钯离子液相催化氧化低浓度磷化氢

采用Pd^2＋液相催化氧化低浓度PH3，考察了Pd^2＋浓度、O2体积分数、PH3质量浓度、混合气流量、反应温度等因素对Pd^2＋吸收液去除低浓度PH3效果的影响。实验结果表明，采用10mL Pd^2＋浓度为0．112mol／L的水溶液作为吸收液净化含低浓度PH3的混合气，在反应温度22℃、O2体积分数5％、PH3质量浓度850mg／m^3、混合气流量190mL／min的条件下，印min之内PH3去除率保持在90％以上。Pd^2＋浓度越高、O2体积分数越大、反应温度越高，PH3去除率越高；混合气流量越大，PH3去除率越低；反应温度越低、O2体积分数越大，PH3去除率的下降速率越小。     

Tourism: economic development without increasing CO2 emissions in Pakistan

Environment, Development and Sustainability - Globally, the national and cultural resources of a country are major sources of attraction for tourism. Pakistan is gifted with abundant natural and...     

河岸过滤中氨氮的削减及其浓度对细菌与氨氧化微生物的影响

通过小试滤柱模拟河岸过滤,结合荧光定量PCR和高通量测序等手段研究了河岸过滤对氨氮的削减效能和进水氨氮浓度对细菌与氨氧化微生物的影响.结果表明,低浓度（0.2 mg·L^-1）氨氮未被削减,较高浓度（1.0 mg·L^-1和2.0 mg·L^-1）氨氮的削减率可达70%.进水处细菌丰度随氨氮浓度升高而增加,细菌群落组成随氨氮浓度升高发生规律性变化.出水处氨氧化古菌（Ammonia oxidizing archaea,AOA）丰度与氨氮浓度呈负相关,氨氧化细菌（Ammonia oxidizing bacteria,AOB）丰度与氨氮浓度无显著相关关系;进水处AOA-α多样性与氨氮浓度呈正相关,但AOB-α多样性与氨氮浓度呈负相关;进水处AOA群落组成受氨氮浓度影响,而进、出水处AOB群落组成均受氨氮浓度影响.可见,进水氨氮浓度会影响河岸过滤对氨氮的削减效能,还会影响细菌、氨氧化微生物的丰度及群落结构,AOB对氨氮浓度的变化比AOA更敏感.     

Aerosol optical properties under different pollution levels in the Pearl River Delta (PRD) region of China

To clarify the aerosol hygroscopic growth and optical properties of the Pearl River Delta(PRD)region,integrated observations were conducted in Heshan City of Guangdong Province from October 19 to November 17,2014.The concentrations and chemical compositions of PM_(2.5),aerosol optical properties and meteorological parameters were measured.The mean value of PM_(2.5) increased from less than 35(excellent) to 35-75 μg/m~3(good) and then to greater than 75 μg/m~3(pollution),corresponding to mean PM_(2.5) values of 24.9,51.2,and 93.3 μg/m~3,respectively.The aerosol scattering hygroscopic growth factor(f(RH = 80%)) values were 2.0,2.12,and 2.18 for the excellent,good,and pollution levels,respectively.The atmospheric extinction coefficient(σext)and the absorption coefficient of aerosols(σ_(ap)) increased,and the single scattering albedo(SSA)decreased from the excellent to the pollution levels.For different air mass sources,under excellent and good levels,the land air mass from northern Heshan had lower f(RH) and σ_(sp) values.In addition,the mixed aerosol from the sea and coastal cities had lower f(RH) and showed that the local sources of coastal cities have higher scattering characteristics in pollution periods.     

Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

Metabolomic modulations in a freshwater microbial community exposed to the fungicide azoxystrobin

An effective broad-spectrum fungicide, azoxystrobin (AZ), has been widely detected in aquatic ecosystems, potentially affecting the growth of aquatic microorganisms. In the present study, the eukaryotic alga Monoraphidium sp. and the cyanobacterium Pseudanabaena sp. were exposed to AZ for 7 days. Our results showed that 0.2–0.5 mg/L concentrations of AZ slightly inhibited the growth of Monoraphidium sp. but stimulated Pseudanabaena sp. growth. Meanwhile, AZ treatment effectively increased the secretion of total organic carbon (TOC) in the culture media of the two species, and this phenomenon was also found in a freshwater microcosm experiment (containing the natural microbial community). We attempted to assess the effect of AZ on the function of aquatic microbial communities through metabolomic analysis and further explore the potential risks of this compound. The metabonomic profiles of the microcosm indicated that the most varied metabolites after AZ treatment were related to the citrate cycle (TCA), fatty acid biosynthesis and purine metabolism. We thereby inferred that the microbial community increased extracellular secretions by adjusting metabolic pathways, which might be a stress response to reduce AZ toxicity. Our results provide an important theoretical basis for further study of fungicide stress responses in aquatic microcosm microbial communities, as well as a good start for further explorations of AZ detoxification mechanisms, which will be valuable for the evaluation of AZ environmental risk.     

SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

介质粒径对复三维电极-生物膜脱硝反应器的影响

研究了无烟煤作填充介质时其粒径对复三维电极 生物膜反应器脱硝效果的影响 .选择了两种具有代表性的无烟煤粒径 :平均粒径D分别为 1 9mm和 4 0mm .研究了两种粒径介质的反应器出水中的NO-3 N、NO-2 N、pH变化 ,并对电流效率及处理负荷进行了对比 .结果表明在一定电流下 ,两反应器的NO-3 N去除率均能达到 98%;在同样操作条件下 ,D为 1 9mm反应器的脱硝能力优于D为 4 0mm反应器 ,前者比后者对水中NO-3 N的去除率高 10 %左右 .D为 1 9mm反应器的NO-3 N最高容积负荷、NO-3 N最高电极负荷、电流效率分别为 0 0 15kg (m3 ·h)、0 0 37mg (cm2 ·h)、36 0 %,均高于D为 4 0mm反应器约 10 %.以小粒径无烟煤为介质的反应器的生物量明显高于大粒径介质反应器 .     

环境物质拟除虫菊酯毒理学研究进展

拟除虫菊酯作为一种重要的合成杀虫剂,在人们的生产生活中有着广泛的应用,但同时其毒理学问题也越来越引起人们的注意,许多学者对此进行了深入的研究,在此研究基础上,从对动物的神经毒性、生殖毒性和生理生化毒性三个方面,对拟除虫菊酯的毒理学研究进展作一综述.     

电解制备聚合铝过程中Alb形态生成条件研究

考察了电解法制备聚合铝过程中AIb的最佳形成条件。AIb的形成与电流密度、极板间距、电解液的温度、铝的浓度以及电解时间等因素有关。在制备AI浓度为2．0mol/L的聚合氯化铝时，最佳的电流密度和极板间距分别为1．1A／dm^2和10mm。由于电化学过程中产生的不均匀的界面pH差值较大而生成较多的AI（OH）4^-作为AIb结构的结晶核心，因此能形成更多的AIb聚合形态。