全文获取类型
收费全文 | 2183篇 |
免费 | 129篇 |
国内免费 | 756篇 |
专业分类
安全科学 | 176篇 |
废物处理 | 138篇 |
环保管理 | 202篇 |
综合类 | 1231篇 |
基础理论 | 345篇 |
污染及防治 | 717篇 |
评价与监测 | 127篇 |
社会与环境 | 69篇 |
灾害及防治 | 63篇 |
出版年
2023年 | 36篇 |
2022年 | 137篇 |
2021年 | 144篇 |
2020年 | 81篇 |
2019年 | 62篇 |
2018年 | 87篇 |
2017年 | 130篇 |
2016年 | 102篇 |
2015年 | 139篇 |
2014年 | 184篇 |
2013年 | 247篇 |
2012年 | 202篇 |
2011年 | 192篇 |
2010年 | 143篇 |
2009年 | 141篇 |
2008年 | 165篇 |
2007年 | 125篇 |
2006年 | 149篇 |
2005年 | 100篇 |
2004年 | 60篇 |
2003年 | 48篇 |
2002年 | 44篇 |
2001年 | 37篇 |
2000年 | 49篇 |
1999年 | 52篇 |
1998年 | 49篇 |
1997年 | 40篇 |
1996年 | 35篇 |
1995年 | 22篇 |
1994年 | 18篇 |
1993年 | 11篇 |
1992年 | 8篇 |
1991年 | 7篇 |
1990年 | 4篇 |
1989年 | 2篇 |
1988年 | 3篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1985年 | 1篇 |
1984年 | 2篇 |
1983年 | 2篇 |
1982年 | 3篇 |
1981年 | 1篇 |
1972年 | 1篇 |
排序方式: 共有3068条查询结果,搜索用时 893 毫秒
1.
利用TSI公司的APS和SMPS系统,于2017年4月在江苏省环境监测中心点位连续一个月进行大气颗粒物数谱观测,结果表明,南京市春季典型月份大气颗粒物数浓度和体积浓度均值分别为1.64×104cm~(-3)和1.65×106μm~3/m~3;核模态、爱根核膜态、积聚模态和粗粒子模态数浓度占比分别为22.72%,53.52%,23.72%和0.05%,体积浓度占比分别为0.01%,1.76%,55.82%和42.41%;颗粒物数浓度平均日变化呈现双峰结构;PM_(2.5)体积浓度和质量浓度具有高度相关性;存在明显的新生粒子事件,3~10 nm颗粒物数浓度小时均值短时7 500 cm~(-3)。 相似文献
2.
为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9% ~5.4%.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3%的系统脱硫效率整体高于含湿量为5%和4%的样品,最大值达93.56%.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3%的循环脱硫灰较含湿量为5%的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5%样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高. 相似文献
3.
4.
5.
反硝化除磷菌驯化富集方式的探讨 总被引:3,自引:0,他引:3
以SBR反应器分别采用一段式和二段式培养方法对反硝化除磷菌进行了驯化富集.结果表明,一段式和二段式培养方法驯化完成后的活性污泥沉降性能均较好,污泥体积指数(SVI)分别约为60、50 mL/g,反硝化除磷菌占聚磷菌的比例达到了77%和71%.两种培养方法下反硝化除磷菌PO3-4-P去除率和脱氮率分别达到了97%和95%以上,缺氧结束时水中PO3-4-P质量浓度小于1 mg/L.驯化完成后污泥的含磷率最高达到了3.7%(质量分数).因此,采用一段式或二段式驯化方法均能实现反硝化除磷菌的有效富集. 相似文献
6.
Park SS Kim YJ Cho SY Kim SJ 《Journal of the Air & Waste Management Association (1995)》2007,57(4):434-443
Daily fine particulate matter (PM2.5) samples were collected at Gwangju, Korea, during the Aerosol Characterization Experiments (ACE)-Asia Project to determine the chemical properties of PM2.5 originating from local pollution and Asian dust (AD) storms. During the study period, two significant events occurred on April 10-13 and 24-25, 2001, and a minor event occurred on April 19, 2001. Based on air mass transport pathways identified by back-trajectory calculation, the PM2.5 dataset was classified into three types of aerosol populations: local pollution and two AD aerosol types. The two AD types were transported along different pathways. One originated from Gobi desert area in Mongolia, passing through Hunshandake desert in Northern Inner Mongolia, urban and polluted regions of China (AD1), and the other originated in sandy deserts located in the Northeast Inner Mongolia Plateau and then flowed southward through the Korean peninsula (AD2). During the AD2 event, a smoke plume that originated in North Korea was transported to our study site. Mass balance closures show that crustal materials were the most significant species during both AD events, contributing -48% to the PM2.5 mass; sulfate aerosols (19.1%) and organic matter (OM; 24.6%) were the second greatest contributors during the AD1 and AD2 periods, respectively, indicating that aerosol properties were dependent on the transport pathway. The sulfate concentration constituted only 6.4% (4.5 microg/m3) of the AD2 PM2.5 mass. OM was the major chemical species in the local pollution-dominated PM2.5 aerosols, accounting for 28.7% of the measured PM2.5 mass, followed by sulfate (21.4%), nitrate (15%), ammonium (12.8%), elemental carbon (8.9%), and crustal material (6.5%). Together with substantial enhancement of the crustal elements (Mg, Al, K, Ca, Sc, Ti, Mn, Fe, Sr, Zr, Ba, and Ce), higher concentrations of pollution elements (S, V, Ni, Zn, As, Cd, and Pb) were observed during AD1 and AD2 than during the local pollution period, indicating that, in addition to crustal material, the AD dust storms also had a significant influence on anthropogenic elements. 相似文献
7.
8.
When combined in the lining and covering of waste-containment facilities, soil and geosynthetic components protect the environment by acting as a hydraulic barrier. Equipment loading may significantly increase the tensile stress induced in geosynthetic components, leading to a potential stability problem. Large equipment loadings may also result in a localized circular slip surface during construction operations. New analytical method based on discrete element modelling is proposed for estimating the distribution of tensile force developed in the individual geosynthetic components of the lining system and for evaluating the safety factor of slope failure due to equipment loading. The analytical results of an example are presented to demonstrate the applicability of the analytical method for the lining system of a waste landfill. The analyses of the example show that equipment loading provide a substantial increase in the tensile forces of the geosynthetic components of a lining system and that the possibility of shallow failure due to equipment loading increases as the slope becomes steeper. This method is a useful tool for analysing the lining system of waste landfills with complex lining components. 相似文献
9.
Zheng Lei Li Dewen Song Shuzheng Wang Hongtu Sui Jinjun 《Environment, Development and Sustainability》2022,24(3):3110-3125
Environment, Development and Sustainability - In order to reveal the distribution and migration law of downwind and upwind coal cutting, total dust (TD) and respirable dust (RD) concentration... 相似文献
10.
Dong Junran Wu Desheng Song Jingxiu Lu Jie 《Environment, Development and Sustainability》2022,24(4):5451-5472
Environment, Development and Sustainability - The ecological compensation mechanism is regarded as the direction for the future management of the ecological environment of the river basin, which... 相似文献