节水灌溉与控释肥施用对太湖地区稻田土壤氮素渗漏流失的影响

在太湖流域采用田间小区试验研究了干湿交替节水灌溉与控释肥(控释BB肥与树脂包膜尿素)施用对稻田30 cm深土壤渗漏水总氮(TN)、铵态氮(NH+4-N)、硝态氮(NO-3-N)和亚硝态氮(NO-2-N)浓度的动态变化及氮素淋失的影响.结果表明:各处理渗漏水TN、NH+4-N和NO-2-N浓度均在施肥后10 d内达到高峰,然后逐渐下降.渗漏水氮素以NH+4-N(0.22~15.15 mg·L-1)为主,平均占TN 70.1%,NO-3-N(0.10~0.95 mg·L-1)占TN比例较低,平均为13.0%,NO-2-N(0~0.24 mg·L-1)平均仅占TN 1.3%.与淹灌相比,节灌对稻田渗漏水氮素浓度及各氮素占总氮的比例影响不大,但降低了14.2%的渗漏水量和9.4%的TN淋失量.施氮显著提高了渗漏水氮素浓度以及NH+4-N和NO-2-N占TN的比例.控释BB肥和树脂包膜尿素较常规尿素处理水稻全生育期渗漏水TN平均浓度分别降低10.2%和43.3%,TN淋失量分别降低26.1%和39.5%.综上,干湿交替节灌结合树脂包膜尿素施用有利于降低氮素渗漏损失,促进农田面源污染减排.     

Application of CFD on the sensitivity analyses of some parameters of the modified Hartmann tube

The aim of this work is to determine the influence of operating parameters such as the dispersion pressure, the ignition delay and height on the dust flammability. A Computational Fluid Dynamics (CFD) simulation, based on an Euler–Lagrange approach, was developed with Ansys Fluent™ and validated experimentally. Such analysis will facilitate the choice of the most conservative conditions for a flammability test. This paper is focused on a case study performed on wheat starch with the modified Hartmann tube. The dispersion process of the powder was studied with granulometric analyses performed in situ and high speed videos. Tests were performed with injections at gas pressure ranging from 3 to 6 bars and the evolution of the particle size distribution (PSD) was recorded at different ignition heights (5, 10 and 15 cm over the dispersion nozzle). The observations highlighted the presence of agglomeration/deagglomeration processes and dust segregation. Besides, a CFD simulation analysis was aimed at evaluating the impact of a set of parameters on the PSD and the local turbulence, which are closely linked to some flammability parameters. For this computational analysis, the CFD simulation was coupled with a collision treatment based on a Discrete Element Method (DEM) in order to consider the cohesive behavior of the combustible dust. Thus the results suggest performing the injection of the gases at approximately 5 bars for the flammability tests of wheat starch in order to obtain the finest PSD at a given ignition height. It is also shown that the finest PSD are obtained at 5 cm over the dispersion nozzle. However, the local instabilities and turbulence levels are so high during the first stages of the dispersion that the flame growth can be disturbed for short ignition delays. Moreover, the stabilization of the bulk of the dust cloud requires longer periods of time when the ignition sources are located at 15 cm. As a result, the recommended height to perform a flammability test is 10 cm in this case. Finally, this study proposes some tools that might improve the procedure of dust flammability testing.     

L型钢管混凝土芯柱耐火极限研究

火灾高温对结构安全有显著影响,为研究等肢L形钢管混凝土芯柱的耐火极限及其影响因素,利用ABAQUS软件建立合理的高温反应分析模型,在验证模型可靠性基础上,分析了荷载比、截面边长、长细比、荷载偏心率、含钢率等对L形钢管混凝土芯柱耐火极限的影响。研究结果表明:在一定参数范围内,荷载比和截面边长是构件耐火极限的主要影响参数,荷载比越小,截面边长越大,构件的耐火极限越高;长细比和荷载偏心率对其影响较大,长细比和荷载偏心率越小,构件的耐火极限越高;含钢率对其影响不显著。结果可为异形钢管混凝土芯柱的抗火安全设计提供参考。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

电渗透脱水对污泥热干燥特性的影响

以污水厂机械脱水后的污泥作为研究对象,提出了采用电渗透-热干燥结合进行深度脱水的方法。通过对原泥以及电渗透脱水至不同含水率(67%、71%和76%)的污泥在热干燥过程中含水率和干燥速率的测定,分析电渗透脱水对污泥热干燥特性的改善规律。结果表明,经电渗透脱水至含水率为67%和71%的污泥在热干燥过程中的传热传质速率及干燥速率有明显提高,且干燥温度越高,电渗透后污泥的干燥速率与原泥的干燥速率差距越大。相同电压梯度及相同温度下电渗透至67%后进行热干燥耗能最少。实际应用中应结合能耗分析选择合适的电渗透程度及干燥温度,以达到最优效果。     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.     

初始pH值对磷酸盐还原除磷的影响研究

以超高盐（盐度7％，以NaCI计）高磷榨菜废水为研究对象，考察了初始pH值对磷酸盐还原进程的影响。实验结果表明，初始pH值对磷酸盐还原除磷效能影响显著。初始pH为8时，磷酸盐还原除磷率达到最高，平均值为65．45％。同时，初始pH值还会影响污泥中活性磷的形成以及基体对磷化氢的吸附。此外，偏碱性有利于磷形态转化，且BD-P（主要是一些可溶性的、还原性强的、带有Fe-P化合物的集合）含量的高低调控着生物膜内间隙水中溶解态可反应性磷（DRP）和可还原水溶态磷（RSP）含量，最终决定着磷酸盐还原进程。随着初始pH值的升高，污泥对磷化氢的吸附能力降低导致污泥中结合态磷化氢（MBP）含量不断减少。     

双组分VOCs的催化氧化及动力学分析

考察了微波加热与管式炉加热下挥发性有机化合物(VOCs)甲苯与氯苯的催化氧化性能,并对双组分VOCs的反应动力学进行了分析.结果表明,VOCs的竞争吸附使得双组分中甲苯和氯苯的转化率比单组分降低3%~12%;微波的"热点效应"与"非热效应"使得VOCs转化效率明显优于管式炉加热,尤其是氯苯的转化率提高了31%~38%;微波加热降低了氧化反应温度和处理能耗.动力学分析表明,微波加热下甲苯和氯苯的反应活化能比管式炉加热下减少了2146 J·mol-1和1450J·mol-1,微波加热下氯苯的化学反应速率常数是管式炉加热的35倍,甲苯的反应速率常数提高了6倍.     

爆炸形成过程中火焰加速的试验研究

为预防和控制工业爆炸事故,并为脉冲爆轰发动机的研究提供理论指导,分析火焰加速导致的燃烧转爆轰过程的影响因素。采用爆轰管探讨障碍物的阻塞比、混合物的组成、初始压力和点火能等4个因素对爆炸性气体火焰速度和爆轰压力的影响规律。试验结果表明:障碍物的存在能大大提高火焰速度和爆轰压力;爆轰压力随管内障碍物阻塞比的增大先变大后减小,并在阻塞比为0.498,燃料种类为天然气,化学当量比为1时达到最大;爆轰压力还随混合气体初始压力的增大和点火能的提高而增大。选择适宜的条件可大大提高火焰加速速率,促进燃烧向爆轰过程转变。     

Numerical simulation of propane detonation in medium and large scale geometries

A modelling strategy has been developed for consequence analysis of medium and large scale gaseous detonation. The model is based on the solution of Euler equations with one-step chemistry. The Van Leer flux limited method which is a total variation diminishing scheme is used for shock capturing. Preliminary calculations were firstly conducted for small domains with fine grids which resolve the wave, relatively coarse grids which have less than 10 grids across the wave and coarse grids in which the minimum grid size is larger than the wave thickness to ensure that the reaction scheme has been properly tuned to capture the correct detonation pressure, temperature and velocity in the resolutions used in the different cases. The model was firstly tested against a medium scale detonation test in a shock tube with U-bends. Reasonably good agreement is achieved on detonation pressure and mean shock wave velocities at different measuring segments of the tube. Following the validation, the detonation of a hypothetical planar propane-air cloud is simulated. The predictions uncovered some interesting features of such large scale detonation phenomena which are of significance in the safety context, especially for accidental investigations. The findings from the present analysis are in line with the forensic evidence on damages in some historic accidents and challenges previous analysis of a major accident in which forensic evidence suggested localised detonation but was considered as the consequence of fire storms by the investigation team.