Degradation of the herbicide dichlobenil and its metabolite BAM in soils and subsurface sediments

The worldwide used herbicide dichlobenil (2,6-dichlorobenzonitrile) has resulted in widespread presence of its metabolite 2,6-dichlorobenzamide (BAM) in surface water and groundwater. To evaluate the potential for natural attenuation of this BAM pollution in groundwater, we studied the degradation of BAM and dichlobenil in 16 samples of clayey till, unconsolidated sand and limestone, including sediments from both oxidized and reduced conditions. The degradation of dichlobenil occurred primarily in the upper few meters below surface, although dichlobenil was strongly sorbed to these sediments. However, the degradation of dichlobenil to BAM could not be correlated to either sorption, water chemistry, composition of soils or sediments. Degradation of dichlobenil to BAM was limited (<2% degraded) in the deeper unsaturated zones, and no degradation was observed in aquifer sediments. This illustrates, that dichlobenil transported to aquifers does not contribute to the BAM-contamination in aquifers. A small, but significant degradation of BAM was observed in the upper part of the unsaturated zones in sandy sediments, but no degradation was observed in the clayey till sediment or in the deeper unsaturated zones. The insignificant degradation of BAM in aquifer systems shows that BAM pollution detected in aquifers will appear for a long time; and consequently the potential for natural attenuation of BAM in aquifer systems is limited.     

Coupled abiotic-biotic mineralization of 2,4,6-trinitrotoluene (TNT)

Munitions wastes such as TNT are widespread contaminants in soils and ground waters. We investigated a coupled abiotic-biotic treatment scheme for remediation of aqueous solutions of TNT. Mineralization of aqueous TNT (0.22 mM) was initially optimized with minimum reactant use (Fe3+ and H2O2) in light-assisted and dark, modified Fenton reactions at acidic and neutral pH. Complete TNT degradation occurred under all reaction conditions within 24 h. Using the optimum reactant concentrations, coupled abiotic-biotic reactions showed an increase in TNT mineralization, from 47 to 80%, after biomass addition to the acidic, dark Fenton-like reaction. Comparable increases of TNT mineralization were observed under neutral pH with similar reaction conditions. In light-assisted Fenton-like reactions at neutral pH, no increase in cumulative TNT mineralization (66%) was seen in coupled abiotic-biotic reactions. Abiotic photo-Fenton-like reactions alone, at acidic pH, produced complete TNT mineralization and required no biotic assistance. While light-enhanced Fenton reactions alone can provide high levels of TNT mineralization, the dark abiotic-biotic reaction scheme has perhaps a wider use due to a similar extent of TNT mineralization in the absence of light, leading to possible applications in soil slurry and in situ processes in the subsurface.     

Chemical and biological characterization of non-extractable sulfonamide residues in soil

For sulfonamides, the formation of non-extractable residues has been identified by laboratory testing as the most relevant concentration determining process in manured soil. Therefore, the present study has been focused on the chemical and biological characterization of non-extractable residues of ¹⁴C-labeled sulfadiazine or sulfamethoxazole. In laboratory batch experiments, the test substances were spiked via standard solution or test slurry to microbially active soil samples. After incubation periods of up to 102 d, a sequential extraction technique was applied. Despite the exhaustive extraction procedure, sulfadiazine residues mainly remained non-extractable, indicating the high affinity to the soil matrix. The remobilization of non-extractable ¹⁴C-sulfadiazine residues was monitored in the activated sludge test and the Brassica rapa test. Only small amounts (<3%) were transferred into the extractable fractions and 0.1% was taken up by the plants. In the Lumbricus terrestris test A, the release of non-extractable ¹⁴C-sulfamethoxazole residues by the burrowing activity of the earthworms was investigated. The residues mainly remained non-extractable (96%). The L. terrestris test B was designed to study the immobilization of ¹⁴C-sulfamethoxazole in soil directly after the test slurry application. The mean uptake by earthworms was 1%. Extractable and non-extractable residues amounted to 5% and 93%, respectively. Consequently, the results of all tests confirmed the high affinity of the non-extractable sulfonamide residues to the soil matrix.     

Controls on atrazine leaching through a soil-unsaturated fractured limestone sequence at Brévilles, France

The objective of this study was to identify the main controls on atrazine leaching through luvisols and calcisols overlying fissured limestone using the dual-permeability model MACRO. The model parameterisation was based on a combination of direct measurements (e.g. hydraulic properties, adsorption and degradation), literature data and calibration against bromide leaching experiments in field plots. A Monte Carlo sensitivity analysis was carried out for a typical application pattern, considering two different depths of unsaturated limestone (15 and 30 m). MACRO calibrations to the field experiments demonstrated the occurrence of strong macropore flow in the luvisol, while transport in the calcisol could be described by the advection-dispersion equation. MACRO simulations of tritium and atrazine leaching qualitatively matched tritium concentration profiles measured in the limestone and atrazine concentrations measured in piezometers and in aquifer discharge via a spring. The sensitivity analysis suggested that the thickness of the limestone, as well as the transport properties and processes occurring in the unsaturated rock (e.g. matrix vs. fissure flow) will have little significant long-term effect on atrazine leaching, mainly because degradation is very slow in the limestone. No mineralization of atrazine was detected in one-year incubations and a mean half-life of 10 years was assumed in the simulations. Instead, processes occurring in the soil exerted the main control on predicted atrazine leaching, especially variations in the degradation rate and the strength of sorption and macropore flow. However, fissure flow in unsaturated rock is expected to exert a much more significant control on groundwater contamination for compounds that degrade more readily in the deep vadose zone.     

A genetic component to size in queens of the ant,<Emphasis Type="Italic"> Formica truncorum</Emphasis>

The genetic basis of morphological traits in social insects remains largely unexplored. This is even true for individual body size, a key life-history trait. In the social insects, the size of reproductive individuals affects dispersal decisions, so that small size in queens is often associated with reduced dispersal, and large size with long-range dispersal and independent colony founding. Worker size is connected to division of labour when workers specialize in certain tasks according to their size. In many species, variation in worker size has been shown to increase colony performance. In this study, we present the first evidence of an additive genetic component to queen size in ants, using maternal half sib analysis. We also compared intra-colony size variation in colonies with high (queen doubly mated) versus low (queen singly mated) genetic variability. We found a high and significant heritability (h²=0.51) for queen size in one of the two study years, but not in the other. Size variation among queens was greater in colonies headed by a doubly mated queen in one of the study years, but not in the other. This indicates that genetic factors can influence queen size, but that environmental factors may override these under some circumstances. The heritability for worker size was low (h²=0.09) and non-significant. Increased genetic diversity did not increase worker size variation in the colonies. Worker size appeared largely environmentally determined, potentially allowing colonies to adjust worker size ratios to current conditions.Communicated by J. Heinze     

Genetic population structure and sociogenetic organisation in Formica truncorum (Hymenoptera; Formicidae)

Summary The genetic population structure and the sociogenetic organization of the red wood ant Formica truncorum were compared in two populations with monogynous colonies and two populations with polygynous colonies. The genetic population structure was analysed by measuring allele frequency differences among local subsets of the main study populations. The analysis of sociogenetic organisation included estimates of nestmate queen and nestmate worker relatedness, effective number of queens, effective number of matings per queen, relatedness among male mates of nestmate queens and relatedness between queens and their male mates. The monogynous populations showed no differentiation between subpopulations, whereas there were significant allele frequency differences among the subpopulations in the polygynous population. Workers, queens and males showed the same genetical population structure. The relatedness among nestmate workers and among nestmate queens was identical in the polygynous societies. In three of the four populations there was a significant heterozygote excess among queens. The queens were related to their male mates in the polygynous population analysed, but not in the monogynous ones. The data suggest limited dispersal and partial intranidal mating in the populations with polygynous colonies and outbreeding in the populations having monogynous colonies. Polyandry was common in both population types; about 50% of the females had mated at least twice. The males contributed unequally to the progeny, one male fathering on average 75% of the offspring with double mating and 45–80% with three or more matings. Correspondence to: L. Sundström     

Seasonal polydomy and unicoloniality in a polygynous population of the red wood ant Formica truncorum

Ant colonies may have a single or several reproductive queens (monogyny and polygyny, respectively). In polygynous colonies, colony reproduction may occur by budding, forming multinest, polydomous colonies. In most cases, budding leads to strong genetic structuring within populations, and positive relatedness among nestmates. However, in a few cases, polydomous populations may be unicolonial, with no structuring and intra-nest relatedness approaching zero. We investigated the spatial organisation and genetic structure of a polygynous, polydomous population of Formica truncorum in Finland. F. truncorum shifts nest sites between hibernation and the reproductive season, which raises the following question: are colonies maintained as genetic entities throughout the seasons, or is the population unicolonial throughout the season? Using nest-specific marking and five microsatellite loci, we found a high degree of mixing between individuals of the population, and no evidence for a biologically significant genetic structuring. The nestmate relatedness was also indistinguishable from zero. Taken together, the results show that the population is unicolonial. In addition, we found that the population has undergone a recent bottleneck, suggesting that the entire population may have been founded by a very limited number of females. The precise causes for unicoloniality in this species remain open, but we discuss the potential influence of intra-specific competition, disintegration of recognition cues and the particular hibernation habits of this species.     

Inbreeding and caste-specific variation in immune defence in the ant <Emphasis Type="Italic">Formica exsecta</Emphasis>

Social insects are a widespread and ecologically dominant group. Reproductive division of labour among the females in the colonies is a key trait for their success, but at the same time, it creates dense aggregations of relatives which may promote the spread of disease in the colonies. Hence, the appropriate regulation of immune defence is crucial for the well-being of a colony. Inbreeding may disturb this process through reduced resistance or by impairing the colony’s ability to regulate the responses. We tested the effect of inbreeding and the within-colony differences in the encapsulation response between the two female castes of the ant Formica exsecta. New reproductive females (gynes) born in more inbred colonies, and being more inbred themselves, showed an elevated immune response whereas inbreeding had no effect on worker response. Furthermore, the immune response exhibited by gynes was lower than that of workers and was not dependent on their body size whereas the worker response increased with body size. The elevated response is likely to reflect genetic stress caused by inbreeding, which in turn may compromise colony founding and longevity. Indeed, eliciting a high immune response in itself might not be adaptive. Our results show that the regulation of the expression of immunity differs between female castes despite their similar genetic make-up.     

High-molecular weight sulfur-containing aromatics refractory to weathering as determined by Fourier transform ion cyclotron resonance mass spectrometry

Biomarkers and low-molecular weight polyaromatic compounds have been extensively studied for their fate in the environment. They are used for oil spill source identification and monitoring of weathering and degradation processes. However, in some cases, the absence or presence of very low concentration of such components restricts the access of information to spill source. Here we followed the resistance of high-molecular weight sulfur-containing aromatics to the simulated weathering condition of North Sea crude oil by ultra high-resolution Fourier transform ion cyclotron resonance mass spectrometry. The sulfur aromatics in North Sea crude having double bond equivalents (DBE) from 6 to 14 with a mass range 188-674 Da were less influenced even after 6 months artificial weathering. Moreover, the ratio of dibenzothiophenes (DBE 9)/naphthenodibenzothiophenes (DBE 10) was 1.30 and 1.36 in crude oil and 6 months weathered sample, respectively reflecting its weathering stability. It also showed some differences within other oils. Hence, this ratio can be used as a marker of the studied crude and accordingly may be applied for spilled oil source identification in such instances where the light components have already been lost due to environmental influences.