排序方式: 共有39条查询结果,搜索用时 109 毫秒
1.
悬浮态TiO_2光催化降解苯系物的方法研究 总被引:6,自引:1,他引:6
以高压汞灯为光源 ,在TiO2 粉末悬浮体系内 ,系统地研究了光照时间、光照距离、催化剂用量、苯系物浓度和溶液pH、空气流量、H2 O2 浓度、Fe3+ 浓度等因素对模拟水样中苯系物的光催化降解效率的影响。研究结果表明 ,当光照时间为 2 0min、光照距离为 6cm ,TiO2 用量为 4 0 0mg L、pH =7、苯系物浓度为 10 0mg L ,空气流量为 4 0 0mL min,苯系物降解率可达 93% ,添加H2 O2 与Fe3+ 能增加苯系物的降解率 ,当H2 O2 浓度为 6mmol L ,Fe3+ 浓度为 0 2mmol L ,苯系物可完全降解。实验测定精密度RSD为 0 5 %。 相似文献
2.
3.
4.
5.
6.
The initial degradation mechanisms of OH and 4-chloro-2-methylphenoxyacetic acid (MCPA) including molecular form and anionic form are studied at the MPWB1K/6-311+G(3df, 2p)//MPWB1K/6-31+G(d, p) level. Possible reaction pathways of H-atom abstraction and OH addition are considered in detail. By result comparison analysis, it is found that the reaction mechanisms for OH and two forms of MCPA are different, and most reactions for anionic MCPA are easier than those for molecular MCPA. For H-atom abstraction reactions, the calculated energies show that OH abstracting H-atom from -CH3 group of molecular MCPA is the most kinetically favorable process; the potential energy surface for anionic MCPA indicates that H-atom in -CH2 group is slightly easier to be abstracted than that in -CH3 group. For OH addition reactions, the addition of OH to the C1 site is the initial step for molecular MCPA and the predominant product is 4-chloro-2-methylphenol (denoted P3), while the C4 site is the most reactive site for anionic MCPA and the primary product results from the hydroxylation of the aromatic ring, which is in good agreement with the experimental observation. In additional, results from PCM calculations show that most reactions in water phase are more kinetically favorable than those in gas phase, though the mechanisms discussed above will not be changed. 相似文献
7.
Xu Zhang Huanhuan Yang Xinlei Wang Wen Song Zhaojie Cui 《Frontiers of Environmental Science & Engineering》2018,12(4):6
In this research, supercritical carbon dioxide extraction (SFE) showed better extraction effect when compared with Solid- liquid extraction (SLE), Soxhlet extraction (SE) and Ultrasonic extraction (UE), not only in the rate but also the time. The comparison among these three extraction modifiers, including acetone, ethanol and methanol demonstrated that ethanol was preferred to SFE due to its high extraction effect and low toxicology. In addition, parameter of SFE, influence of temperature and pressure were investigated, and the best extraction effect was achieved at the optima conditions, temperature of 40°C and the pressure of 35 MPa. Thus, SFE is a highly effective method for flavonols extraction, requiring minimum energy and producing non-toxic byproduct. SFE-GC system is applied for the evaluation on flavonols that plays a key role in plant resistance to heavy metal, with its content and synthetase gene expression significantly increasing in plant when threatened by heavy metal. Besides, results indicated that flavonols can improve plant resistance to oxidative stress by quenching the redundant ROS in matrix.
相似文献
8.
9.
以活性污泥脱氢酶的活性作为毒性指标,研究了半导体材料GaAs、Ga~(3+)、Ge~(4+)对活性污泥活性的抑制影响,并用Hg~(2+)作为参比材料;同时对抑制动力学也作了初步研究。实验表明,GaAs、Ga~(3+)、Ge~(4+)及Hg~(2+)的10%抑制浓度分别为45.00,371.63,0.13ppm/gMLSS,GaAs、Ga~(3+)、Ge~(4+)和Hg~(2+)在浓度分别为180,700,250和1.25ppm/g MLSS时的抑制常数分别为1.30×10~(-3),7.05×10~(-3),6.12×10~(-3)和5.49×10~(-3)mmol,且其抑制类型均属可逆非竞争性抑制。 相似文献
10.
废润滑油絮凝脱色试验研究 总被引:7,自引:0,他引:7
废润滑油的回收再生利用不仅可以节约石油资源,而且是防治废润滑油污染、保护环境的主要措施.针对有污染的传统酸-白土废润滑油再生工艺,提出了以絮凝为主的无污染再生新技术,重点考察了影响废润滑油脱色再生效率的各种因素.结果表明,在絮凝剂用量为1.2%(体积分数)、搅拌时间为5 min、反应温度为75℃、沉降温度为80℃、沉降时间为2.0 h的条件下,废润滑油絮凝脱色效果最佳.废润滑油经过絮凝脱色和白土精制后理化指标得到了较大改善,基本接近该级别新油SC40的标准. 相似文献