Unemployment effects of climate policy

This paper models the unemployment effects of restrictions on greenhouse gas emissions, embodying two of the most significant types of short-term economic imperfections that generate unemployment: sectoral rigidities in labor mobility and sectoral rigidities in wage adjustments. A labor policy is also analyzed that would reduce the direct negative economic effects of the emissions restrictions.The politics of limiting greenhouse gas emissions are often dominated by relatively short-term considerations. Yet the current economic modeling of emissions limitations does not embody economic features that are likely to be particularly important in the short term, in particular, the politically sensitive unemployment rate. Moreover, only a few of these studies also consider policies that would offset the negative direct economic effects of emissions restrictions. For plausible estimates of the parameters, the model shows that, with the labor market imperfections, if there were no offsetting policies, the reductions in GNP in the U.S. in the first 10 years after emissions restrictions were imposed would be as much as 4%. However, if there were two policies, instead of just one: a counteracting labor market policy, as well as the emissions restrictions, the negative direct economic effects could be completely eliminated.     

Mineral contents and proximate composition of Pistacia vera kernels

The mineral contents of Pistacia vera kernels were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES). The minimum and maximum values of K, P, Ca, Mg, and S elements ranged from 6,333 to 8,064 mg/kg, 3,630 to 5,228 mg/kg, 1,614 to 3,226 mg/kg, 1,716 to 2,402 mg/kg, and 1,417 to 1,825 mg/kg, respectively. In addition, the mean values of Fe, Zn, Cu, Mn, B, Mo, Cr and Ni elements were determined as 42.48, 20.52, 12.81, 7.48, 11.31, 0.106, 0.511 and 1.67 mg/kg, respectively. Ash levels of kernels were found between 2.28 % (Urfa) and 2.79 % (Halebi). In addition, crude oil and protein contents were determined between 48.8 % (Halebi) to 55.3 % (Siirt) and 23.33 % (Uzun) to 27.16 % (Halebi), respectively.     

Time-varying causality between income inequality and ecological footprint in Turkey

Environmental Science and Pollution Research - This paper investigates the relationship between income inequality and environmental degradation for the case of Turkey between 1987 and 2017 through...     

EXPOSURE ASSESSMENT OF POPULATIONS USING ENVIRONMENTAL MODELING,DEMOGRAPHIC ANALYSIS,AND GIS1

ABSTRACT: Simulation of ground-water flow and fate of contaminants in the subsurface environment constitutes a major phase of most environmental assessment and site remediation studies. These simulation studies yield information on spatial and temporal distributions of contaminants in the subsurface media. An important use of this information is to conduct exposure assessment studies. Spatial and temporal distributions of both chemical concentrations and exposed populations render this integrated exposure analysis task rather difficult. Geographic Information Systems (GIS), on the other hand, provide a platform in which layered, spatially distributed databases can be manipulated with ease, thereby simplifying exposure analysis tasks significantly. In this paper, we describe procedures that combine the simulation models and demographic databases under a GIS platform to automate the exposure assessment phase of a typical health assessment study. Procedures developed herein significantly simplify the post-processing phase of the analysis, and render the overall task more ‘user friendly.’ A site-specific application is included as a demonstration of the proposed process.     

Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.     

Bleaching of chemithermomechanical pulp (CTMP) using environmentally friendly chemicals

Increasing environmental restrictions require a reduction in the use of chlorine-containing bleaching agents mainly chlorine gas. There are several approaches to this goal, including changes in the cooking process and the influent treatment. The aim of this study is to improve the physical and optical properties of chemithermomechanical pulp (CTMP) which has low brightness and strong tendency towards aging in chlorine-free bleaching sequences. For this reason, initially 7 different sets of single stage hydrogen peroxide bleaching operations were performed. After the analysis of the data obtained, the optimum bleaching conditions were as: H2O2 ratio on oven dry (o.d) raw material: 2%, NaOH ratio (on o.d raw material): 1.5%, MgSO4 ratio (on o.d raw material) : 0.5%, Na2SiO3 ratio (on o.d raw material) : 3%, EDTA ratio (on o.d raw material) : 0.5%, reaction time: 60 minutes, reaction temperature: 70 degrees C and concentration: 16%. Then, 11 different sets of two and multistage H2O2 (P), NaBH4 (B), and Na2S2O4 (S) bleaching operations were carried out. Optimum bleaching conditions were found in bleaching of BPSP with 4 stage sequences. As a result, CTMP brightness was observed to increase from 47% to 81.37% elrepho while yellowness of bleached pulps decreased from 321 per thousand to 164.01 per thousand elrepho.     

Uranium bioassay and radioactive dust measurements at some uranium processing sites in Egypt--health effects

The safety of radiation workers in the uranium mining industry requires close and continuous monitoring of their working conditions. In this study, external radiation surveillance, radioactive dust monitoring and the bioassay of uranium were carried out in some processing sites. As dust represents one of the most important sources of radiation exposure in mills and mines, dust monitoring and bioassays were performed for a sample of workers on the production lines. The concentration of uranium in air ranged from 22.6 x 10(-7) to 11.1 x 10(-5) Bq cm-3, and the exposure levels ranged from 1 to 80 microSv h-1. Laser fluorimetric determination of uranium in urine samples showed concentrations in the range 8.4-29.2 micrograms L-1. Renal function parameters, such as serum creatinine and urea, and hematological parameters were determined in an attempt to correlate them with radiation exposure and the health status of the workers. Urine specimens collected from workers at the ore crushing and separation site showed elevated concentrations of uranium (up to 29.2 micrograms L-1) and a strong correlation between these concentrations and the registered serum creatinine. The mean uranium excretion in the investigated group was more than 20 times the occupational exposure decision level for urine uranium of 0.8 microgram L-1.