Density and Viscosity Measurements of Natural Solutions

Utilizing sophisticated equipment, densimetric and viscosimetric measurements were carried out on samples of ground-waters of Apulia.

Experimental data, utilized to check if simple equations can evaluate the density and the viscosity of multicomponent solutions, confirm the validity of the hypothesis.     

Alkylphenol polyethoxylate removal in a pilot-scale reed bed and phenotypic characterization of the aerobic heterotrophic community.

The removal of the non-ionic surfactant Triton X-100, dosed at 30 and 300 mg/L in a pilot-scale subsurface horizontal flow reed bed, and the aerobic heterotrophic cultivable community associated with the roots and with the substrate gravel in both absence and presence of Triton X-100 were investigated. t-Octylphenol (OP) and its mono-, di- and tri-ethoxyl derivatives, among others, were found in the outlet. A mass balance allowed us to calculate that approximately 40% of the Triton X-100 metabolites OP and octylphenol polyethoxylate derivatives flowed out of the reed bed during the dosage and postdosage experiments. More aerobic heterotrophic microorganisms adhered to the roots than to the gravel. The appearance of new strains (Aeromonas, Flavobacterium, and Aquaspirillum) and the increased presence of others (Pseudomonas) during the dosage of Triton may be linked to the capacity of these bacteria to adapt to the presence of the surfactant or to use it as a nourishment.     

Mercury Balance on a Large Pulverized Coal-Fired Furnace

This paper presents results of a survey of mercury concentrations in coal, ash, water, fly ash, and flue gas discharges from a 5.5 × 10⁶ Ib/hr steam generator serving a 775 MW (net) turbine-generator set. Representative composite or grab samples were obtained for inlet coal and outlet ash and water. Stack samples were obtained for fly ash and mercury vapor emissions while the unit was operated at 660 MW (net) (85% of full load). Samples were analyzed by anodic stripping voltammetry, plasma emission spectroscopy, and neutron activation analysis to determine mercury concentration entering the furnace in the coal and leaving the furnace in the flue gas, fly ash, bottom and hopper ash, and water. Method inter-comparisons are discussed. A material balance for mercury has been calculated from fuel, ash, and stack gas flow rates. About 90% of the mercury in the coal is released and appears as vapor discharged in the stack gas while 10% remains in the residual ash. For a 700 MW (net) unit, about 5 lb/day of mercury vapor is released to the atmosphere.     

Analysis of indoor gaseous formic and acetic acid, using radial diffusive samplers

A diffusive sampling method for the determination of gaseous acetic and formic acids, using a radial symmetry diffusive sampler, has been optimised for a 7-day exposure time in this study. Sampling rate determinations were performed on data obtained from a dynamic exposure chamber, simulating the indoor conditions of an empty, closed, room, at room temperature and minimal wind speed. Analysis has been performed by means of ion chromatography. The sampling rates for formic acid concentrations of 128 microg m(-3) and 1248 microg m(-3) were determined to be 91.2 +/- 3.9 ml min(-1) and 111.6 +/- 2.8 ml min(-1), respectively. The acetic acid sampling rate was independent of the concentration in the range 160 microg m(-3)-1564 microg m(-3), and amounted to 97.3 +/- 3.1 ml min(-1). Experimentally determined sampling rates showed deviations of 3% for acetic acid, and 3-21% for formic acid, in relation to theoretically derived values. The blank values were as low as 1.69 +/- 0.07 microg for formic acid and 1.21 +/- 0.14 microg for acetic acid, and detection limits lower than 0.5 microg m(-3) could be achieved, which is an improvement of 98-99% compared to previously validated diffusive sampling methods. This study describes the first step of an extended validation program in which the applicability of these types of samplers for the measurement of organic acids will be validated and optimised for the environmental conditions typical for museum showcases.