Laboratory and Field Assessment of Arsenic Testing Field Kits in Bangladesh and West Bengal, India

High concentrations of arsenic in ground waters in West Bengal and Bangladeshhave become a major cause for concern in recent years. Given the enormity and the severity of the problemof arsenic poisoning, a task of evaluating the commercially available arsenic detection field kits for their capabilities was undertaken. In the light of the findings, generic specificationswere recommended which could form the basis forindigenous manufacture of these kits in the arsenic affected countries. This article presents the results of the laboratory and fieldevaluation conducted in Bangladesh and West Bengalof five arsenic testing field kits. The salient features of the kits, their merits and limitationshave been brought out. Based on the criteria of kitdesign, quality of chemicals used, colourcomparator charts, detection range, time required for analysis, cost etc., a comparative ranking ofthe kits has been made to facilitate the choice of the kit to meet specific requirements.     

A ten channel fibre-optic device for distributed sensing of underground hydrocarbon leakage

With millions of fuel storage tanks and oil pipelines installed around the world, there is inevitably frequent leakage of potentially hazardous hydrocarbons. As many of these installations are below ground, it can often be many years before the extent of the leak is discovered. We have previously reported the development of a sensor for the detection of such subterranean leaks, using infrared reflectometry to interrogate a hydrocarbon sensitive membrane. However, a single sensor cannot provide any information about the flow rate or direction of the leak. This paper describes the extension of the technology to a multi-channel distributed sensing system, using optical fibres capable of distributing the sensors over large subterranean areas. Results are reported from the evaluation of the device, which consisted of monitoring the movement of different hydrocarbons (gasoline, diesel and insulating oil) through a vertical sand-filled vessel.     

A novel sensor for monitoring leakage of petroleum and other liquid hydrocarbons into soil environments

This paper describes the use of a potentially implantable infrared reflectometer for the qualitative detection of petroleum and a number of other hydrocarbon solvents. A rugged, low-power, re-useable sensor was evaluated in the laboratory for its ability to detect petrol in soil. A hydrophobic fluoropolymer was used as the sensing surface due to its high selectivity for petroleum hydrocarbons. The photocurrent reflected by this surface from a near IR source was measured to test for petroleum saturation within the membrane, which in turn was an indicator of petroleum in the surrounding soil. The simplicity in the sensor design enabled a stable, low cost detection method for petroleum and other hydrocarbons, ideal for use in sub-surface applications.     

Emissions of VOCs at Urban Petrol Retail Distribution Centres in India (Delhi and Mumbai)

Air pollution has assumed gigantic proportion killing almost half a million Asians every year. Urban pollution mainly comprises of emissions from buses, trucks, motorcycle other forms of motorized transport and its supporting activities. As Asia's cities continue to expand the number of vehicles have risen resulting in greater pollution. Fugitive emissions from retail distribution center in urban area constitute a major source. Petrol vapours escape during refueling adding pollutants like benzene, toluene, ethylbenzene and xylene to ambient air. This paper discusses a study on fugitive emissions of Volatile Organic Compounds (VOC) at some refueling station in two metropolitan cities of India, i.e., Mumbai and Delhi. Concentration of VOCs in ambient air at petrol retail distribution center is estimated by using TO-17 method. Concentration of benzene in ambient air in Delhi clearly shows the effect of intervention in use of petroleum and diesel fuel and shift to CNG. Chemical Mass Balance (CMB) model is used to estimate source contributions. At Delhi besides diesel combustion engines, refueling emissions are also major sources. At Mumbai evaporative emissions are found to contribute maximum to Total VOC (TVOC) concentration in ambient air.     

Electro-oxidation of the dye azure B: kinetics,mechanism, and by-products

In this work, the electrochemical degradation of the dye azure B in aqueous solutions was studied by electrochemical advanced oxidation processes (EAOPs), electro-Fenton, and anodic oxidation processes, using Pt/carbon-felt and boron-doped diamond (BDD)/carbon-felt cells with H₂O₂ electrogeneration. The higher oxidation power of the electro-Fenton (EF) process using BDD anode was demonstrated. The oxidative degradation of azure B by the electrochemically generated hydroxyl radicals (^?OH) follows a pseudo-first-order kinetics. The apparent rate constants of the oxidation of azure B by ^?OH were measured according to pseudo-first-order kinetic model. The absolute rate constant of azure B hydroxylation reaction was determined by competition kinetics method and found to be 1.19?×?10⁹ M^?1 s^?1. It was found that the electrochemical degradation of the dye leads to the formation of aromatic by-products which are then oxidized to aliphatic carboxylic acids before their almost mineralization to CO₂ and inorganic ions (sulfate, nitrate, and ammonium). The evolution of the TOC removal and time course of short-chain carboxylic acids during treatment were also investigated.     

Chemical characterization and health risk assessment of soil and airborne particulates metals and metalloids in populated semiarid region,Agra, India

Rapid industrialization and urbanization have contaminated air and soil by heavy metals and metalloids from biogenic, geogenic and anthropogenic sources in many areas of the world, either directly or indirectly. A case study was conducted in three different microenvironments, i.e., residential sites, official sites and official sites; for each sites, we choose two different locations to examine the elemental concentration in fine particulate matter and soil and health risk assessment. The concentration values of heavy metals and metalloid in the air and soil in the Agra region were measured using inductively coupled plasma-atomic emission spectrophotometry. The exposure factor and health risk assessment for carcinogenic and non-carcinogenic effects due to heavy metals and metalloid contaminants have been calculated for both children and adults by following the methodology prescribed by USEPA. For the elements As, Cr, Cd, Ni and Pb selected for the carcinogenic health risk assessment, the calculated results lie above the threshold ranges. We observed the lifetime exposure to heavy metals through mainly three pathways, ingestion, inhalation and dermal contact of soil and air from that particular area. Therefore, the overall hazard quotient (HQ) values for children are more than that of adults. The assessment of health risk signifies that there were mainly three exposure pathways for people: ingested, dermal contact and inhalation. The major exposure pathway of heavy metals to both children and adults is ingestion. The values of HQ are higher than the safe level (=1), indicating a high risk exists in present condition. Meanwhile, HQs value for children is higher than that for adults, indicating that children have higher potential health risk than adults in this region.

     

Bioleaching of copper from large printed circuit boards for synthesis of organic-inorganic hybrid

Environmental Science and Pollution Research - The present study described a process for copper (Cu) bioleaching from waste printed circuit boards (PCBs). The 45 (±?0.18) mg/g Cu was...     

A comprehensive review on the carcinogenic potential of bisphenol A: clues and evidence

Environmental Science and Pollution Research - Bisphenol A [BPA; (CH3)2C(C6H4OH)2] is a synthetic chemical used as a precursor material for the manufacturing of plastics and resins. It gained...     

Evidence of new particle formation during post monsoon season over a high-altitude site of the Western Ghats,India

The formation of ultrafine particles, their growth, and associated characteristic features has been studied during new particle formation events over a high-altitude station of the Western Ghats during the 2014 post-monsoon season. Most of the events were observed during noon time where particle bursts in the nucleation-mode size range from 5 to 25 nm followed by sustained growth in size. This phenomenon persists for ～4–8 h with a growth rate of 1–2 nm h^–1. Peak concentrations of nucleation-mode particles during the event generally vary from 2300 to 5000 cm^–3. The mean growth rate is 1.4 ± 0.42 nm h^–1, particle formation rate is 1.14 ± 0.22 cm^–3 s^–1, coagulation sink is 0.35 ± 0.22 cm^–3 s^–1, and condensational sink is 15.4 ± 2.6?×?10^–3 s^–1. All these values are comparable with earlier results from Indian region. Comparison of size-segregated particle number concentration during days of new particle formation events and those without new particle formation were carried out showing a distinct variation in nucleation and Aitken mode with least variability associated with the accumulation mode.     

Detecting diclofenac in livestock carcasses in India with an ELISA: a tool to prevent widespread vulture poisoning

Diclofenac, a non-steroidal anti-inflammatory drug (NSAID), has caused catastrophic vulture declines across the Indian sub-continent. Here, an indirect ELISA is used to detect and quantify diclofenac in 1251 liver samples from livestock carcasses collected across India between August 2007 and June 2008, one to two years after a ban on diclofenac manufacture and distribution for veterinary use was implemented. The ELISAs applicability was authenticated with independent data obtained using LC-ESI/MS. Of 1251 samples, 1150 (91.9%) were negative for diclofenac using both methods, and 60 (4.8%) were positive at 10-4348 and 10-4441 μg kg(-1) when analysed by ELISA and LC-ESI/MS, respectively. The residue level relationship in the 60 positive samples was highly significant (p < 0.001, r(2) = 0.644). Data suggest that this immunological assay could be used not only for cost effective sample screening, but also for residue level semi-quantification.