• The inhibition of the main organic pollutions in CMW was demonstrated.• Variations of AK and BK showed a high correlation with the SAA of Ac and n-Bu.• The inhibitory degree was in the order of Ac>n-Bu for individual toxicants.• Biodegradation products of the main toxicants were analyzed. This work aims to investigate the inhibitory effect of crotonaldehyde manufacture wastewater (CMW) on biological acidification. To reveal the inhibitory effect of wastewater to the anaerobic granular sludge (AnGS), variations of the specific acidogenic activity (SAA) and activities of key enzymes were investigated. The results indicated that the dosage of CMW causing a 50% effect concentration (EC50) on the activity of total volatile fatty acids (TVFA) production was 380 mg COD/g VSS. The inhibitory effect of individual toxicants in CMW on the activity of TVFA production were in the order of crotonaldehyde>ethyl sorbate>(E,E)-2,4-hexadienal, and their inhibitory degrees on individual VFA products were acetic acid (Ac)>n-butyric acid (n-Bu), which could correspond to the variations in the activities of acetate kinase (AK) and butyrate kinase (BK). Furthermore, the combined effect of three toxicants on the activity of TVFA production was significantly higher than that of any individual toxicant, and the contribution of the relative toxicity to CMW was 77.27%. Additionally, the biodegradation products of the main toxicants indicated that the removal of crotonaldehyde and (E,E)-2,4-hexadienal was primarily due to the hydrogenation of alkene and aldehyde and the oxidation of aldehyde. Nevertheless, the removal of ethyl sorbate was primarily based on adsorption. In conclusion, biological acidification has a limited ability to treatment CMW, therefore, a further pretreatment technology should be used to remove the main toxicant of wastewater. 相似文献
Assessment of aquatic macroinvertebrates is a critical component of many watershed monitoring programs and passive samplers are often used to collect long-term site data, especially in environments where active sampling is not possible. However, standard passive samplers can be expensive and lost in extreme conditions. We developed a sampler using plastic soda bottles (PSB) filled with river rock and compared its effectiveness with standard Hester-Dendy samplers in both lotic and lentic environments. Abundance, taxa richness, and macroinvertebrate composition showed no significant differences between sampler types in either habitat type. PSB samplers, which can be constructed for less than one dollar each, collected the same number of organisms and represented the same diversity as Hester-Dendy devices that cost around $38 each. In studies where funds are limited, PSB samplers appear to be suitable for passive monitoring. 相似文献
Objective: A novel anthropomorphic test device (ATD) representative of the 50th percentile male soldier is being developed to predict injuries to a vehicle occupant during an underbody blast (UBB). The main objective of this study was to develop and validate a finite element (FE) model of the ATD lower limb outfitted with a military combat boot and to insert the validated lower limb into a model of the full ATD and simulate vertical loading experiments.
Methods: A Belleville desert combat boot model was assigned contacts and material properties based on previous experiments. The boot model was fit to a previously developed model of the barefoot ATD. Validation was performed through 6 matched pair component tests conducted on the Vertically Accelerated Loads Transfer System (VALTS). The load transfer capabilities of the FE model were assessed along with the force-mitigating properties of the boot. The booted lower limb subassembly was then incorporated into a whole-body model of the ATD. Two whole-body VALTS experiments were simulated to evaluate lower limb performance in the whole body.
Results: The lower limb model accurately predicted axial loads measured at heel, tibia, and knee load cells during matched pair component tests. Forces in booted simulations were compared to unbooted simulations and an amount of mitigation similar to that of experiments was observed. In a whole-body loading environment, the model kinematics match those recorded in experiments. The shape and magnitude of experimental force–time curves were accurately predicted by the model. Correlation between the experiments and simulations was backed up by high objective rating scores for all experiments.
Conclusion: The booted lower limb model is accurate in its ability to articulate and transfer loads similar to the physical dummy in simulated underbody loading experiments. The performance of the model leads to the recommendation to use it appropriately as an alternative to costly ATD experiments. 相似文献