Determination of trace metal concentrations in soil profiles of municipal waste dumps in Nigeria

The concentrations of trace metals (Cd, Pb, Cu, Cr, Fe, Ni, Zn and Co) were studied in soil profiles of eight municipal waste dump sites in Warri metropolis. The results indicate that concentrations of trace metals varied widely among the different dumpsites and decreased with depths in a studied soil profile. The accumulation pattern for the heavy metals in the soil profiles follows the order: Fe > Pb > Mn > Co > Cr > Zn > Ni > Cu > Cd. The concentrations of metals found in these sites was below the Canadian remediation criteria for land for agricultural, residential and commercial/industrial purposes except for the cadmium levels in some sites that exceeded criterion values for agricultural and residential. In such sites, remedial actions are required before any form of chosen development can take place. The levels of heavy metals found in these dump sites were higher than that of the control site. The examined metals showed no significant correlation with soil physicochemical properties at the surface horizon, which is suggestive evidence that these metals arise from anthropogenic input.     

Oxygen Stratification in Industrial Boiler Stacks

The DSS/2 software system was used to numerically simulate oxygen stratification effects in a typical industrial boiler stack. The model developed for the simulation involves turbulent mass transfer in a tube with a constant, high mass flux from the walls of the tube. The concentration profile is considered to be developing, but the velocity profile is assumed to be fully developed. The model is for a gaseous system at constant temperature and pressure; the transport properties are shown to be constant. The universal velocity profile for turbulent flow and von Karman’s expressions for the turbulent eddy diffusivity are incorporated in the model. An expression for a wall concentration profile corresponding to conditions of high mass flux at the wall is developed. The model is then expressed as a system of partial differential equations which are solved using the numerical method of lines together with the DSS/2 numerical integration system. The resulting concentration profiles are presented for various flux rates which might be encountered in a typical stack. These profiles indicate that a potential for oxygen stratification in stacks does exist; they also suggest that careful placement of the oxygen cell probe can help minimize such errors.     

Automated riverine landscape characterization: GIS-based tools for watershed-scale research, assessment, and management

River systems consist of hydrogeomorphic patches (HPs) that emerge at multiple spatiotemporal scales. Functional process zones (FPZs) are HPs that exist at the river valley scale and are important strata for framing whole-watershed research questions and management plans. Hierarchical classification procedures aid in HP identification by grouping sections of river based on their hydrogeomorphic character; however, collecting data required for such procedures with field-based methods is often impractical. We developed a set of GIS-based tools that facilitate rapid, low cost riverine landscape characterization and FPZ classification. Our tools, termed RESonate, consist of a custom toolbox designed for ESRI ArcGIS®. RESonate automatically extracts 13 hydrogeomorphic variables from readily available geospatial datasets and datasets derived from modeling procedures. An advanced 2D flood model, FLDPLN, designed for MATLAB® is used to determine valley morphology by systematically flooding river networks. When used in conjunction with other modeling procedures, RESonate and FLDPLN can assess the character of large river networks quickly and at very low costs. Here we describe tool and model functions in addition to their benefits, limitations, and applications.     

Liquid household hazardous wastes in the United States: Identification,disposal, and management plan

Present methods of disposal of today's hazardous household chemicals in the United States are frequently not acceptable because of pathways to groundwater, surface water, and the atmosphere. This report identifies potentially hazardous liquid waste in the household, notes current disposal practices, and recommends an improved management plan that utilizes consumer education, manufacturer cooperation, and governmental intervention. Laws requiring uniform disposal labeling on packaging are critical. Local, county, and state governments must be encouraged to coordinate the necessary infrastructure. Managing hazardous household wastes now will mitigate potential disposal problems.     

PCDD/F formation from oxy-PAH precursors in waste incinerator flyash

The yield of PCDD/F in relation to the presence of oxygenated PAH in model waste incinerator flyash has been investigated in a fixed bed laboratory scale reactor. Experiments were undertaken by thermal treatment of the model flyash at 250 and 350 °C under a simulated flue gas stream for 2 h. After reaction, the PCDD/F content of the reacted flyash and the PCDD/F released into the exhaust gas, and subsequently trapped by XAD-II resin in a down-stream condensation system were analyzed. The PAHs investigated were, dibenzofuran and benzo[b]naphtho[2,3-d]furan and were spiked onto the model flyash as reactant precursors for PCDD/F formation. The results showed significant formation of furans from both of the PAH investigated, however except from some highly chlorinated dioxin congeners, the formation of dioxins was not so common. Benzonaphthofuran was significantly more reactive than dibenzofuran in PCDD/F formation, in spite of the fact that dibenzofuran is structurally more similar to that of PCDD/F. Thus, there was no clear attribution between the chemical structure of PAH used and the formation of PCDD/F. There were considerable differences between the yields of PCDD/F congeners in the gaseous species and those in the reacted flyash under the same operational conditions. The concentration of PCDD/Fs was reduced at the higher reaction temperature of 350 °C; however, the higher temperature resulted in the majority of the PCDD/F formed on the flyash being released into the gas phase.     

Removal potential of toxic 2378-substituted PCDD/F from incinerator flue gases by waste-derived activated carbons

The application of activated carbons has become a commonly used emission control protocol for the removal or adsorption of persistent organic pollutants from the flue gas streams of waste incinerators. In this study, the 2378-substituted PCDD/F removal efficiency of three types of activated carbons derived from the pyrolysis of refuse derived fuel, textile waste and scrap tyre was investigated and compared with that of a commercial carbon. Experiments were carried out in a laboratory scale fixed-bed reactor under a simulated flue gas at 275 °C with a reaction period of four days. The PCDD/F in the solid matrices and exhaust gas, were analyzed using gas chromatography coupled with a triple quadrupole mass spectrometer. In the absence of activated carbon adsorbent, there was a significant increase in the concentration of toxic PCDD/F produced in the reacted flyash, reaching up to 6.6 times higher than in the raw flyash. In addition, there was a substantial release of PCDD/F into the gas phase, which was found in the flue gas trapping system. By application of the different commercial, refuse derived fuel, textile and tyre activated carbons the total PCDD/F toxic equivalent removal efficiencies in the exhaust gas stream were 58%, 57%, 64% and 52%, respectively. In general, the removal of the PCDDs was much higher with an average of 85% compared to PCDFs at 41%. Analysis of the reacted activated carbons showed that there was some formation of PCDD/F, for instance, a total of 60.6 μg I-TEQ kg⁻¹ toxic PCDD/F was formed in the refuse derived fuel activated carbon compared to 34 μg I-TEQ kg⁻¹ in the commercial activated carbon. The activated carbons derived from the pyrolysis of waste, therefore, showed good potential as a control material for PCDD/F emissions in waste incinerator flue gases.     

Interactive effects of metal contamination and pathogenic organisms on the introduced marine bivalve Ruditapes philippinarum in European populations

In natural environment, marine organisms are concomitantly exposed to pollutants and multiple disease agents resulting in detrimental interactions. The present study evaluated interactive effects of metal contamination (cadmium) and pathogenic organisms (trematode parasites Himasthla elongata and pathogenic bacteria Vibrio tapetis) singularly and in combination on the bivalve Ruditapes philippinarum, an introduced species to Europe, under laboratory controlled conditions. After 7 days, metal bioaccumulation and pathogen load were analyzed as well as metallothionein (MT) response and hemocyte concentrations and activities. Results showed that infection by opportunistic pathogens affects metal accumulation, leading to maximal Cd accumulation in co-infected clams. Among stressors only V. tapetis induced significant effects on immune parameters whereas a particular interaction “trematode-bacteria” was shown on MT responses. Despite low trematode infection in agreement with the resistant status of R. philippinarum to these macroparasites, significant interaction with bacteria and metal occurred. Such results highlight the necessity of taking pathogens into account in ecotoxicological studies.     

Depositional behaviour of C-org, N, P and K in the surface sediments of two shallow water bodies in a tropical coast, India

The present paper deals with the distribution of sediment and sediment-bound nutrients in two important coastal lagoons of southern Kerala such as the Ashtamudi Estuarine Lagoon in the Kollam district and the Kadinamkulam Lagoon in the Thiruvananthapuram district. Among the two lagoons, the former is coast perpendicular, and the latter is coast parallel. An analysis of the textural characteristics reveals that, in both lagoons, the estuarine mouth and areas close to it are dominated by sand and sand-rich sediment species, indicating a high-energy depositional regime prevailing the region. On the other hand, the silt and clay dominant arms are almost sheltered and enjoy a low-energy depositional environment. The nutrient and organic carbon contents in the sheltered areas are significantly higher than the most dynamic high-energy estuarine mouth regions. This peculiar behaviour of these coastal water bodies has to be given adequate importance while laying down strategies for the conservation and management of these fragile aquatic systems in the south-western coast of India in particular and tropical coasts of the world in general.