cl-）、c（NO₃-）之间均存在着较为显著的相关性,说明它们之间可能有相似的来源或形成化合物共同存在.结合PMF模型分析结果表明,Na+、Cl-很明显受到了海盐的影响,也部分受土壤和二次污染影响;K+、Mg2+、Ca2+大部分来自于土壤,海盐、二次污染也贡献了一部分的K+;SO₄2-、NH₄+和NO₃-是组成大气二次颗粒物的主要成分,主要由二次污染源贡献;煤燃烧贡献了主要的F-和部分SO₄2-.后向轨迹模型分析表明,南昌市大气降水主要受局地降雨气团影响,5月、8月、9月受陆源及人为影响较大,海源性离子经过内陆上空时被稀释或沉降,导致6月、7月来自于海洋上空的降雨气团对南昌影响不大.研究显示,SO₄2-对南昌市大气降水的影响逐渐增大导致降雨类型逐渐由混合型向硫酸型转化,人为影响是造成大气污染的主要原因.      

活性污泥模型参数实际可识别性研究方法

可识别性研究是参数估计的第一步。对目前应用于活性污泥模型参数实际可识别性研究的三种方法进行了综述,根据模型的复杂程度以及所要研究的参数数量,研究者可选用不同的方法。     

嘉陵江重庆段DOM三维荧光光谱的平行因子分析

应用平行因子分析法对2010年6月嘉陵江重庆段水体13个取样点DOM(溶解性有机质)的三维荧光光谱进行指纹识别.结果表明,嘉陵江重庆段水体可识别出4类5个荧光组分,包括类富里酸荧光组分C1(250、320 nm/400 nm)和C4(230、340nm/450 nm)、类腐殖酸荧光组分C2(260、360 nm/450 nm)、浮游生物产生的荧光组分C3(260 nm/380 nm)和类蛋白物质荧光组分C5(280 nm/330 nm).它们的贡献率依次为类富里酸18%～38%,类腐殖酸11%～18%,浮游植物8%～22%,类蛋白物质33%～49%.嘉陵江重庆段水体的有机物污染主要以来自工业、生活污水和其他人为活动产生的陆源污染输入为主,其次是浮游植物和水体微生物代谢产生的污染.13个取样点的总荧光强度在空间分布上由西到东呈"升高—降低—升高—降低"的趋势.