Monochlorobenzene Marine Risk Assessment with Special Reference to the Osparcom Region: North Sea

This risk assessment on monochlorobenzene was carried out for the marine environment, following methodology given in the EU risk assessment Regulation (1488/94) and Guidance Document of the EU New and Existing Substances Regulation (TGD, 1996). Data from analytical monitoring programmes in large rivers and estuaries in the North Sea area were collected and evaluated for effects and environmental concentrations. Risk is indicated by the ratio of predicted environmental concentration (PEC) to predicted no-effect concentration (PNEC) for the marine aquatic environment. In total, 27 data for fish, 24 data for invertebrates and 13 data for algae were evaluated. Acute and chronic toxicity studies were taken into account and appropriate assessment factors used to define a final PNEC value of 32 micro/l. Recent monitoring data indicate that monochlorobenzene levels in surface waters are below determination limits of 0.1, 0.2, 0.5 microg/l used in monitoring programs. Assuming that half of the lowest determination (0.1 microg/l) is typical, a PEC of 0.05 microg/l was derived. A worst case of 0.5 microg/l is assumed. PEC/PNEC ratios give safety factors of 60 to over 500, taking no account of dilution in the sea. Monochlorobenzene is not a 'toxic, persistent and liable to bioaccumulate' substance sensu the Oslo and Paris Conventions for the Prevention of Marine Pollution (OSPAR-DYNAMEC) criteria. Environmental fate and effects data indicate that current use of monochlorobenzene poses no unacceptable risk to the aquatic environment.     

Mechanical and Barrier Properties of Biodegradable Films Made from Chitosan and Poly (Lactic Acid) Blends

Biodegradable film blends of chitosan with poly(lactic acid) (PLA) were prepared by solution mixing and film casting. The main goal of these blends is to improve the water vapor barrier of chitosan by blending it with a hydrophobic biodegradable polymer from renewable resources. Mechanical properties of obtained films were assessed by tensile test. Thermal properties, water barrier properties, and water sensitivity were studied by differential scanning calorimeter analysis, water vapor permeability measurements, and surface-angle contact tests, respectively. The incorporation of PLA to chitosan improved the water barrier properties and decreased the water sensitivity of chitosan film. However, the tensile strength and elastic modulus of chitosan decreased with the addition of PLA. Mechanical and thermal properties revealed that chitosan and PLA blends are incompatible, consistent with the results of Fourier transform infrared (FTIR) analysis that showed the absence of specific interaction between chitosan and PLA.     

Benzene Exposure Assessment at Indoor, Outdoor and Personal Levels. The French Contribution to the Life MACBETH Programme

Many VOC represent hazards to human health through chronic exposure. Recent European and world-wide legislation proposes limit values for ambient concentrations of these compounds. However, very little experimental data exists for true population exposure. In 1996, the European MACBETH initiative set out to measure population exposure to benzene in six European cities. This study details the French contribution to this program. Six campaigns were carried out, each comprising measurements at 100 outdoor sites and the participation of 50 non-smoking volunteers who wore personal samplers and had passive monitors installed in their homes. Iso-concentration maps were drawn for each campaign and the results showed that outdoor concentrations were significantly lower than indoors. Almost 75% of the volunteers were exposed to mean concentrations higher than the limit value of 5µgm³. It is demonstrated that personal exposure levels cannot be deduced simply by combining indoor and outdoor background concentrations. It is also shown that there is need for better knowledge of the contributions to overall exposure of outdoor microenvironments and the authors hope that future European directives will take this into account.     

Temporal variation in protein, carbohydrate, and lipid concentrations in Paramuricea clavata (Anthozoa, Octocorallia): evidence for summer–autumn feeding constraints

Temporal variations in protein, carbohydrate, and lipid levels were studied in a passive suspension feeder, the gorgonian Paramuricea clavata. The samples were collected every month for mature and immature colonies over a three-year period (1997–2000). The relationship between biochemical composition and reproductive output was examined on the basis of the 1998 and 1999 data. In female and male P. clavata colonies, the tissue displayed differences in lipid concentrations only in winter–spring, due to the high lipid levels attained by female colonies in this period. Immature colonies showed significant differences in lipid concentration only with respect to mature females in spring. There were clear seasonal trends in the lipid and carbohydrate levels in P. clavata, with maximum values in winter–spring [male lipid 212±75 SD μg mg⁻¹ of organic matter (OM) and female lipid 274±103 SD μg mg⁻¹ of OM; male and female carbohydrate 68±14 SD μg mg⁻¹ of OM], coinciding with maximum food concentration/quality, and minimum values in summer–autumn (male and female lipid 155±57 SD μg mg⁻¹ of OM; male and female carbohydrate 56±14 SD μg mg⁻¹ of OM), coinciding with low food concentration/quality. The relationship between reproductive output and tissue concentrations of lipids, carbohydrates, and proteins was not straightforward, although there was an evident overlap of the lipid accumulation and the gonadal development. The results of this study show that protein, carbohydrate, and lipid levels may provide a record of episodes in the ecological cycle bearing on the trophic aspects of the target species. The results indicate that information on seasonal biochemical levels may explain benthopelagic coupling processes, provided factors such as natural diet, feeding rates, reproduction, and growth are well understood.     

Are flocculants required in a flocculant process?

The effectiveness of solids abatement by pH increase was investigated using the jar test procedure with a bentonite tap water suspension and an urban wastewater and an oxidation pond effluent. The results indicated that, depending on the suspended particles and on the dissolved ions, pH values between 9.5 and 12 induced extensive solids elimination without adding any other chemical than a base, i.e. sodium hydroxide or lime. The major effective reactions are then the calcium carbonate precipitation and the magnesium hydroxide precipitation. Moreover, this process does not require a flocculation step but only a precipitation step where the particles are entrapped by sweep coagulation and adsorption-coagulation. A continuous reactor was operated with an oxidation pond effluent. A suspended solids concentration less than 30 mg/l was obtained by adjusting pH between 11 and 11.5 while the reactor was operated up to 20 m/h superficial upflow velocity corresponding to a residence time through the whole unit of only 5 minutes. The sludge settling velocity depends on pH and on the primary particles but a maximum settling velocity larger than 1 m/h is easily reached. The concentration factor is then about 100. Environmental policy implications of this technique are that it allows to significantly upgrade a stabilization pond effluent and can be used when a high pH situation is acceptable.     

A rule-based screening environmental risk assessment tool derived from EUSES

Within the context and scope of the forthcoming European Union chemical regulations (REACH), there is a need to be able to prioritise the chemicals for evaluation. Therefore, a simple, pragmatic and adequately conservative approach for the identification of substances of very low or no immediate concern at an early stage is presented. The fundamental principles and basic concepts are derived from the EU Technical Guidance Document and EUSES, and are translated into an easy-to-use rule-based system. For this development, the effect on risk characterisation ratios (RCRs) of the key environmental parameters in EUSES was quantified (taking into account several standardised chemical release scenarios). Using statistical analysis, ranges were identified for each key parameter, within which the end result of the assessment was not significantly affected. This information was then translated into a lookup table from which environmental risk characterisation ratios can be directly read as a function of a few parameters.     

Dichloromethane Marine Risk Assessment with Special Reference to the Osparcom Region: North Sea

This risk assessment on dichloromethane was carried out specifically for the marine environment, following methodology given in the EU risk assessment Regulation (1488/94) and Guidance Document of the EU New and Existing Substances Regulation (TGD, 1997). The study consists of collection and evaluation of data on effects and environmental concentrations from analytical monitoring programs in large rivers and estuaries in the North Sea area. The risk is indicated by the ratio of 'predicted environmental concentrations' (PEC) to 'predicted no-effect concentrations' (PNEC) for the marine aquatic environment. In total, 23 studies for fish, 17 studies for invertebrates and 6 studies for algae were evaluated. Both acute and chronic toxicity studies were taken into account and appropriate assessment factors used to define a PNEC value of 830 microg/l. Most of the available monitoring data apply to rivers and estuaries and were used to calculate PECs. The most recent data (1983--1995) support a typical PEC for dichloromethane lower than 0.2 microg/l and a worst case PEC of 13.6 microg/l. Dichloromethane is not a 'toxic, persistent and liable to bioaccumulate' substance sensu the Oslo and Paris Conventions for the Prevention of Marine Pollution (OSPAR-DYNAMEC). The calculated PEC/PNEC ratios give margins of 60 to 4000 between the PNEC and PEC, dilution within the sea would further increase these margins. It can be concluded that the present use of dichloromethane does not present a risk to the marine aquatic environment.     

Learning to Drive: Learners’ Self-Reported Cognitive Failure Level Predicts Driving Instructor’s Observation Rating of Driving Performance

Objectives. Evidence increases that cognitive failure may be used to screen for drivers at risk. Until now, most studies have relied on driving learners. This exploratory pilot study examines self-report of cognitive failure in driving beginners and error during real driving as observed by driving instructors. Methods. Forty-two driving learners of 14 driving instructors filled out a work-related cognitive failure questionnaire. Driving instructors observed driving errors during the next driving lesson. In multiple linear regression analysis, driving errors were regressed on cognitive failure with the number of driving lessons as an estimator of driving experience controlled. Results. Higher cognitive failure predicted more driving errors(p < .01) when age, gender and driving experience were controlled in analysis. Conclusions. Cognitive failure was significantly associated with observed driving errors. Systematic research on cognitive failure in driving beginners is recommended.     

Euro Chlor Risk Assessment for the Marine Environment Osparcom Region: North Sea - Principles and Purposes -

A voluntary programme on risk assessment for chlorinated chemicals was initiated by Euro Chlor (the European Chlorine Producers Federation). The study was targeted on the marine environment, starting with the North Sea, and the methodology used was based on the European Union risk assessment principles. Details of the method used are described in this paper. A first set of five compounds is published in this special issue: chloroform, 1,2-dichloroethane, 1,1,2-trichloroethane, trichloroethylene, tetrachloroethylene.     

Two unusual chromosome aberrations ascertained by sonographic anomalies

We describe two cases of sonographic abnormalities associated with unusual chromosomal aberrations. Case 1 presented with a cystic hygroma at 12 weeks' gestation. Cytogenetic analysis revealed an unbalanced complex chromosome rearrangement implicating chromosomes 6, 13 and 21 (karyotype: 47,XX,t(6;21;14)(q14;q21;q21)mat,+21) and corresponding to a complete trisomy 21. This anomaly resulted from malsegregation of a maternal balanced three-way translocation. For case 2, an alobar holoprosencephaly was identified by ultrasonography at 23 weeks' gestation. Chromosomal analysis showed a recombinant rec (13), dup q chromosome, secondary to unequal crossing-over of a paternal pericentric inversion of chromosome 13, giving rise to partial trisomy 13q (karyotype: 46,XX,rec(13)dup(13q)inv(13)(p11q21)pat). These two cases illustrate the role of ultrasound in leading to detection not only of foetal chromosomal aberrations but also of rare balanced chromosomal rearrangements presented by one of the two parents. Copyright © 2004 John Wiley & Sons, Ltd.