Chemical states of arsenic contained in sewage sludge incineration ash and insolubilized material

Journal of Material Cycles and Waste Management - The chemical states of arsenic contained in 4 kinds of sewage sludge incineration ash and insolubilized materials are analyzed using a leaching...     

离心脱水机的污泥脱水实验及应用分析

简要阐述了高效型离心脱水机的工作原理及其在上海两个污水处理厂进行的现场污泥脱水实验，结果表明，污泥脱水效果良好，从污泥性状与脱水性分析说明，污泥浓度低，有机物含量高，则脱水性差；有机物含量低，则脱水性好，应用分析表明，随着污泥性状逐年变化，离心脱水机将成为流脱水机。     

Perfluorosulfonates and perfluorocarboxylates in snow and rain in Dalian,China

Samples of precipitation events (snow and rain) in Dalian, a typical coastal town in China, were analyzed for perfluorosulfonates (PFSAs) and perfluorocarboxylates (PFCAs) to investigate atmospheric contamination by these compounds. In the snow event on December 16, 2006, samples were collected from 21 different sites and in another 6 precipitation events, samples were collected from a single location. Four PFSAs (C4, C6, C8, C10) and seven PFCAs (C6–12) were analyzed. Among the homologues, perfluorooctane sulfonate (PFOS) concentrations were the highest with a geometric mean (GM) of 145 ng/L (n = 21) during the snow event on December 16, 2006, followed by perfluorooctanoate (PFOA) with a GM of 24.7 ng/L (n = 21). Concentrations of perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS) and perfluoroheptanoate (PFHpA) were more than two orders of magnitude lower than that of PFOS. Other PFSAs and PFCAs were found to be below the limit of detection in all the samples. In other 6 precipitation events, PFSAs and PFCAs were detected approximately in the same order of magnitude in both snow and rain. The results indicate that wet deposition may be a potential transport mechanism of perfluorinated chemicals in the environment.     

Studies on enhanced degradable plastics: 1. The geographic variability in outdoor lifetimes of enhanced photodegradable polyethylenes

Studies on three types of enhanced photodegradable polyethylenes showed tensile elongation at break to be a suitable parameter for assessing disintegration due to outdoor weathering. Disintegration rates varied greatly with exposure location, with Arizona the harshest environment and Washington and New Jersey the mildest. The rate of breakdown of the enhanced degradable polyethylenes relative to unmodified plastic was termed an enhancement factor. For the materials studied, average enhancement factors generally ranged from five to fifteen. The location-dependent variability in rate parameters can be mostly explained in terms of different average radiation levels and temperatures at these locations. A duplicate exposure protocol was developed to determine if the test data were complicated by short-term fluctuations in sunlight or temperature during exposure.     

Biological methane production coupled with sulfur oxidation in a microbial electrosynthesis system without organic substrates

Methane is produced in a microbial electrosynthesis system (MES) without organic substrates. However, a relatively high applied voltage is required for the bioelectrical reactions. In this study, we demonstrated that electrotrophic methane production at the biocathode was achieved even at a very low voltage of 0.1 V in an MES, in which abiotic HS⁻ oxidized to SO₄²⁻ at the anodic carbon-cloth surface coated with platinum powder. In addition, microbial community analysis revealed the most probable pathway for methane production from electrons. First, electrotrophic H₂ was produced by syntrophic bacteria, such as Syntrophorhabdus, Syntrophobacter, Syntrophus, Leptolinea, and Aminicenantales, with the direct acceptance of electrons at the biocathode. Subsequently, most of the produced H₂ was converted to acetate by homoacetogens, such as Clostridium and Spirochaeta 2. In conclusion, the majority of the methane was indirectly produced by a large population of acetoclastic methanogens, namely Methanosaeta, via acetate. Further, hydrogenotrophic methanogens, including Methanobacterium and Methanolinea, produced methane via H₂.     

Comparative study of the alkyl and peroxy radical scavenging activities of polyphenols

The lipid antioxidative activities of polyphenols with high oxygen radical capacities need to be measured at low oxygen tensions. In this study, differences in the reactivity of catechins and resveratrols towards alkyl (R*) and peroxy (PhCOO*) radicals were observed at lower oxygen pressures. The radical scavenging activities for catechin, epicatechin, resveratrol and n-propyl gallate with or without 2-mercapto-1-methylimidazole (MMI), a thiol were investigated by differential scanning calorimetry (DSC) monitoring of the polymerization of methyl methacrylates (MMA) initiated by 2,2'-azobisisobutyronitrile (AIBN, an R* radical) or benzoyl peroxide (BPO, an PhCOO* radical) at 70 degrees C under nearly anaerobic conditions. Catechin, epicatechin and resveratrol with MMI, but not n-propyl gallate showed the less length of induction period than that for corresponding ones without MMI, probably resulting from the reaction of MMI radicals with molecular oxygen in the system. Also, the inhibitory rate of propagation (R(inh)) for catechin and resveratrol in the BPO system was much more greater than that in the AIBN system. The reactivity of catechins and resveratrol with R() or PhCOO* radical was considerably different, whereas n-propyl gallate did not different between radicals under nearly anaerobic conditions.     

A method for determination of methyl chloride concentration in air trapped in ice cores

A method for measuring the concentration of methyl chloride (CH3Cl) in air trapped in an ice core was developed. The method combines the air extraction by milling the ice core samples under vacuum and the analysis of the extracted air with a cryogenic preconcentration/gas chromatograph/mass spectrometry system. The method was applied to air from Antarctic ice core samples estimated to have been formed in the pre-industrial and/or early industrial periods. The overall precision of the method deduced from duplicate ice core analyses was estimated to be better than +/-20 pptv. The measured CH3Cl concentration of 528+/-26 pptv was similar to the present-day concentration in the remote atmosphere as well as the CH3Cl concentration over the past 300 years obtained from Antarctic firn air and ice core analyses.     

Quantum-chemical descriptors for estimating hemolytic activity of aliphatic and aromatic methacrylates

Methacrylates such as methyl methacrylate (6), triethyleneglycol dimethacrylate (5) and bisphenol A glycidyldimethacrylate, bis-GMA, (8) are widely used as materials in dental resins perturbation of the phosphatidylcholine-cholesterol interaction. Such effects of aromatic methacrylates may be involved in their marked hemolytic action.     

750kV串抗并联避雷器泄漏监测器指示异常分析研究

针对750 kV串抗并联避雷器的泄漏监测器指示异常情况,从避雷器选型、泄漏电流计算和电抗器磁场强度影响3个方面进行全面分析,并提出了处理措施,为后续电抗器侧加装并联避雷器有一定的参考价值。     

Effect of void structure of photocatalyst paper on VOC decomposition

TiO₂ powder-containing paper composites, called TiO₂ paper, were prepared by a papermaking technique, and their photocatalytic efficiency was investigated. The TiO₂ paper has a porous structure originating from the layered pulp fiber network, with TiO₂ powders scattered on the fiber matrix. Under UV irradiation, the TiO₂ paper decomposed gaseous acetaldehyde more effectively than powdery TiO₂ and a pulp/TiO₂ mixture not in paper form. Scanning electron microscopy and mercury intrusion analysis revealed that the TiO₂ paper had characteristic unique voids ca. 10 μm in diameter, which might have contributed to the improved photocatalytic performance. TiO₂ paper composites having different void structures were prepared by using beaten pulp fibers with different degrees of freeness and/or ceramic fibers. The photodecomposition efficiency was affected by the void structure of the photocatalyst paper, and the initial degradation rate of acetaldehyde increased with an increase in the total pore volume of TiO₂ paper. The paper voids presumably provided suitable conditions for TiO₂ catalysis, resulting in higher photocatalytic performance by TiO₂ paper than by TiO₂ powder and a pulp/TiO₂ mixture not in paper form.