Chromium (III) recovery from waste acid solution by ion exchange processing using Amberlite IR-120 resin: batch and continuous ion exchange modelling

The use of ion exchange technology was studied to remove chromium (III) from acidic waste solution by Amberlite IR-120 resin. Batch and column experimental tests were conducted to provide data for theoretical models and verify the system performance of the adsorption process. Results of batch equilibrium tests indicated that Langmuir isotherm describes well the adsorption process, whereas experimental data also provide evidence that, under the present experimental conditions, chromium (III) adsorption by Amberlite IR-120 resin is film-diffusion controlled; on the other hand, the theoretical model used in the present investigation was found to predict reasonably well the ion exchange breakthrough performance.     

Electrostatic Precipitation of Ultrafine Particles Enhanced by Simultaneous Diffusional Deposition on Wire Screens

Abstract

A laboratory-scale electrostatic precipitator has been designed and constructed in which the grounded collector plate has been substituted by a set of wire screens placed perpendicularly to the gas flow. Particles are deposited onto the screens by two mechanisms—electrostatic deposition and diffusional deposition—which act simultaneously. On the one hand, electrostatic deposition is effective for relatively large particles, but it is quite ineffective for the smallest ones because their charging probability in the corona field is too low. On the other hand, the diffusional collection efficiency of particles on fibers is high for small particles but low for the larger ones. Therefore, the simultaneous diffusional-electrostatic precipitation may become a useful technique for efficient filtration of particles below 0.1 μm. A preliminary experimental evaluation of this filtering device has shown that submicrometer particles with diameters down to a few nanometers can be collected with number efficiencies greater than 99%.     

Uphill permeation of Cr(VI) using Hostarex A327 as ionophore by membrane-solvent extraction processing

The transport of chromium by the emulsion pertraction technology (EPERT) using Hostarex A327 (tertiary amine) as a carrier has been investigated. The permeation of the metal is studied as a function of various experimental variables: hydrodynamic conditions, concentration of Cr(VI) and HCl in the source phase, carrier concentration and diluent in the organic phase, strippant concentration in the stripping phase and support characteristics of the membrane. The mass transfer coefficient and the thickness of the aqueous source boundary layer were estimated from the experimental data. Furthermore, the selectivity of the Hostarex A327-bases EPERT towards different metal ions and the behaviour of the system against other carriers are presented.     

Gasification of the char derived from distillation of granulated scrap tyres

This work reports the effect of pressure on the steam/oxygen gasification at 1000 °C of the char derived from low temperature-pressure distillation of granulated scrap tyres (GST). The study was based on the analysis of gas production, carbon conversion, cold gas efficiency and the high heating value (HHV) of the product. For comparison, similar analyses were carried out for the gasification of coals with different rank.In spite of the relatively high ash (≈12 wt.%) and sulphur (≈3 wt.%) contents, the char produced in GST distillation can be regarded as a reasonable solid fuel with a calorific value of 34 MJ kg⁻¹. The combustion properties of the char (E_A ≈ 50 kJ mol⁻¹), its temperature of self-heating (≈264 °C), ignition temperature (≈459 °C) and burn-out temperature (≈676 °C) were found to be similar to those of a semi-anthracite.It is observed that the yield, H₂ and CO contents and HHV of the syngas produced from char gasification increase with pressure. At 0.1 MPa, 4.6 Nm³ kg_char⁻¹ of syngas was produced, containing 28% v/v of H₂ and CO and with a HHV around 3.7 MJ Nm⁻³. At 1.5 MPa, the syngas yield achieved 4.9 Nm³ kg_char⁻¹ with 30% v/v of H₂-CO and HHV of 4.1 MJ Nm⁻³. Carbon conversion significantly increased from 87% at 0.1 MPa to 98% at 1.5 MPa.It is shown that the char derived from distillation of granulated scrap tyres can be further gasified to render a gas of considerable heating value, especially when gasification proceeds at high pressure.     

Changes in Physical and Biological Soil Quality Indicators in a Tropical Crop System (Havana,Cuba) in Response to Different Agroecological Management Practices

The objective of our study was to assess the response of physical (aggregate stability and bulk density) and biological (enzyme activities and microbial biomass) soil quality indicators to the adoption of agroecological management practices, such as the planting of forage species (forage area) and the rotation of local crops (polycrop area), carried out in a representative tropical pasture on an integrated livestock–crop farm. The pasture system was used as control (pasture area). In all three areas, the values of water-soluble C were higher in the rainy season compared to the dry season. Pasture and forage areas had the highest percentage of stable aggregates in the rainy season, while polycrops developed soils with less stable aggregates. Soil bulk density was lower in the pasture and forage areas than in the polycrop area. In the pasture area, the microbial biomass C values, dehydrogenase, urease, protease-BAA, acid phosphatase, and -glucosidase activities were higher than in the forage and polycrop areas, particularly in the dry season. The highest increase in the microbial biomass C in the rainy season, with respect to the dry season, was recorded in the pasture area (about 1.2-fold). In conclusion, the planting of forage species can be considered an effective practice for carrying out sustainable, integrated livestock–crop systems, due to its general maintenance of soil quality, while the adoption of polycrop rotations appears to be less favorable because it decreases soil quality.     

Electrostatic precipitation of ultrafine particles enhanced by simultaneous diffusional deposition on wire screens

A laboratory-scale electrostatic precipitator has been designed and constructed in which the grounded collector plate has been substituted by a set of wire screens placed perpendicularly to the gas flow. Particles are deposited onto the screens by two mechanisms--electrostatic deposition and diffusional deposition--which act simultaneously. On the one hand, electrostatic deposition is effective for relatively large particles, but it is quite ineffective for the smallest ones because their charging probability in the corona field is too low. On the other hand, the diffusional collection efficiency of particles on fibers is high for small particles but low for the larger ones. Therefore, the simultaneous diffusional-electrostatic precipitation may become a useful technique for efficient filtration of particles below 0.1 microm. A preliminary experimental evaluation of this filtering device has shown that submicrometer particles with diameters down to a few nanometers can be collected with number efficiencies greater than 99%.     

The impact of tillage practices on arbuscular mycorrhizal fungal diversity in subtropical crops.

Arbuscular mycorrhizal fungi (AMF) are a main component of soil microbiota in most agrosystems. As obligately mutualistic symbionts, they colonize the roots of the majority of plants, including crop plants. We used molecular techniques to investigate how different tillage systems (moldboard, shred-bedding, subsoil-bedding, and no tillage) can influence the AM fungal community colonizing maize, bean, and sorghum roots in an experimental site located in northern Tamaulipas, Mexico. Roots from 36 plants were analyzed using AM fungal-specific primers to partially amplify the small subunit (SSU) of the ribosomal DNA genes. More than 880 clones were screened for restriction fragment length polymorphism (RFLP) variation, and 173 of these were sequenced. Ten AM fungal types were identified and clustered into three AM fungal families: Gigasporaceae, Glomaceae, and Paraglomaceae. Glomus was the dominating taxon in all the samples. Four of the 10 identified types were distinct from any previously published sequences and could correspond to either known unsequenced species or unknown species. The fungal diversity was low in the four agriculture management systems, but the multidimensional scaling (MDS) analysis and log-linear-saturated model indicated that the composition of the AMF community was significantly affected by the tillage system. In conclusion, since some fungal types were treatment specific, agricultural practices could directly or indirectly influence AM biodiversity.     

Environmental impact and management of phosphogypsum

The production of phosphoric acid from natural phosphate rock by the wet process gives rise to an industrial by-product called phosphogypsum (PG). About 5 tons of PG are generated per ton of phosphoric acid production, and worldwide PG generation is estimated to be around 100–280 Mt per year. This by-product is mostly disposed of without any treatment, usually by dumping in large stockpiles. These are generally located in coastal areas close to phosphoric acid plants, where they occupy large land areas and cause serious environmental damage. PG is mainly composed of gypsum but also contains a high level of impurities such as phosphates, fluorides and sulphates, naturally occurring radionuclides, heavy metals, and other trace elements. All of this adds up to a negative environmental impact and many restrictions on PG applications. Up to 15% of world PG production is used to make building materials, as a soil amendment and as a set controller in the manufacture of Portland cement; uses that have been banned in most countries. The USEPA has classified PG as a “Technologically Enhanced Naturally Occurring Radioactive Material” (TENORM).