Inexpensive substrate sampler for macroinvertebrates

Assessment of aquatic macroinvertebrates is a critical component of many watershed monitoring programs and passive samplers are often used to collect long-term site data, especially in environments where active sampling is not possible. However, standard passive samplers can be expensive and lost in extreme conditions. We developed a sampler using plastic soda bottles (PSB) filled with river rock and compared its effectiveness with standard Hester-Dendy samplers in both lotic and lentic environments. Abundance, taxa richness, and macroinvertebrate composition showed no significant differences between sampler types in either habitat type. PSB samplers, which can be constructed for less than one dollar each, collected the same number of organisms and represented the same diversity as Hester-Dendy devices that cost around $38 each. In studies where funds are limited, PSB samplers appear to be suitable for passive monitoring.     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

Collecting representative dust samples: A comparison of various sampling methods in underground coal mines

Former methods used in the U.S. to assess hazardous and explosible coal dust date back to the 1950s. As mining technologies advanced, so too have the hazards. Given the results of the recent coal dust particle size survey and full-scale experimental mine explosion tests, the National Institute for Occupational Safety and Health (NIOSH) recommended a new minimum standard, in the absence of background methane, of 80% total incombustible content (TIC) be required in the intake airways of bituminous coal mines, replacing the previous 65% TIC requirement. Most important to monitoring and maintaining the 80% TIC is the ability to effectively collect and analyze representative dust samples that would likely disperse and participate in dust explosion propagation. Research has shown that dust suspended on elevated surfaces is usually finer, more reactive, and more readily dispersible while floor deposits of dust are generally coarser and more difficult to disperse given the same blast of air. The roof, rib, and floor portions of the dust samples were collected and analyzed for incombustible content separately and the results were compared to a band sample of the roof, rib, and floor components. Results indicate that the roof and rib dust samples should be kept separate from floor dust samples and considered individually for analyses. The various experimental collection methods are detailed along with preferred sampling approaches that improve the detectability of potentially hazardous accumulations of explosible dust.     

室内空气和灰尘中全(多)氟烷基化合物的研究进展

全(多)氟烷基化合物(per(poly)fluoroalkyl substances,PFASs)在环境各个介质及人体样品中广泛被检出,近年,在室内空气和灰尘中也普遍发现PFASs.研究表明,室内空气中PFASs的含量普遍高于室外空气,室内空气和灰尘中的PFASs可能是室外空气的污染来源及人体暴露源,因此室内环境中PFASs成为环境领域的又一个研究热点.但目前为止,我国还没有开展室内空气中PFASs的相关研究,室内灰尘中PFASs的研究也相对较少.本文就室内空气和灰尘中PFASs的采样与分析方法、污染现状、来源分析及人体暴露等4个方面进行了综合阐述,以期为我国室内环境中PFASs的研究提供参考.     

新乡市工业“三废”污染及治理措施

以新乡市2006—2012年工业"三废"排放监测数据为依据,通过对城市废水、废气及工业固体废弃物排放情况的分析,找出主要污染特征并提出相关治理对策。     

基于相关性分析的PCBA热力学模型修正

目的精确且高效地对印制电路板组件热力学模型进行修正。方法采用基于拉丁超立方抽样试验设计和Speraman等级相关系数计算公式的相关性分析方法,找出电子产品热仿真试验中对元器件表面温度值影响较大的输入参数,然后进一步分析得出输入与输出之间的函数关系。在此基础上给出印制电路板组件(PCBA)热力学模型修正的一般方法流程。最后利用该方法对某航空电子产品中一块PCBA的热力学模型进行修正。结果修正结果较精确且只调用2次有限元软件。结论该热模型修正方法具有较高的精确性和高效性,可推广用于工程实践。     

铜铈复合氧化物上石化行业典型VOCs的氧化行为与动力学

采用共沉淀法和等体积浸渍法制备了CuCeO x复合催化剂,对材料的物化性质进行了XRD、低温N2吸脱附、H2-TPR和O2-TPD表征.以石化行业典型VOCs(苯、甲苯和正己烷)为探针污染物,研究了污染物组成与浓度、反应空速、O2浓度、H2O浓度和催化剂种类对其氧化行为的影响,并对反应动力学参数进行了模型拟合.共沉淀得到的催化剂具有均匀的活性相、好的低温可还原性能和较多的活性表面氧物种.甲苯氧化率随着污染物浓度升高而降低,高转化率下苯浓度与其氧化率无相关性,正己烷的氧化率与入口浓度呈正比.苯能够显著抑制甲苯的氧化,而甲苯加入有利于苯的氧化.正己烷对苯氧化的影响较小,但能够促进甲苯的转化,苯系物对正己烷氧化有明显的抑制作用.低空速和高氧浓度都有利于污染物的氧化,氧浓度的变化对正己烷和苯的氧化影响较小.水汽对甲苯的氧化有明显的抑制作用,而对苯和正己烷氧化有明显的促进作用.共沉淀催化剂具有更好的甲苯和苯氧化性能,而无水条件下浸渍催化剂具有更好的正己烷氧化性能.拟一级动力学模型能够很好地模拟不同条件下污染物的氧化行为.     

基于生活垃圾分类的厨余垃圾采样方法研究

与复杂的混合生活垃圾相比,厨余垃圾成分较单一,需要针对性的采样方法.本研究基于生活垃圾分类背景,在《生活垃圾采样和分析方法》(CJ/T 313—2009)的基础上,就采样位点和采样节点数对分类存放的厨余垃圾采样的影响展开研究.研究结果表明,仅采集垃圾桶中间位点的样品不具有代表性,不同情景应有不同的采样策略.当厨余垃圾流节点数少于2时需采集所有节点,当厨余垃圾流节点数为3~7时需采集2个节点,而当厨余垃圾节点数为8~18时需采集3个节点,均少于CJ/T 313—2009中要求的采样节点数.厨余垃圾的总量增大,则其最少采样节点数相应上升,但最少采样点受到厨余垃圾流节点数的制约.     

Determination of explosion limits – Criterion for ignition under non-atmospheric conditions

Many industrial processes are run at non-atmospheric conditions (elevated temperatures and pressures, other oxidizers than air). To judge whether and if yes to what extent explosive gas(vapor)/air mixtures will occur or may be generated during malfunction it is necessary to know the safety characteristic data at the respective conditions. Safety characteristic data like explosion limits, are depending on pressure, temperature and the oxidizer. Most of the determination methods are standardized for ambient conditions. In order to obtain determination methods for non-atmospheric conditions, particularly for higher initial pressures, reliable ignition criteria were investigated. Ignition tests at the explosion limits were carried out for mixtures of methane, propane, n-butane, n-hexane, hydrogen, ammonia and acetone in air at initial pressures up to 20 bar. The tests have been evaluated according to different ignition criteria: visual flame propagation, temperature and pressure rising. It could be shown that flame propagation and occasionally self-sustained combustion for several seconds occurred together with remarkable temperature rise, although the pressure rise was below 3%. The results showed that the combination of a pressure rise criterion of 2% and a temperature rise criterion of 100 K seems to be a suitable ignition criterion for the determination of explosion limits and limiting oxidizer concentration at higher initial pressures and elevated temperatures. The tests were carried out within the framework of a R&D project founded by the German Ministry of Economics and Technology.     

Resolution and Analysis of Spatial Variations and Patterns in an Urban Lake with Rapid Profiling Instrumentation

Rapid response vertical profiling instrumentation was used to document spatial variability and patterns in a small urban lake, Onondaga Lake, associated with multiple drivers. Paired profiles of temperature, specific conductance (SC), turbidity (T_n), fluorometric chlorophyll a (Chl_f), and nitrate nitrogen (NO₃^?) were collected at >30 fixed locations (a “gridding”) weekly, over the spring to fall interval of several years. These gridding data are analyzed (1) to characterize phytoplankton (Chl_f) patchiness in the lake's upper waters, (2) to establish the representativeness of a single long‐term site for monitoring lake‐wide conditions, and (3) to resolve spatial patterns of multiple tracers imparted by buoyancy effects of inflows. Multiple buoyancy signatures were resolved, including overflows from less dense inflows, and interflows to metalimnetic depths and underflows to the bottom from the plunging of more dense inputs. Three different metrics had utility as tracers in depicting the buoyancy signatures as follows: (1) SC, for salinity‐enriched tributaries and the more dilute river that receives the lake's outflow, (2) T_n, for the tributaries during runoff events, and (3) NO₃^?, for the effluent of a domestic waste treatment facility and from the addition of NO₃^? solution to control methyl mercury. The plunging inflow phenomenon, which frequently prevailed, has important management implications.