Uptake and concentration of heavy metals in dominant mangrove species from Hainan Island,South China

Environmental Geochemistry and Health - By investigating three dominant mangrove species, namely Aegiceras corniculatum, Kandelia candel, Ceriops tagal and their rhizosediment in Mangrove wetlands...     

Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

警用头盔的人机工程学分析

警用头盔是武警部队使用最为频繁的单兵防护用具，本文基于人机工程学的理论，用人机工程学的观点对武警部队现装备的警用头盔进行分析和探讨，提出解决途径的设想，展望警用头盔的发展前景。     

序批式反应器生物强化处理苯酚废水的研究

将4株高效苯酚分解菌湿菌体分3批投加于序批式反应器(SBR),对活性污泥进行生物强化试验,分析活性污泥状态与性能变化,测定生物强化后对苯酚的降解能力.结果表明,随着生物强化过程的进行,沉降性能改善,污泥颗粒化趋势明显;生物强化后,活性污泥对苯酚降解能力、降解速率及对苯酚的耐受性明显提高:苯酚质量浓度为730～960mg/L时,苯酚完全降解时间可由正常的6h缩短至2h;6h内可完全降解苯酚的质量浓度由原来的880mg/L提高到2080mg/L,处理能力提高了1.36倍;当进水苯酚质量浓度增加到2400mg/L时,6h内污泥对苯酚的降解率仍达到60.1%.     

提高转炉OG效率的对策

对武钢第一炼钢厂100t转炉OG系统设备存在的问题进行了分析、研究，结合生产实际进行了一系列的技术改进和工艺参数调整，提高了OG系统效率。     

治污投资的政府最优政策博弈

外部性的存在及制造商治污投资动机不足要求政府对制造商的行为进行相应的规制，政府在制造商的治污投资行为中主要的作用是通过各种措施使得制造裔有动机地去自觉地进行有效的治污投资;政府的主要控制手段包括直接管制及借助市场激励，政府制定环境管理策略的关键因素是“惩罚的力度与激励的强度”。基于社会福利最大化的角度；从制造商的治污投资行为出发研究政府制定环境管理规制的策略，通过一个三阶段的博弈模型分析福利增进量、洽污成本与治污效果等三个因素对“惩罚力度与激励强度”的影响。     

区域水战略方案选优的动态组合评价模型研究

水安全危机是人类进入新世纪以来在生存及发展方面所面临的最严重挑战之一。研究科学合理的水安全战略成为区域可持续发展的重大课题。针对区域水战略问题涉及众多因素且各因素之间动态关联的特点，提出了基于水战略方案优选的兼容度极大化动态组合评价模型（CMM—DCEM），并将其成功地应用于我国广东省北江下游及其三角洲地区水安全战略方案优选评价。评价结果及模型基于不确定性的敏感性分析结果证明：CMM—DCEM实现了主、客观赋权方法以及单一评价模型的融合，使用实码加速遗传算法求解目标函数，克服了传统的组合评价方法计算繁琐的不足，评价过程更加科学合理。     

压力板仪法测土-水特征曲线试验研究

非饱和土土-水特征曲线(SWCC)表示了土中含水量与吸力之间的关系。针对非饱和土干-湿循环过程中的吸力变化特征,开展试验研究。采用体积压力板仪实现非饱和土的脱湿和吸湿过程。试验成果显示:(1)土-水特征曲线是不稳定的,它与土体含水率的变化路径有关;(2)在干湿循环过程中,相同的基质吸力具有不同的含水量。