A comparison of X-ray fluorescence and wet chemical analysis of air filter samples from a scrap lead smelting operation

Personal and area air samples were taken at a scrap lead smelter operation in a bullet manufacturing facility. Samples were taken using the 37-mm styrene-acrylonitrile closed-face filter cassette (CFC, the current US standard device for lead sampling), the 37-mm GSP or "cone" sampler, the 25-mm Institute of Occupational Medicine (IOM) inhalable sampler, and the 25-mm Button sampler (developed at the University of Cincinnati). Polyvinylchloride filters were used for sampling. The filters were pre- and post-weighed, and analyzed for lead content using a field-portable X-ray fluorescence (XRF) analyzer. The filters were then extracted with dilute nitric acid in an ultrasonic extraction bath and the solutions were analyzed by inductively coupled plasma optical emission spectroscopy. The 25-mm filters were analyzed using a single XRF reading, while three readings on different parts of the filter were taken from the 37-mm filters. The single reading from the 25-mm filters was adjusted for the nominal area of the filter to obtain the mass loading, while the three readings from the 37-mm filters were inserted into two different algorithms for calculating the mass loadings, and the algorithms were compared. The IOM sampler was designed for material collected in the body of the sampler to be part of the collected sample as well as that on the filter. Therefore, the IOM sampler cassettes were rinsed separately to determine if wall-loss corrections were necessary. All four samplers gave very good correlations between the two analytical methods above the limit of detection of the XRF procedure. The limit of detection for the 25-mm filters (5 microg) was lower than for the 37-mm filters (10 microg). The percentage of XRF results that were within 25% of the corresponding ICP results was evaluated. In addition, the bias from linear regression was estimated. Linear regression for the Button sampler and the IOM sampler using single readings and the GSP using all tested techniques for total filter loading gave acceptable XRF readings at loadings equivalent to sampling at the OSHA 8-hour Action Level and Permissible Exposure Limit. However, the CFC only had acceptable results when the center reading corrected for filter area was used, which was surprising, and may be a result of a limited data set. In addition to linear regression, simple estimation of bias indicated reasonable agreements between XRF and ICP results for single XRF readings on the Button sampler filters, (82% of the individual results within criterion), and on the IOM sampler filters (77% or 61%--see text), and on the GSP sampler filters using the OSHA algorithm (78%). As a result of this pilot project, all three samplers were considered suitable for inclusion in further field research studies.     

Young northern pike,yellow perch and crayfish as bioindicators in a mercury contaminated watercourse

Young-of-the-year and yearling northern pike (Esox lucius), yearling yellow perch (Perca flavescens) and adult crayfish (Orconectes virilis) were collected in the mercury-contaminated Wabigoon/English/Winnipeg River System, Ontario, and analyzed for total mercury. Analysis of mercury concentrations in these organisms produced consistent geographical trends; i.e. mercury concentrations in biota downstream of Dryden > English River system > Winnipeg River system > control sites. In the Wabigoon River system the bioavailability of mercury increases with distance downstream of the historical point source. Mercury concentrations in the biota studied were highly correlated with mercury concentrations in fish species which are of sport and commercial interest. The locations where young fish obtain their bodyburdens are known typically within 100 m. The biota studied compare favourably with the criteria proposed by Phillips (1980) as prerequisites for biological indicators. The wide distribution of young pike, perch and crayfish in North America, Europe and Asia may enhance their appeal as biomonitors.The views expressed are those of the authors and do not necessarily reflect the views of the Ontario Ministry of the Environment. No endorsement should be inferred.     

Wetland loss and substitution by the Section 404 permit program in southern California,USA

To test the effectiveness of the 404 permit program in preventing a net loss of wetland resources, 75 Section 404 projects permitted in the years 1987–1989 and located in a portion of southern California were evaluated. From this group of projects, 80.47 ha of wetlands were affected by Section 404 permits and the Army Corps of Engineers required 111.62 ha of wetland mitigation. To verify the successful completion of each mitigation project, all 75 project sites were visited and evaluated based on the amount of dead vegetation, growth and coverage, and the number of invasive species. Based on the field verification results, the actual amount of completed mitigation area was 77.33 ha, resulting in a net loss of 3.14 ha of wetland resources in the years 1987–1989. By comparing the types of wetlands lost to the types of wetlands mitigated, it is apparent that, in particular, freshwater wetlands are experiencing a disproportionately greater loss of area and that riparian woodland wetlands are most often used in mitigation efforts. The net result of these accumulated actions is an overall substitution of wetland types throughout the region. Results also indicate that, typically, large-scale mitigation projects are more successful compared to smaller projects and that successful compliance efforts are not evenly distributed throughout the region. We recommend that better monitoring, mitigation in-kind, mitigation banking, and planning on a regional or watershed scale could greatly improve the effectiveness of the Section 404 permitting program.     

Development of Layered Sediment Structure and its Effects on Pore Water Transport and Hyporheic Exchange

Hyporheic exchange is known to provide an important control on nutrient and contaminant fluxes across the stream-subsurface interface. Similar processes also mediate interfacial transport in other permeable sediments. Recent research has focused on understanding the mechanics of these exchange processes and improving estimation of exchange rates in natural systems. While the structure of sediment beds obviously influences pore water flow rates and patterns, little is known about the interplay of typical sedimentary structures, hyporheic exchange, and other transport processes in fluvial/alluvial sediments. Here we discuss several processes that contribute to local-scale sediment heterogeneity and present results that illustrate the interaction of overlying flow conditions, the development of sediment structure, pore water transport, and stream-subsurface exchange. Layered structures are shown to develop at several scales within sediment beds. Surface sampling is used to analyze the development of an armor layer in a sand-and-gravel bed, while innovative synchrotron-based X-ray microtomography is used to observe patterns of grain sorting within sand bedforms. We show that layered bed structures involving coarsening of the bed surface increase interfacial solute flux but produce an effective anisotropy that favors horizontal pore water transport while limiting vertical penetration.     

Regional status assessment of stony corals in the US Virgin Islands

States may protect coral reefs using biological water quality standards outlined by the Clean Water Act. This requires biological assessments with indicators sensitive to human disturbance and regional, probability-based survey designs. Stony coral condition was characterized on a regional scale for the first time in the nearshore waters of the US Virgin Islands (USVI). Coral composition, abundance, size, and health were assessed at 66 stations in the St. Croix region in fall 2007 and at 63 stations in the St. Thomas and St. John region in winter 2009. Indicators were chosen for their sensitivity to human disturbance. Both surveys were probability-based (random) designs with station locations preselected from areas covered by hardbottom and coral reef substrate. Taxa richness was as high as 21 species but more than half the area of both regions exhibited taxa richness of <10 species in the 25 m² transect area. Coral density was as high as 5 colonies m^?2 but more than half the area of both regions had <2 colonies m^?2. Both regions showed similar dominant species based on frequency of occurrence and relative abundance. Because of large colony sizes, Montastrea annularis provided more total surface area and live surface area than more abundant species. The surveys establish baseline regional conditions and provide a foundation for long-term regional monitoring envisioned by the USVI Department of Planning and Natural Resources. The probabilistic sampling design assures the data can be used in Clean Water Act reporting.     

Control of invasive rats on islands and priorities for future action

Invasive rats are one of the world's most successful animal groups that cause native species extinctions and ecosystem change, particularly on islands. On large islands, rat eradication is often impossible and population control, defined as the local limitation of rat abundance, is now routinely performed on many of the world's islands as an alternative management tool. However, a synthesis of the motivations, techniques, costs, and outcomes of such rat‐control projects is lacking. We reviewed the literature, searched relevant websites, and conducted a survey via a questionnaire to synthesize the available information on rat‐control projects in island natural areas worldwide to improve rat management and native species conservation. Data were collected from 136 projects conducted over the last 40 years; most were located in Australasia (46%) and the tropical Pacific (25%) in forest ecosystems (65%) and coastal strands (22%). Most of the projects targeted Rattus rattus and most (82%) were aimed at protecting birds and endangered ecosystems. Poisoning (35%) and a combination of trapping and poisoning (42%) were the most common methods. Poisoning allows for treatment of larger areas, and poison projects generally last longer than trapping projects. Second‐generation anticoagulants (mainly brodifacoum and bromadiolone) were used most often. The median annual cost for rat‐control projects was US$17,262 or US$227/ha. Median project duration was 4 years. For 58% of the projects, rat population reduction was reported, and 51% of projects showed evidence of positive effects on biodiversity. Our data were from few countries, revealing the need to expand rat‐control distribution especially in some biodiversity hotspots. Improvement in control methods is needed as is regular monitoring to assess short‐ and long‐term effectiveness of rat‐control.     

Hurricane Harvey and Greater Houston households: comparing pre-event preparedness with post-event health effects,event exposures,and recovery

Most disaster studies rely on convenience sampling and ‘after-only’ designs to assess impacts. This paper, focusing on Hurricane Harvey (2017) and leveraging a pre-/post-event sample of Greater Houston households (n=71) in the United States, establishes baselines for disaster preparedness and home structure flood hazard mitigation, explores household-level ramifications, and examines how preparedness and mitigation relate to health effects, event exposures, and recovery. Between 70 and 80 per cent of participants instituted preparedness measures. Mitigation actions varied: six per cent had interior drainage systems and 83 per cent had elevated indoor heating/cooling components. Sixty per cent reported home damage. One-half highlighted allergies and two-thirds indicated some level of post-traumatic stress (PTS). Three-quarters worried about family members/friends. The results of generalised linear models revealed that greater pre- event mitigation was associated with fewer physical health problems and adverse experiences, lower PTS, and faster recovery. The study design exposed the broad benefits of home structure flood hazard mitigation for households after Harvey.     

Benchmarking Optical/Thermal Satellite Imagery for Estimating Evapotranspiration and Soil Moisture in Decision Support Tools

Generally, one expects evapotranspiration (ET) maps derived from optical/thermal Landsat and MODIS satellite imagery to improve decision support tools and lead to superior decisions regarding water resources management. However, there is lack of supportive evidence to accept or reject this expectation. We “benchmark” three existing hydrologic decision support tools with the following benchmarks: annual ET for the ET Toolbox developed by the United States Bureau of Reclamation, predicted rainfall‐runoff hydrographs for the Gridded Surface/Subsurface Hydrologic Analysis model developed by the U.S. Army Corps of Engineers, and the average annual groundwater recharge for the Distributed Parameter Watershed Model used by Daniel B. Stephens & Associates. The conclusion of this benchmark study is that the use of NASA/USGS optical/thermal satellite imagery can considerably improve hydrologic decision support tools compared to their traditional implementations. The benefits of improved decision making, resulting from more accurate results of hydrologic support systems using optical/thermal satellite imagery, should substantially exceed the costs for acquiring such imagery and implementing the remote sensing algorithms. In fact, the value of reduced error in estimating average annual groundwater recharge in the San Gabriel Mountains, California alone, in terms of value of water, may be as large as $1 billion, more than sufficient to pay for one new Landsat satellite.